Particle properties and drug metastable solubility of simvastatin containing PVP matrix particles prepared by electrospraying technique

Pharmaceutical Nanoparticles Formation and Their Physico-Chemical and Biomedical Properties

The use of medicinal substances in nanosized forms (nanoforms, nanoparticles) allows the therapeutic effectiveness of pharmaceutical preparations to be increased due to several factors: (1) the high specific surface area of nanomaterials, and (2) the high concentration of surface-active centers interacting with biological objects. In the case of drug nanoforms, even low concentrations of a bioactive substance can have a significant therapeutic effect on living organisms. These effects allow pharmacists to use lower doses of active components, consequently lowering the toxic side effects of pharmaceutical nanoform preparations. It is known that many drug substances that are currently in development are poorly soluble in water, so they have insufficient bioavailability. Converting them into nanoforms will increase their rate of dissolution, and the increased saturation solubility of drug nanocrystals also makes a significant contribution to their high therapeutic efficiency. Some physical and chemical methods can contribute to the formation of both pure drug nanoparticles and their ligand or of polymer-covered nanoforms, which are characterized by higher stability. This review describes the most commonly used methods for the preparation of nanoforms (nanoparticles) of different medicinal substances, paying close attention to modern supercritical and cryogenic technologies and the advantages and disadvantages of the described methods and techniques; moreover, the improvements in the physico-chemical and biomedical properties of the obtained medicinal nanoforms are also discussed.

Development of Simvastatin-Loaded Particles Using Spray Drying Method for Ex Tempore Preparation of Cartridges for 2D Printing Technology

In this work, a spray drying method was developed to produce drug/polymer (simvastatin/polycaprolactone) microparticles that have the potential to be used as a pre-formulation for ex tempore preparation of 2D printing cartridges. An experimental model was designed with the process parameters set to predict the smallest particle size required for successful 2D printing. Three different types of particles (lactose, nanocellulose/lactose, calcium silicate) were produced, and the average size of the dry particles varied depending on the sampling location (cyclone, collection vessel). The encapsulation efficiency of simvastatin was highest with nanocellulose/lactose from the collection vessel. The one-month stability of simvastatin in the particles showed low content, but the addition of ascorbic acid as an antioxidant increased the chemical stability of the drug. Interestingly, the addition of antioxidants decreased the stability of simvastatin in the calcium silicate particles from the collection vessel. Dispersion of the particles in three different propylene glycol and water mixtures (10/90, 50/50, and 90/10% (v/v)), representing a printable ink medium with three different viscosity and surface tension properties, showed that nanocellulose/lactose was the most suitable antiadhesive in terms of dispersed particle size (˂1 µm). After one month of storage, the dispersed particles remained in the same size range without undesirable particle agglomeration.

Development of Nanofibers with Embedded Liposomes Containing an Immunomodulatory Drug Using Green Electrospinning

Conventional treatments for chronic wounds are often ineffective, thus new therapeutic approaches are needed, such as the delivery of immunomodulatory drugs that can reduce inflammation, restore immune cell function, and facilitate tissue regeneration. A potential drug for such an approach is simvastatin, which has major drawbacks including poor solubility and chemical instability. With the aim of developing a dressing for wound healing, simvastatin and an antioxidant were incorporated into alginate/poly(ethylene oxide) nanofibers by green electrospinning without the use of organic solvents, thanks to their prior encapsulation into liposomes. The composite liposome-nanofiber formulations exhibited fibrillar morphology (160-312 nm) and unprecedentedly high phospholipid and drug content (76%). Transmission electron microscopy revealed dried liposomes as bright ellipsoidal spots homogeneously distributed over the nanofibers. After nanofiber hydration, the liposomes reconstituted in two size populations (~140 and ~435 nm), as revealed by cutting-edge MADLS^® analysis. Lastly, in vitro assays demonstrated that composite liposome-nanofiber formulations are superior to liposomal formulations due to a better safety profile in keratinocytes and peripheral blood mononuclear cells. Furthermore, both formulations exhibited similarly advantageous immunomodulatory effects, measured as decreased inflammation in vitro. A synergistic combination of the two nanodelivery systems shows promise for the development of efficient dressings for chronic wound treatment.

Enhancement of oral bioavailability and anti-colitis effect of luteolin-loaded polymer micelles with RA (rosmarinic acid)-SS-mPEG as carrier

OBJECTIVE

Polymer micelles were prepared (L-RSPMs) with luteolin and synthetic RA-SS-mPEG polymeric material before evaluation of their anti-inflammatory effect on 2, 4, 6-trinitro-benzene-sulfonic acid (TNBS)-induced ulcerative colitis (UC) model in rats.

METHODS

The synthetic RA-SS-mPEG was characterized with NMR spectroscopy, before preparation of luteolin-coated RA-SS-mPEG polymer micelles. The in vitro characterization and evaluation of the formulation were accomplished, couple with its pharmacokinetic parameters. The levels of PEG2, MDA, CRP and GSH, as well as concentrations of TNF-α, IL1-β, IL-6 and IL-10 in serum and colon tissue were detected via ELISA kit. The degree of colon injury and inflammation was evaluated via histopathologic examination.

RESULTS

L-RSPMs displayed small average droplet size (133.40 ± 4.52 nm), uniformly dispersed (PDI: 0.163 ± 0.011), good stability, slow release and enhanced solubility. We observed 353.28% increase in the relative bioavailability of L-RSPMs compared to free luteolin, while the half-life of the micelle was extended by 6.16h. Compared to model (M) group, luteolin (low and high doses) and L-RSPMs (low and high doses) significantly reduced levels of MDA, PEG2, CRP, TNF-α, IL-6 and IL-1β in colon tissue and serum of colitic rats but dose dependently increased IL-10 and SOD levels (p < 0.01). Histopathologic examination of colon showed that luteolin (low and high doses) and L-RSPMs (low and high doses) improved colonic inflammation in colitic rats to varying degrees compared to M group.

CONCLUSION

L-RSPMs could improve TNBS-induced colon inflammation by enhancing bioavailability, promoting antioxidant effects and regulating cytokine release, which may become a potential agent for UC treatment in clinical settings.

Co-amorphous systems using epigallocatechin-3-gallate as a co-former: stability, in vitro dissolution, in vivo bioavailability and underlying molecular mechanisms

Co-amorphous strategy has been extensively investigated to improve the dissolution of hydrophobic drugs. Here, epigallocatechin-3-gallate (EGCG) was exploited as a co-former in co-amorphous systems based on its unique structure including phenyl rings, phenolic hydroxyl groups and the galloyl moiety. Two model BCS class II drugs, simvastatin (SIM) and nifedipine (NIF), were selected to be co-amorphized with EGCG. All drug-EGCG systems at three molar ratios became amorphous by the means of spray drying and showed high physically stable either under dry condition and 75% RH at 40 °C or under dry conditions at 25 °C. The optimal feed molar ratios of both EGCG based co-amorphous systems fabricated were determined to be three, under which the significant increases were obtained in the maximum apparent concentrations of 4.90-fold for SIM at 1 h and 106.03-fold for NIF at 0.25 h compared to crystalline drugs by non-sink dissolution studies. The underlying molecular mechanisms of two co-amorphous systems formation were involved in molecular miscibility, hydrogen bonds and π-π stacking interactions unraveled by means of DSC, FTIR and molecular dynamics simulations. More to the point, oral pharmacokinetic studies in rats demonstrated that co-amorphous SIM-EGCG and NIF-EGCG systems at 1:3 have a significant increase in C_max of 1.81- and 5.69-fold, and AUC _{0-24 h} of 1.62- and 4.57-fold compared with those of corresponding crystalline drugs, respectively. In conclusion, EGCG is proved to be a promising co-former in co-amorphous systems.

Hyaluronic Acid-Functionalized Mesoporous Silica Nanoparticles Loading Simvastatin for Targeted Therapy of Atherosclerosis

Atherosclerosis (AS) constitutes a major threat to human health, yet most current therapeutics are hindered in achieving desirable clinical outcomes by low bioavailability or serious side effects. Herein, we constructed an enzyme-responsive and macrophage-targeting drug delivery system (SIM@HA-MSN) which can potentially modulate the microenvironment of the atherosclerotic plaques characterized by excessive inflammation and overexpression of hyaluronidase (HAase) for precise AS treatment. More specifically, mesoporous silica nanoparticles (MSNs) were loaded with a lipid-lowering drug simvastatin (SIM) and further gated with hyaluronic acid (HA) coating, which endowed the nanosystem with HAase responsiveness and targetability to inflammatory macrophages. Our results showed that a high loading efficiency (>20%) and excellent enzyme-responsive release of SIM were simultaneously achieved for the first time by silica-based nanocarriers through formulation optimizations. Moreover, in vitro experiments confirmed that SIM@HA-MSN possessed robust targeting, anti-inflammatory, and anti-foaming effects, along with low cytotoxicity and excellent hemocompatibility. In addition, preliminary animal experiments demonstrated the as-established nanosystem had a long plasma-retention time and good biocompatibility in vivo. Taken together, SIM@HA-MSN with HA playing triple roles including gatekeeping, lesion-targeting, and long-circulating holds great potential for the management of atherosclerosis.