Data on alveolar mandibular bone thickness in Class I skeletal patient with bimaxillary protrusion

Comparative study of biomodels manufactured using 3D printing techniques for surgical planning and medical training

OBJECTIVES

To obtain 3D printed bone models with a haptic sensation similar to that of the real bone, which will help the surgeon to learn and improve based on practice.

METHODS

From computed tomography, 3 digital anatomical models of the human proximal femur were created and, by modifying the printing parameters, both cortical and trabecular tissues were simulated, which were combined in a different cortico-cancellous interface depending on the bone segment. The 3 equivalent models obtained were compared with a commercial Sawbone synthetic model and subjected to a series of blind surgical practice trials performed by 5 TOC specialists from a hospital, each of them with different degrees of expertise. A statistical analysis of the qualitative data collected based on the Wilcoxon test, the Spearman correlation matrix, and the Validity Ratio Coefficient was performed.

RESULTS

The deviations observed in the dimensional study are less than 0.2 millimeter, which confirms the validity of the 3DP-FFF technology to geometrically recreate personalized biomodels with high anatomical precision.

CONCLUSIONS

The reproductions obtained have given rise to a reliable method that professionals can refine to plan operations with the consequent reduction of time and risks for the patient, as well as for medical training.

Correlation of alveolar bone thickness and central incisor inclination in skeletal Class I and II malocclusions with different vertical skeletal patterns: A CBCT study

INTRODUCTION

This study aimed to assess the alveolar bone thickness (ABT) and labiolingual inclination of maxillary and mandibular central incisors in patients with Class I and II skeletal patterns with normal-angle, high-angle, and low-angle vertical patterns.

METHODS

The study sample consisted of 200 cone-beam computed tomography scans of patients with skeletal Class I and II malocclusions. Each group was further divided into low-angle, normal-angle, and high-angle subgroups. Labiolingual inclinations of maxillary and mandibular central incisors and ABT were measured at 4 levels from the cementoenamel junction in the labial and lingual surfaces. The Kolmogorov-Smirnov test, independent t test, 2-way analysis of variance, and Spearman's correlation test were applied for statistical analyses.

RESULTS

The only significant difference between Class I and II groups regarding the ABT was found at the labial side of the maxillary central incisor, 9 mm apical to the crest. At this level, the mean ABT was 0.87 mm in patients with a skeletal Class I malocclusion, which was significantly greater than that in patients with a skeletal Class II malocclusion with a mean ABT of 0.66 mm (P = 0.02). Comparisons among the vertical subgroups revealed that on the labial and lingual sides of the mandible, as well as the palatal side of the maxilla, significantly thinner alveolar bone was found in patients with high-angle growth patterns than those with normal-angle and low-angle patterns in both sagittal groups (P <0.05). Significant weak to moderate correlations were found between ABT and tooth inclination (P <0.05).

CONCLUSIONS

Significant differences in ABT covering central incisors between patients with skeletal Class I and II malocclusion are merely observed at the labial surface of the maxilla, 9 mm apical to the cementoenamel junction. Compared with patients with normal-angle and low-angle, those with a high-angle growth pattern and Class I and II sagittal relationships have thinner alveolar bone support around maxillary and mandibular incisors.