In vitro assessment of maximum insertion and removal torque with three different miniscrews on artificial maxilla and mandible

Evaluation of mechanical properties and morphology of miniscrews Ti6Al4V cold worked versus annealed in artificial bones

PURPOSE

This study aimed to evaluate the influence of different manufacturing procedures (Eli annealed - hot work versus cold worked - cold work) of the raw material under mechanical properties and morphological characteristics of orthodontic miniscrews (MS).

MATERIAL AND METHODS

Thirty MS were randomly separated into 3 types (n=10) according to manufacturer and manufacturing process of the raw material: type A - SIN® annealed (control group); type B - Dentfix® annealed; and, type C - Dentfix® cold worked. MI were inserted in artificial bone blocks, through the manufacturer's specific manual key attached to the digital torquemeter stabilized via custom device. Data of fracture's occurrence was performed using Fisher's exact test. Comparisons between the other two types regarding insertion torque and removal torque were performed using the Mann-Whitney test. Data of fracture torque, shear stress, normal stress and torque ratio was submitted to Kruskal Wallis and Dunn tests (α=0.05). Representative images of surface morphology and fractures were selected.

RESULTS

Type C showed statistically the lowest fracture torque (N.cm) (26.11±0.41) (P=0.0012) and highest torque ratio (%) (98.74±0.85) (P=0.0007). Type C showed statistically higher calculated shear (MPa) (2,432.73±508.41) and normal stress (MPa) (1,403.86±293.39) than type B and type A, showing that they differed in relation to the mechanical strength of the material with which they were made (P=0.0007).

CONCLUSION

Type A fractured completely inside the most apical bone. Type B and type C fractured closer to the transmucosal profile. Cold worked process should be more prone to fractures than those annealed raw manufactured.

Effects of Implanting Torques on Implant Osseointegration in an Animal Model

Objective: To investigate the effect of insertion torque on implant osseointegration in an animal model. Methods: First, the first to fourth premolars of nine healthy adult beagles’ mandibular were extracted to form an edentulous area, and then the beagles were equally divided into three groups with different torques (low torque: 10–30 Ncm; medium torque: 30–50 Ncm; high torque: > 70 Ncm). Three implants were placed on each side of the edentulous area of the beagles (54 total), and the dogs were observed for 8 weeks. Implant performance and removal torque values (RTV) were determined at 1, 4, and 8 weeks after surgery. In addition, the expression ratios of OPG and RANKL mRNAs in the surrounding bone tissue were determined. Results: None of the 54 implants showed loosening or loss, and no significant bone resorption was observed. The removing torques and the expression ratios of OPG and RANKL mRNAs showed differences at 1 and 4 weeks after surgery, while they converged at 8 weeks after the surgery (p > 0.05). Conclusion: The osteointegration process lasted approximately 8 weeks depending on the difference in parameters, and all parameters showed the same values even though the insertion torques at the beginning were different.