Potentiostatic infrared titration of 11-mercaptoundecanoic acid monolayers

An ultra-sensitive SPR immunosensor for quantitative determination of human cartilage oligomeric matrix protein biomarker

This paper reports the development of a novel surface plasmon resonance (SPR) immunosensor for ultra-sensitive quantitative determination of human articular cartilage oligomeric matrix protein (COMP), a major component of the extracellular matrix and an exploratory biomarker. Capture antibodies against human COMP (anti-COMP_16F12) were covalently immobilized on an 11-mercaptoundecanoic acid (11-MUA) self-assembled monolayer (SAM)-coated SPR sensor disk and a dual sandwich-type signal amplification strategy using biotinylated detection antibodies against COMP (anti-COMP_17C10-biot) and streptavidin-conjugated quantum dots (SAv‒QDs) were used for the development of an immunosensor. The binding of high-mass SAv‒QDs via biotin-streptavidin interaction to the surface of the immunosensor resulted in a drastic increase in the sensitivity. The developed immunosensor was able to detect concentrations of COMP in a range from 2.80 to 680.54 fM with a limit of detection (LOD) and a limit of quantification (LOQ) of 0.15 and 0.50 fM, respectively. The immunosensor exhibited good repeatability (relative standard deviation (RSD) 8.05%) and reproducibility (RSD 9.88%) as well as excellent operational stability (2.14 % decrease in SPR signal after 13 days). In addition, the analysis of secretomes of human knee articular cartilage explants from patients with osteoarthritis revealed that the immunosensor has good accuracy (analytical error less than 5 %). These results indicate that the immunosensor developed may be suitable for quantitative determination of COMP derived from articular cartilage and other synovial joint tissues in clinical studies.

Surface Plasmon Resonance Immunosensor with Antibody-Functionalized Magnetoplasmonic Nanoparticles for Ultrasensitive Quantification of the CD5 Biomarker

A surface plasmon resonance (SPR) immunosensor signal amplification strategy based on antibody-functionalized gold-coated magnetic nanoparticles (mAuNPs) was developed for ultrasensitive and quantitative detection of the CD5 biomarker using an indirect sandwich immunoassay format. The gold surface of the SPR sensor disk and mAuNPs was modified with a self-assembled monolayer of 11-mercaptoundecanoic acid (11-MUA), and the coupling method using N-(3-(dimethylamino)propyl)-N'-ethylcarbodiimide hydrochloride and N-hydroxysuccinimide was used to immobilize capture antibodies against human CD5 (anti-CD5_2A) and detection antibodies against human CD5 (anti-CD5_2B), respectively. The mAuNPs and anti-CD5_2B conjugates (mAuNPs-anti-CD5_2B) were separated by an external magnetic field and used to amplify the SPR signal after the formation of the anti-CD5_2A/CD5 immune complex on the SPR sensor disk. Compared to the direct CD5 detection with a limit of detection (LOD) of 1.04 nM and a limit of quantification (LOQ) of 3.47 nM, the proposed sandwich immunoassay utilizing mAuNPs-anti-CD5_2B significantly improved the LOD up to 8.31 fM and the LOQ up to 27.70 fM. In addition, it showed satisfactory performance in human blood serum (recovery of 1.04 pM CD5 was 109.62%). These results suggest that the proposed signal amplification strategy has superior properties and offers the potential to significantly increase the sensitivity of the analysis.

Interfacial Acid-Base Equilibria and Electric Fields Concurrently Probed by In Situ Surface-Enhanced Infrared Spectroscopy

Understanding how applied potentials and electrolyte solution conditions affect interfacial proton (charge) transfers at electrode surfaces is critical for electrochemical technologies. Herein, we examine mixed self-assembled monolayers (SAMs) of 4-mercaptobenzoic acid (4-MBA) and 4-mercaptobenzonitrile (4-MBN) on gold using in situ surface-enhanced infrared absorption spectroscopy (SEIRAS). Measurements as a function of the applied potential, the electrolyte pD, and the electrolyte concentration determined both the relative surface populations of acidic and basic forms of 4-MBA, as well as the local electric fields at the SAM-solution interface by following the Stark shifts of 4-MBN. The effective acidity of the SAM varied with the applied potential, requiring a 600 mV change to move the pK_a by one unit. Since this is ca. 10× the Nernstian value of 59 mV/pK_a, ∼90% of the applied potential dropped across the SAM layer. This emphasizes the importance of distinguishing applied potentials from the potential experienced at the interface. We use the measured interfacial electric fields to estimate the experienced potential at the SAM edge. The SAM pK_a showed a roughly Nernstian dependence on this estimated experienced potential. An analysis of the combined acid-base equilibria and Stark shifts reveals that the interfacial charge density has significant contributions from both SAM carboxylate headgroups and electrolyte components. Ion pairing and ion penetration into the SAM also influence the observed surface acidity. To our knowledge, this study is the first concurrent examination of both effective acidity and electric fields, and highlights the relevance of experienced potentials and specific ion effects at functionalized electrode surfaces.

Probing a Reversible Cationic Switch on a Mixed Self-Assembled Monolayer Using Scanning Electrochemical Microscopy

Probing a switch on biomimic membrane surfaces would offer some references to the research on permeability of cytomembranes. In this work, a mixed 11-mercaptoundecanoic acid/1-undecanethiol self-assembled monolayer (MUA/UT SAM) was constructed as a model of a biomembrane. In this mixed SAM, the MUA molecules work as functional parts for the switch and the UT molecules work as diluents. The surface coverage, wetting property, and pK_a of this mixed SAM all have been well-inspected. The mixed SAM exhibits excellent switchable properties for cations, which is well-monitored by scanning electrochemical microscopy. When the pH of a solution is higher than the pK_a, protons would stimulate a shift of dissociation equilibrium of terminal carboxyl groups. The dissociated carboxylate ions would lead to a switch on the state of the SAM. Otherwise, the SAM shows an off state when the pH is lower than the pK_a. In addition, the repeatability, applicability, and the mechanism of the switch all have been well-evaluated.

Spectroscopic Evidence of Size-Dependent Buffering of Interfacial pH by Cation Hydrolysis during CO2 Electroreduction

The nature of the electrolyte cation is known to affect the Faradaic efficiency and selectivity of CO₂ electroreduction. Singh et al. (J. Am. Chem. Soc. 2016, 138, 13006-13012) recently attributed this effect to the buffering ability of cation hydrolysis at the electrical double layer. According to them, the pK_a of hydrolysis decreases close to the cathode due to the polarization of the solvation water molecules sandwiched between the cation's positive charge and the negative charge on the electrode surface. We have tested this hypothesis experimentally, by probing the pH at the gold-electrolyte interface in situ using ATR-SEIRAS. The ratio between the integrated intensity of the CO₂ and HCO₃^- bands, which has to be inversely proportional to the concentration of H⁺, provided a means to determining the pH change at the electrode-electrolyte interface in situ during the electroreduction of CO₂. Our results confirm that the magnitude of the pH increase at the interface follows the trend Li⁺ > Na⁺ > K⁺ > Cs⁺, adding strong experimental support to Singh's et al.'s hypothesis. We show, however, that the pH buffering effect was overestimated by Singh et al., their overestimation being larger the larger the cation. Moreover, our results show that the activity trend of the alkali-metal cations can be inverted in the presence of impurities that alter the buffering effect of the electrolyte, although the electrolyte with maximum activity is always that for which the increase in the interfacial pH is smaller.

Acid deprotonation driven by cation migration at biased graphene nanoflake electrodes

Deprotonation of acids at an electrode interface is driven by cation migration in response to the applied potential.