Analytical detection and biological assay of antileukemic drug using gold nanoparticles

Developing an analytical method for quantification of trientine based on modified silver nanoparticles

Trientine or (N,N´-bis(2-aminoethyl)-1,2-ethanediamine (TETA) is a copper chelator and used in Wilson's disease, is aliphatic amine that does not have UV absorbing groups. In this study, the modified silver nanoparticles (AgNPs) by sodium lauryl sulfate have been used to develop an analytical method for quantification of TETA. Different concentrations of TETA were added into a particular concentration of AgNPs and absorbance of each sample was measured at 397 nm under the optimal conditions which include pH, time, salt and AgNPs volume. It was optimized by a design of experiments using response surface methodology. Then, the calibration curve was obtained based on the concentrations of TETA solution versus decrease in the absorbance of AgNPs. Selectivity of the developed method was performed in plasma and presence of common cations i.e. copper, zinc and ferrous. Under optimum conditions, linear range of this method was between 10 and 40 ng.mL- 1 with correlation coefficient (R2) of 0.996 with limit of detection and quantification of 3 ng.mL- 1 and 10 ng.mL- 1, respectively. Selectivity of established method in presence of cations eliminated by diluting because of high sensitivity of the established analytical techniques based on AgNPs. This method is suitable and low costing for quantification of TETA and does not require high equipment.

Detection of vasodilator drugs through microwave spectroscopy of Au NP colorimetric probes using a microwave metallic photonic crystal-inspired resonant probe

A low-cost, time-effective and easy-to-use novel analytical technique incorporating microwave spectroscopy of unmodified gold nanoparticles for the detection of selected vasodilator drugs.

XRD, vibrational spectra and quantum chemical studies of an anticancer drug: 6-Mercaptopurine

The single crystal of the hydrated anticancer drug, 6-Mercaptopurine (6-MP), has been grown by slow evaporation technique under room temperature. The structure was determined by single crystal X-ray diffraction. The vibrational spectral analysis was carried out using Laser Raman and FT-IR spectroscopy in the range of 3300-100 and 4000-400 cm(-1). The single crystal X-ray studies shows that the crystal packing is dominated by N-H⋯O and O-H⋯N classical hydrogen bonds leading to a hydrogen bonded ensemble. This classical hydrogen bonds were further connected through O-H⋯S hydrogen bond to form two primary ring R4(4)(16) and R4(4)(12) motifs. These two primary ring motifs are interlinked with each other to build a ladder like structure. These ladders are connected through N-H⋯N hydrogen bond along c-axis of the unit cell through chain C(5) motifs. Further, the strength of the hydrogen bonds is studied through vibrational spectral measurements. The shifting of bands due to the intermolecular interactions was also analyzed in the solid crystalline state. Geometrical optimizations of the drug molecule were done by Density Functional Theory (DFT) using the B3LYP function and Hartree-Fock (HF) level with 6-311++G(d,p) basis set. The optimized molecular geometry and computed vibrational spectra are compared with experimental results which show significant agreement. The natural bond orbital (NBO) analysis was carried out to interpret hyperconjugative interaction and intramolecular charge transfer (ICT). The chemical hardness, electro-negativity and chemical potential of the molecule are carried out by HOMO-LUMO plot. In which, the frontier orbitals has lower band gap value indicating the possible pharmaceutical activity of the molecule.

Analytical detection and method development of anticancer drug Gemcitabine HCl using gold nanoparticles

A simple, rapid, cost effective and extractive UV spectrophotometric method was developed for the determination of Gemcitabine HCl (GMCT) in bulk drug and pharmaceutical formulation. It was based on UV spectrophotometric measurements in which the drug reacts with gold nanoparticles (AuNP) and changes the original colour of AuNP and forms a dark blue coloured solution which exhibits absorption maximum at 688nm. The apparent molar absorptivity and Sandell's sensitivity coefficient were found to be 3.95×10(-5)lmol(-1)cm(-1) and 0.060μgcm(-2) respectively. Beer's law was obeyed in the concentration range of 2.0-40μgml(-1). This method was tested and validated for various parameters according to ICH guidelines. The proposed method was successfully applied for the determination of GMCT in pharmaceutical formulation (parental formulation). The results demonstrated that the procedure is accurate, precise and reproducible (relative standard deviation <2%). As it is simple, cheap and less time consuming, it can be suitably applied for the estimation of GMCT in dosage forms.

Gold nanoparticles enhance the anti-leukemia action of a 6-mercaptopurine chemotherapeutic agent

6-mercaptopurine and its riboside derivatives are some of the most widely utilized anti-leukemic and anti-inflammatory drugs. Their short biological half-life and severe side effects limit their use. A new delivery method for these drugs based on 4-5 nm gold nanoparticles can potentially resolve these issues. We have found substantial enhancement of the antiproliferative effect against K-562 leukemia cells of Au nanoparticles bearing 6-mercaptopurine-9-beta-d-ribofuranoside compared to the same drug in typically administered free form. The improvement was attributed to enhanced intracellular transport followed by the subsequent release in lysosomes. Enhanced activity and nanoparticle carriers will make possible the reduction of the overall concentration of the drug, renal clearance, and, thus, side effects. The nanoparticles with mercaptopurine also showed excellent stability over 1 year without loss of inhibitory activity.

Synthesis of PET-PLA/Drug Nanoparticles and Their Effect with Gold Nanoparticles for Controlled Drug Release in Cancer Chemotherapy

Polyethylene terephthalate-polylactic acid copolymer (PET-PLA) was synthesized from bis (2-hydroxyethyl terephthalate) and L-lactic acid oligomer in the presence of manganese antimony glycoxide as a catalyst. The synthesized PET-PLA copolymer was used for controlled drug release systems with gold nanoparticles. Fluorouracil containing PET-PLA nanocapsules was prepared in the presence of gold nanoparticles by solvent evaporation method. The morphologies of the nanocapsules were characterized using scanning electron microscopy and transmission electron microscopy. Controlled release of Fu and Fu@Au was carried out in 0.1 M phosphate buffer (pH 7.4) and 0.1 M HCl solution. The results indicated that the drug release for gold nanoparticles/fluorouracil (Au@Fu) incorporated PET-PLA nanocapsules was controlled and slow compared to Fu incorporated PET-PLA nanocapsules. This may be due to the interaction between the gold nanoparticles and fluorouracil in PET-PLA nanocapsules.