On the role of the thermal treatment of sulfided Rh/CNT catalysts applied in the oxygen reduction reaction

Electronic Asymmetric Distribution of RhCu Bimetallic Nanocrystals for Enhancing Trifunctional Electrocatalysis

Developing efficient and durable multifunctional electrocatalysts for oxygen evolution reaction (OER), hydrogen evolution reaction (HER), and oxygen reduction reaction (ORR) is of significant importance for many electrochemical energy devices, such as water electrolyzers, metal-air batteries, and fuel cells. Herein, the Rh-Cu alloy nanocrystals (NCs) are prepared with a simple wet-chemical approach. The tuning of morphology and the asymmetric electron distribution provide more efficient Rh-Cu bimetallic sites. Meanwhile, the incorporation of Cu into the Rh lattice could reduce the oxidation of Rh-Cu bimetallic sites and increase the catalytic stability. Under the tuning of the composition, the drastically enhanced electrocatalytic activities of HER, OER, and ORR are achieved in the Rh₆Cu₁ NCs with the cell voltage required to be as low as 1.55 V to accomplish an overall water splitting of 10 mA cm^-2 and a maximum power density of 142.58 mW cm^-2 for a zinc-air battery with good stability, representing the best trifunctional electrocatalysts for all we know. This work highlights the design and control of Rh-Cu NCs, which could be a potential alternative approach to trifunctional catalysis and further boosts the development of the bimetallic electrocatalysts in the energy conversion system.

Facile Green Preparation of Rhodium Nanoclusters Supported Nano-Scaled Graphene Platelets for Sonogashira Coupling Reaction and Reduction of p-Nitrophenol

Rhodium nanoclusters were uniformly dispersed on nano-scaled graphene platelets by a simple ‘mix and heat’ method without using any toxic reagents. Distilled water was used to obtain the homogenous dispersion of Rh-nanoclusters on graphene platelets. The morphology of the resultant catalyst (Rh(0)NCs/GNPs) was studied by means of transmission electron microscope (TEM) and atomic force microscope (AFM) analyses. The X-ray photoemission spectroscope (XPS) result confirmed the metallic form of Rh-nanoclusters in Rh(0)NCs/GNPs. The crystalline property and the interaction between Rh-nanoclusters and graphene platelets (GNPs) were studied by means of XRD and Raman analysis. The Rh-loading in Rh(0)NCs/GNPs was confirmed by scanning electron microscope and energy dispersive spectroscope (SEM-EDS) and inductively coupled plasma-mass spectroscope (ICP-MS) analysis. After being optimized, the Rh(0)NCs/GNPs used as catalyst for the reduction of 4-nitrophenol with NaBH4 and the Sonogashira coupling reaction between iodobenzene with phenylacetylene. To our delight, the Rh(0)NCs/GNPs showed excellent catalytic activity towards the reduction of 4-nitrophenol with an excellent turnover frequency (TOF) value of 112.5 min−1. The kapp and k’ values were calculated to be 62.07 × 10−3 min−1(0.002 mg of Rh(0)NCs/GNPs) and 31035 × 10−3 mg−1 min−1,respectively. Alike, under the optimal conditions, the Rh(0)NCs/GNPs gave the desired product, diphenylacetylene, in a good yield of 87% with 91% selectivity. The Rh(0)NCs/GNPs can be reused without significant loss in its catalytic activity.

Non-mercury catalytic acetylene hydrochlorination over Ru catalysts enhanced by carbon nanotubes

Ru catalysts deposited inside the channels of the CNTs show higher catalytic activity. Ru-in-CNT catalyst exhibited an acetylene conversion of 95.0% at 170 °C and 10 h. CNTs with an inner diameter of 3–7 nm can functionalize as an efficient support.

Ruthenium(0) nanoparticles supported on multiwalled carbon nanotube as highly active catalyst for hydrogen generation from ammonia-borane

Ruthenium(0) nanoparticles supported on multiwalled carbon nanotubes (Ru(0)@MWCNT) were in situ formed during the hydrolysis of ammonia-borane (AB) and could be isolated from the reaction solution by filtration and characterized by ICP-OES, XRD, TEM, SEM, EDX, and XPS techniques. The results reveal that ruthenium(0) nanoparticles of size in the range 1.4-3.0 nm are well-dispersed on multiwalled carbon nanotubes. They were found to be highly active catalyst in hydrogen generation from the hydrolysis of AB with a turnover frequency value of 329 min⁻¹. The reusability experiments show that Ru(0)@MWCNTs are isolable and redispersible in aqueous solution; when redispersed they are still active catalyst in the hydrolysis of AB exhibiting a release of 3.0 equivalents of H₂ per mole of NH₃BH₃ and preserving 41% of the initial catalytic activity even after the fourth run of hydrolysis. The lifetime of Ru(0)@MWCNTs was measured as 26400 turnovers over 29 h in the hydrolysis of AB at 25.0 ± 0.1 °C before deactivation. The work reported here also includes the kinetic studies depending on the temperature to determine the activation energy of the reaction (E(a) = 33 ± 2 kJ/mol) and the effect of catalyst concentration on the rate of the catalytic hydrolysis of AB, respectively.

Metal-free and electrocatalytically active nitrogen-doped carbon nanotubes synthesized by coating with polyaniline

Nitrogen doping of multi-walled carbon nanotubes (CNTs) was achieved by the carbonization of a polyaniline (PANI) coating. First, the CNTs were partially oxidized with KMnO4 to obtain oxygen-containing functional groups. Depending on the KMnO4 loading, thin layers of birnessite-type MnO2 (10 wt% and 30 wt%) were obtained by subsequent thermal decomposition. CNT-supported MnO2 was then used for the oxidative polymerization of aniline in acidic solution, and the resulting PANI-coated CNTs were finally heated at 550 degrees C and 850 degrees C in inert gas. The samples were characterized by transmission electron microscopy and X-ray photoelectron spectroscopy. A thin layer of carbonized PANI was observed on the CNT surface, and the surface nitrogen concentration of samples prepared from 30% MnO2 was found to amount to 7.6 at% and 3.8 at% after carbonization at 550 degrees C and 850 degrees C, respectively. These CNTs with nitrogen-containing shell were further studied by electrochemical impedance spectroscopy and used as catalysts for the oxygen reduction reaction. The sample synthesized from 30 wt% MnO2 followed by carbonization at 850 degrees C showed the best electrochemical performance indicating efficient nitrogen doping.