Transphyseal Anterior Cruciate Ligament Reconstruction Using Hybrid Transtibial Femoral Drilling and a Quadriceps Tendon Autograft

A Novel Predictor of the Length and Size of ACL Grafts in Chinese Han Adults for ACL Reconstruction: An MRI Study

OBJECTIVE

Currently, there is no simple and valid method to predict the length and size of the native anterior cruciate ligament (ACL) in each adult patient who will undergo ACL reconstruction. This study aimed to develop an imaging prediction method that can predict the length and size of ACL grafts using the intact posterior cruciate ligament (PCL), in order to enhance the graft preparation individualized sizing.

METHODS

Three hundred and nineteen patients aged 18 years or older who underwent magnetic resonance imaging (MRI) of the knee at an orthopaedic clinic between September 9, 2021, and February 5, 2023, were included. The length, sagittal diameter, and coronal diameter of the ACL and PCL were measured in all patients, and F-test were performed to explore linear relationship between ligament measurements.

RESULTS

Equations were established to predict a variable of the native ACL for the corresponding variable of the intact PCL (i.e., sagittal diameter of the ACL = 4.32 + 1.08 × sagittal diameter of the PCL, and coronal diameter of the ACL = 2.45 + 0.59 × coronal diameter of the PCL, length of the male ACL = 10.92 + 0.64 × length of the male PCL, length of the female ACL = 11.76 + 0.58 × length of the female PCL) (R2  = 0.532; R2  = 0.417; R2  = 0.488; R2  = 0.509; respectively).

CONCLUSIONS

The length and size of the intact PCL in cases without PCL buckling are predictors of the length and size of the native ACL in adults, respectively. The use of this information to optimize graft diameter may lower the rates of ACL graft failure in the future.

Speed whip ripstop technique during anterior cruciate ligament reconstruction using quadriceps tendon results in higher fixation strength

PURPOSE

To compare the biomechanical strength of different fixation configurations using a suspensory button in a soft-tissue quadriceps tendon graft for Anterior Cruciate Ligament (ACL) reconstruction.

METHODS

Thirty fresh-frozen bovine Achilles tendons (10 mm wide, 50 mm long, and 4 mm thick) were used in this study. Tendons were assigned to three groups (n = 10 per group) with different suture configurations using adjustable loops with a suspensory button: group A, with the threads of an adjustable loop fixed by crossing at the tip of the loop and the entire loop; group B, continuous loops with hanging buttons were directly sutured to the tendon with eight simple sutures; group C, fixation was performed using the speed whip ripstop technique. Tensile tests with five cycles of preloading were performed at 50 N, held at 50 N for 1 min, and load-to-failure testing was conducted until rupture at 5 mm/min. The difference in the elongation and the maximum load-to-failure force were measured.

RESULTS

The average elongation was significantly larger in group B (16.6 ± 2.2 mm) than in groups A (10.3 ± 2.4 mm) and C (10.0 ± 1.0 mm), (p < 0.001). The average load-to-failure force varied significantly between the three groups, 157.5 ± 33.4 N in group A, 253.4 ± 45.5 N in group B, and 337.7 ± 21.0 N in group C, (p < 0.001).

CONCLUSION

Fixation using the speed whip ripstop technique to fix the suspensory button and soft-tissue transplant tendon resulted in minimal elongation and higher fixation strength. Simple devices that use this method have already been developed. Since it can be fixed using a relatively simple method, speed whip ripstop technique was shown to be advantageous for femoral fixation in ACL reconstruction using soft-tissue quadriceps tendon. The findings of this study could help surgeons reduce graft re-tear rates in ACL reconstruction using quadriceps tendons.

LEVEL OF EVIDENCE

N/A, laboratory control study.

Direct suturing quadriceps tendon to a continuous loop with a suspensory button provides biomechanically superior fixation in ACL reconstruction

PURPOSE

To compare the biomechanical strength of different fixation configurations using suspensory buttons in a soft-tissue quadriceps tendon (QT) grafts in anterior cruciate ligament (ACL) reconstruction.

METHODS

Forty bovine QTs, 6-cm long and 10-mm wide, were allocated into four groups with different suture configurations using suspensory buttons (n = 10 in each group): Group A, a baseball suture with a knot tied to the continuous loop with a suspensory button; Group B, same configuration as in Group A but with the knot tied at the opposite end of the baseball suture; Group C, a continuous loop with a suspensory button stitched directly to the QT with simple sutures, and Group D, a baseball suture tied directly to a suspensory button. Biomechanical testing was performed by preloading followed by cyclic loading for 500 cycles between 10 and 100 N. The length of elongation (mm) and maximum load to failure (N) were recorded, and compared among the four groups.

RESULTS

Group C showed significantly smaller elongation (4.1 mm [95% CI 3.1-5.2]) than Group A (8.2 mm [95% CI 7.0-9.4]), Group B (10.5 mm [95% CI 7.7-13.3]), and Group D (8.5 mm [95% CI 7.0-9.9]) (A-C; P = 0.004, B-C; P = 0.0001, C-D; P = 0.0018). The maximum load to failure in Group C (386 N [95%CI 306-466]) was significantly higher than that in Group A (196 N [95% CI 141-251]), Group B (226 N [95% CI 164-289]), and Group D (212 N [95%CI 171-253]) (A-C; P = 0.0001, B-C; P = 0.0009, C-D; P = 0.0002). No significant differences were observed between Group A, B, and D in terms of elongation and maximum load to failure.

CONCLUSION

The soft-tissue QT graft fixation configuration stitched directly to a continuous loop with suspensory button using simple sutures exhibits small elongation and high maximum load to failure among the four configurations. Regarding clinical relevance, direct suturing of the soft-tissue QT to a continuous loop with a suspensory button may be advantageous for femoral fixation in ACL reconstruction from a biomechanical perspective, and warrant future development of a novel fixation device using this principle.

Quadricep ACL Reconstruction Techniques and Outcomes: an Updated Scoping Review of the Quadricep Tendon

PURPOSE OF REVIEW

The purpose of this review is to provide an up-to-date summary on the most recent literature examining techniques and outcomes in anterior cruciate ligament (ACL) reconstruction using quadriceps tendon (QT) which will enable surgeons to make well informed evidence-based decisions when choosing a particular graft option and technique in ACL reconstruction.

RECENT FINDINGS

Several RCTs and systematic reviews have been published recently on this topic, and overall, there were no differences found between the QT, HT, and BPTB groups in patient-reported outcomes, stability testing, or graft re-rupture rates. In terms of strength testing, the QT group did have inferior knee extensor strength on isokinetic testing when compared to the HT group, whereas the HT group had inferior knee flexor strength compared to the QT group. No differences were found on strength testing between the QT and BPTB groups. Currently, two large RCTs, the Stability2 and SQuASH trials, are ongoing examining the effectiveness of the QT vs BPTB with or without LET and QT vs HT in the pediatric population which will help shed further light on the effectiveness of the QT as a graft choice in ACL reconstruction. The findings of this scoping review demonstrate that the QT is an excellent graft option in ACL reconstruction both in the primary and revision settings, among adult and pediatric populations. This review provides surgeons with further assurance when selecting QT autograft in ACL reconstruction.