Silver–zinc electrodeposition from a thiourea solution with added EDTA or HEDTA

Treatment of Cyanide-Free Wastewater from Brass Electrodeposition with EDTA by Electrodialysis: Evaluation of Underlimiting and Overlimiting Operations

Growing environmental concerns have led to the development of cleaner processes, such as the substitution of cyanide in electroplating industries and changes in the treatment of wastewaters. Hence, we evaluated the treatment of cyanide-free wastewater from the brass electroplating industry with EDTA as a complexing agent by electrodialysis, aimed at recovering water and concentrated solutions for reuse. The electrodialysis tests were performed in underlimiting and overlimiting conditions. The results suggested that intense water dissociation occurred at the cathodic side of the commercial anion-exchange membrane (HDX) during the overlimiting test. Consequently, the pH reduction at this membrane may have led to the reaction of protons with complexes of EDTA-metals and insoluble species. This allowed the migration of free Cu²⁺ and Zn²⁺ to the cation-exchange membrane as a result of the intense electric field and electroconvection. These overlimiting phenomena accounted for the improvement of the percent extraction and percent concentration, since in the electrodialysis stack employed herein, the concentrate compartments of cationic and anionic species were connected to the same reservoir. Chronopotentiometric studies showed that electroconvective vortices minimized fouling/scaling at both membranes. The electrodialysis in the overlimiting condition seemed to be more advantageous due to water dissociation and electroconvection.

Smaller is faster and more sensitive: the effect of wire size on the detection of hydrogen by single palladium nanowires

Palladium nanowires prepared using the lithographically patterned nanowire electrodeposition (LPNE) method are used to detect hydrogen gas (H2). These palladium nanowires are prepared by electrodepositing palladium from EDTA-containing solutions under conditions favoring the formation of β-phase PdHx. The Pd nanowires produced by this procedure are characterized by X-ray diffraction, transmission electron microscopy, scanning electron microscopy, atomic force microscopy, and X-ray photoelectron spectroscopy. These nanowires have a mean grain diameter of 15 nm and are composed of pure Pd with no XPS-detectable bulk carbon. The four-point resistance of 50-100 μm segments of individual nanowires is used to detect H2 in N2 and air at concentrations ranging from 2 ppm to 10%. For low [H2] < 1%, the response amplitude increases by a factor of 2-3 with a reduction in the lateral dimensions of the nanowire. Smaller nanowires show accelerated response and recovery rates at all H2 concentrations from, 5 ppm to 10%. For 12 devices, response and recovery times are correlated with the surface area/volume ratio of the palladium detection element. We conclude that the kinetics of hydrogen adsorption limits the observed response rate seen for the nanowire, and that hydrogen desorption from the nanowire limits the observed recovery rate; proton diffusion within PdHx does not limit the rates of either of these processes.