Novel fluorene-based supramolecular sensor for selective detection of amoxicillin in water and blood

Compounds Derived from 9,9-Dialkylfluorenes: Syntheses, Crystal Structures and Initial Binding Studies (Part II)

New representatives of 2,4,7-trisubstituted 9,9-dialkyl-9H-fluorenes were prepared and used for crystallographic investigations as well as initial binding studies towards metal ions and carbohydrates. The binding studies, which included ¹ H NMR spectroscopic titrations and fluorescence measurements, demonstrated the ability of the tested fluorene-based compounds to act as complexing agents for ionic and neutral substrates. Depending on the nature of the subunits of the fluorene derivatives, "turn on" or "turn off" fluorescent chemosensors can be developed. Compounds composed of 4,6-dimethylpyridin-2-yl-aminomethyl moieties have the potential to be used as sensitive "turn-on" chemosensors for some metal ions.

Synthesis of Imino Stabilized Iron Oxide Nanosensor for Selective Detection of Lead Ions

The present work describes the successful preparation of iron oxide nanoparticles (NSB1) stabilized with 4-((2-hydroxybenzylidene)amino)benzoic acid. The characterization has been achieved through ultraviolet visible (UV-Vis), fourier transform infra-red (FTIR) spectroscopy and scanning electron microscopy (SEM) with electron dispersive X-ray elemental analysis (EDX). These magnetic nanoparticles have exhibited significant chemosensing properties in the aqueous media to screen Cr3+, Cd2+, Li+, Co2+, Al3+, Pb2+, Ni2+ and Sr2+ ions. However, lead (Pb2+) ions have shown the highest selectivity as compared to other metal ions without any interference in the competitive ion study. The detection limit of Pb2+ ions was found to be 1.7 µM by this nanosensor. The binding ratio and stoichiometry was found to be 1:1 as measured by Job’s plot. The binding strength was also computed through Benesei-Hildebrand equation.

Total removal of amoxicillin from water using magnetic core nanoparticles functionalized with silver

Framed in the problem of emerging pollutants, in this work we introduce a novel procedure for the total removal of amoxicillin from water samples using magnetic nanoparticles functionalized with nanometric silver (Fe₃O₄@AgNPs). Experimental conditions such as pH, contact time, temperature, as well as adsorbate and adsorbent doses have been studied to achieve the total adsorption for different concentrations of amoxicillin in water. Particularly, for concentrations 10 and 100 mg L^-1, a maximum removal efficiency of 100% was reached at room temperature and pH = 7 after 15 min of contact time between adsorbent and water samples under gentle shaking. The doses of adsorbent employed to remove 10 and 100 mg L^-1 of amoxicillin were 100 and 500 μL, respectively. Characterization of the adsorbent surfaces was performed by Scanning and Transmission Electron Microscopy, Energy Dispersive X-ray Spectroscopy, BET analysis and Fourier-transform infrared spectroscopy. Recycling studies were carried out employing 500 μL of NaOH solution 1 M during 15 min in order to explore desorption and reuse of the adsorbent, showing that Fe₃O₄@AgNPs remains unaltered and can be used for two more additionally adsorption cycles, exhibiting 93% adsorption efficiency after the third regeneration. The characterization of equilibrium isotherms and thermodynamics reveal a Langmuir-type endothermic chemisorption.

High-sensitive detection of fluorene by ambient ionization mass spectrometry

High sensitive analysis for fluorene at the sub-ng L⁻¹ level in real water samples was achieved by nebulization-dielectric barrier discharge ionization.

Sensing of diclofenac by a porphyrin-based artificial receptor

The synthesis of a porphyrin chemosensor is here reported as well as its sensing activity in detecting the emerging pollutant diclofenac with an overall 1 : 1 binding constant of about 10⁵ M⁻¹.