Bioelectrocatalytic endpoint assays based on steady-state diffusion current at microelectrode array

Disposable electrochemical glucose sensor based on water-soluble quinone-based mediators with flavin adenine dinucleotide-dependent glucose dehydrogenase

Glucose level measurement is essential for the point-of-care diagnosis, primarily for persons with diabetes. A disposable electrochemical glucose sensor is constructed using flavin adenine dinucleotide-dependent glucose dehydrogenase (FAD-GDH) and redox mediator for electron transfer from the enzyme to the electrode surface. Ideally, a suitable mediator should have high water solubility, high kinetic constant, high stability, and redox potential between -0.2 and 0.1 V vs. Ag|AgCl|sat. KCl. We designed and synthesized two new quinone-based water-soluble mediators: quinoline-5,8-dione (QD) and isoquinoline-5,8-dione (IQD). The formal potentials for both QD and IQD at pH 7.0 were -0.07 V vs. Ag|AgCl|sat. KCl. The logarithms of the electron exchange rate constants (k₂/(M^-1 s^-1)) between QD/IQD and FAD-GDH were 7.7 ± 0.1 and 7.4 ± 0.1 for QD and IQD, respectively, which are the highest value among the water-soluble mediators for FAD-GDH reported to date. Disposable amperometric glucose sensors were fabricated by dropping FAD-GDH and QD or IQD onto a test strip. The sensor achieved a linear response up to glucose concentrations of 55.5 mM. The linear response was obtained even when the mediator loading was low (0.5 nmol/strip); loading was only 0.2 mol% of glucose. The results proved that the response current was primarily controlled by glucose diffusion. In addition, the sensor using QD exhibited high stability over 3 months at room temperature.

Development Perspective of Bioelectrocatalysis-Based Biosensors

Bioelectrocatalysis provides the intrinsic catalytic functions of redox enzymes to nonspecific electrode reactions and is the most important and basic concept for electrochemical biosensors. This review starts by describing fundamental characteristics of bioelectrocatalytic reactions in mediated and direct electron transfer types from a theoretical viewpoint and summarizes amperometric biosensors based on multi-enzymatic cascades and for multianalyte detection. The review also introduces prospective aspects of two new concepts of biosensors: mass-transfer-controlled (pseudo)steady-state amperometry at microelectrodes with enhanced enzymatic activity without calibration curves and potentiometric coulometry at enzyme/mediator-immobilized biosensors for absolute determination.

Fabrication and Characterization of Ultrathin-ring Electrodes for Pseudo-steady-state Amperometric Detection

The fabrication of ultrathin-ring electrodes with a diameter of 2 mm and a thickness of 100 nm is established. The ultrathin-ring electrodes provide a large density of pseudo-steady-state currents, and realize pseudo-steady-state amperometry under quiescent conditions without a Faraday cage. Under the limiting current conditions, the current response at the ultrathin-ring electrode can be well explained by the theory of the microband electrode response. Cyclic voltammograms at the ultrathin-ring electrode show sigmoidal characteristics with some hysteresis. Numerical simulation reveals that the hysteresis can be ascribed to the time-dependence of pseudo-steady-state current. The performance of amperometry with the ultrathin-ring electrode has been verified in its application to redox enzyme kinetic measurements.

Characteristics of fast mediated bioelectrocatalytic reaction near microelectrodes

The pseudo-steady-state current due to a mediated enzymatic reaction on a microelectrode is characterized on the basis of theoretical analysis and numerical simulation. The steady-state current is proportional to substrate concentration when the enzymatic reaction is considerably faster than substrate mass transport via nonlinear diffusion. Under such conditions, the reaction plane, where the mass flow of the substrate is converted to that of the mediator, exists near the electrode surface. The steady-state current increases as the diffusion coefficient of the substrate increases. In contrast, the diffusion coefficient and the concentration of the mediator have minor effects on the current. This difference can be explained on the basis of a change in the reaction plane location. When a sufficient amount of enzyme exists in a system, the system can be used as an amperometric biosensor, the response of which is independent of any change in enzyme activity.

Diffusion-controlled detection of glucose with microelectrodes in mediated bioelectrocatalytic oxidation

This paper describes a diffusion-controlled electrolysis of glucose with mediated bioelectrocatalysis at microdisk-electrodes. Under conditions of an extremely fast enzyme reaction, compared with the diffusion of glucose, the current in potential-step chronoamperometry reaches an almost steady state within 10 s, and is proportional to the glucose concentration. The current can be detected at +0.1 V (vs. Ag|AgCl) with 9,10-phenanthrenequinone as a mediator. The addition of carboxymethylcellulose increased the linear range up to 10 mM.