Electrocatalytic oxidation of NADH on a glassy carbon electrode modified with MWCNT-Pd nanoparticles and poly 3,4-ethylenedioxypyrrole

High-Performance Respiration-Based Biocell Using Artificial Nanochannel Regulation

Based on electron and proton transfer events occurring in biological respiration, a mitochondria-based biocell is constructed by combining with artificial nanochannels. In this biocell, mitochondria transfer electrons to the working electrode and pump protons into the electrolyte through the tricarboxylic acid cycle. The nanochannels provide passages for protons to transport along the transmembrane concentration gradient to consume electrons on the counter electrode, forming a continuous and stable current. Furthermore, the proton transmembrane transport behavior could be modulated by regulating the permeability area and surface charge of nanochannels. A high-performance biocell is obtained when equipped with the optimized nanochannels, which produces a current of ≈3.1 mA cm^-2 , a maximum power of ≈0.91 mW cm^-2 , and a lifetime over 60 h. This respiratory-based biocell shows great potential for the efficient utilization of bioelectricity.

Single-walled carbon nanotubes covalently functionalized with polytyrosine: A new material for the development of NADH-based biosensors

We report for the first time the use of single-walled carbon nanotubes (SWCNT) covalently functionalized with polytyrosine (Polytyr) (SWCNT-Polytyr) as a new electrode material for the development of nicotinamide adenine dinucleotide (NADH)-based biosensors. The oxidation of glassy carbon electrodes (GCE) modified with SWCNT-Polytyr at potentials high enough to oxidize the tyrosine residues have allowed the electrooxidation of NADH at low potentials due to the catalytic activity of the quinones generated from the primary oxidation of tyrosine without any additional redox mediator. The amperometric detection of NADH at 0.200V showed a sensitivity of (217±3)µAmM(-1)cm(-2) and a detection limit of 7.9nM. The excellent electrocatalytic activity of SWCNT-Polytyr towards NADH oxidation has also made possible the development of a sensitive ethanol biosensor through the immobilization of alcohol dehydrogenase (ADH) via Nafion entrapment, with excellent analytical characteristics (sensitivity of (5.8±0.1)µAmM(-1)cm(-2), detection limit of 0.67µM) and very successful application for the quantification of ethanol in different commercial beverages.

Fabrication of a sensitive amperometric sensor for NADH and H2O2 using palladium nanoparticles-multiwalled carbon nanotube nanohybrid

Palladium nanoparticles decorated multiwalled carbon nanotubes (PdNPs-MWCNTs) were synthesized and simply cast on the surface of a glassy carbon electrode (GCE) to prepare an amperometric sensor. The fabricated sensor (PdNPs-MWCNTs/GCE) showed excellent electrocatalytic activity towards NADH and H2O2 oxidation and H2O2 reduction. A fast, linear and highly sensitive response was observed for NADH in the concentration range between 0.1 and 200 μM with a detection limit (S/N=3) of 32 nM. Also, the sensor exhibited fast and sensitive responses (<2 s) towards H2O2. The sensitivity and detection limit for H2O2 at the operating potential of +0.35 V were 167 nA μM(-1)cm(-2) and 1.2 μM, respectively and better than those obtained at the operating potential of -0.25 V (68 nA μM(-1)cm(-2) and 14 μM). Moreover, further modification of the proposed sensor by glucose oxidase led to the fabrication of a glucose biosensor with satisfactory performance.

Conducting polymer and its composite materials based electrochemical sensor for Nicotinamide Adenine Dinucleotide (NADH)

Nicotinamide Adenine Dinucleotide (NADH) is an important coenzyme in the human body that participates in many metabolic reactions. The impact of abnormal concentrations of NADH significantly causes different diseases in human body. Electrochemical detection of NADH using bare electrode is a challenging task especially in the presence of main electroactive interferences such as ascorbic acid (AA), uric acid (UA) and dopamine (DA). Modified electrodes have been widely explored to overcome the problems of poor sensitivity and selectivity occurred from bare electrodes. This review gives an overview on the progress of using conducting polymers, polyelectrolyte and its composites (co-polymer, carbonaceous, metal, metal oxide and clay) based modified electrodes for the sensing of NADH. In addition, developments on the fabrication of numerous conducting polymer composites based modified electrodes are clearly described.

Immobilization of Ni-Pd/core-shell nanoparticles through thermal polymerization of acrylamide on glassy carbon electrode for highly stable and sensitive glutamate detection

The preparation of a persistently stable and sensitive biosensor is highly important for practical applications. To improve the stability and sensitivity of glutamate sensors, an electrode modified with glutamate dehydrogenase (GDH)/Ni-Pd/core-shell nanoparticles was developed using the thermal polymerization of acrylamide (AM) to immobilize the synthesized Ni-Pd/core-shell nanoparticles onto a glassy carbon electrode (GCE). The modified electrode was characterized by scanning electron microscopy (SEM), Fourier transform infrared (FTIR) spectroscopy, cyclic voltammetry (CV), and electrochemical impedance spectroscopy (EIS). Electrochemical data showed that the prepared biosensor had remarkably enhanced electrocatalytic activity toward glutamate. Moreover, superior reproducibility and excellent stability were observed (relative average deviation was 2.96% after continuous use of the same sensor for 60 times, and current responses remained at 94.85% of the initial value after 60 d). The sensor also demonstrated highly sensitive amperometric detection of glutamate with a low limit of detection (0.052 μM, S/N = 3), high sensitivity (4.768 μA μM(-1) cm(-2)), and a wide, useful linear range (0.1-500 μM). No interference from potential interfering species such as l-cysteine, ascorbic acid, and l-aspartate were noted. The determination of glutamate levels in actual samples achieved good recovery percentages.

Electrochemical oxidation of dihydronicotinamide adenine dinucleotide at nitrogen-doped carbon nanotube electrodes

Nitrogen-doped carbon nanotubes (N-CNTs) substantially lower the overpotential necessary for dihydronicotinamide adenine dinucleotide (NADH) oxidation compared to nondoped CNTs or traditional carbon electrodes such as glassy carbon (GC). We observe a 370 mV shift in the peak potential (Ep) from GC to CNTs and another 170 mV shift from CNTs to 7.4 atom % N-CNTs in a sodium phosphate buffer solution (pH 7.0) with 2.0 mM NADH (scan rate 10 mV/s). The sensitivity of 7.4 atom % N-CNTs to NADH was measured at 0.30 ± 0.04 A M(-1) cm(-2), with a limit of detection at 1.1 ± 0.3 μM and a linear range of 70 ± 10 μM poised at a low potential of -0.32 V (vs Hg/Hg2SO4). NADH fouling, known to occur to the electrode surface during NADH oxidation, was investigated by measuring both the change in Ep and the resulting loss of electrode sensitivity. NADH degradation, known to occur in phosphate buffer, was characterized by absorbance at 340 nm and correlated with the loss of NADH electroactivity. N-CNTs are further demonstrated to be an effective platform for dehydrogenase-based biosensing by allowing glucose dehydrogenase to spontaneously adsorb onto the N-CNT surface and measuring the resulting electrode's sensitivity to glucose. The glucose biosensor had a sensitivity of 0.032 ± 0.003 A M(-1) cm(-2), a limit of detection at 6 ± 1 μM, and a linear range of 440 ± 50 μM.

Electrocatalytic activity of nickel oxide nanoparticles as mediatorless system for NADH and ethanol sensing at physiological pH solution

The glassy carbon (GC) electrode modified by nickel oxide nanoparticles (NiOxNPs) is proposed as a novel electrocatalytic system for the oxidation of NADH without using any electron transfer mediator. Here, chronoamperometry was used not only as a simple method for the deposition of NiOxNPs onto the GC electrode but also as an efficient tool in the controlling of nanoparticles size and efficient electrocatalytic activity. The surface morphology and electrochemical properties of the NiOxNPs/GC electrode was investigated using scanning electron microscopy and cyclic voltammetry techniques, respectively. The NPs are deposited uniformly across the GC surface and the size of NiOxNPs varies from 20 to less than 100 nm. The NiOxNPs/GC electrode shows excellent electrocatalytic activity toward oxidation of NADH at reduced overvoltage. The detection limit and sensitivity of the modified electrode toward NADH were estimated to be 106 nM (S/N=3) and 0.052 μAμM(-1), respectively at a concentration range up to 1mM. Due to the biocompatibility of NiOxNPs toward biomolecules, this modified electrode can be used as an efficient transducer in the design of an ethanol biosensor based on the coupled alcohol dehydrogenase enzyme(ADH). Hydrodynamic amperometric detection of ethanol on the ADH-Nafion/NiOxNPs/GC modified electrode gives linear responses over the concentration range of 0.2-6mM with a detection limit of 6.4 μM and sensitivity of 36 nA mM(-1). Applicability of the proposed biosensor for ethanol detection in real samples, easy and simple preparation, being mediator free, high sensitivity and biocompatibility are the major advantages of the proposed biosensor.

Electrochemistry of Q-graphene

A newly synthesised type of graphene, Q-Graphene, has been physically and electrochemically characterised with Scanning and Transmission Electron Microscopy (SEM, TEM), X-ray Photoelectron Spectroscopy (XPS) and Cyclic Voltammetry (CV). Interpretation of SEM, TEM and XPS data reveal the material to consist of hollow carbon nanospheres of multi-layer graphene (viz. graphite), which exhibit a total oxygen content of ca. 36.0% (atomic weight via XPS). In addition to the carbon structures present, spherical magnesium oxide particles of ≤50 nm in diameter are abundantly present in the sample (ca. 16.2%). Interestingly, although the TEM/SEM images show macroporous carbon structures, Raman spectroscopy shows peaks typically characteristic of graphene, which suggests the material is highly heterogeneous and consists of many types of carbon allotropes. Q-Graphene is electrochemically characterised using both inner-sphere and outer-sphere electrochemical redox probes, namely potassium ferrocyanide(II), hexaammine-ruthenium(III) chloride and hexachloroiridate(III), in addition to the biologically relevant and electroactive analytes, norepinephrine, β-nicotinamide adenine dinucleotide (NADH) and l-ascorbic acid. The electrochemical response of Q-Graphene is benchmarked against edge plane- and basal plane-pyrolytic graphite (EPPG and BPPG respectively), pristine graphene and graphite alternatives. Q-Graphene is found to exhibit fast electron transfer kinetics, likely due to its high proportion of folded edges and surface defects, exhibiting a response similar to that of EPPG - which exhibits fast electron transfer rates due to the high proportion of edge plane sites it possesses. Furthermore, we demonstrate that the specific oxygen content plays a pivotal role in dictating the observed electrochemical response, which is analyte dependant. Consequently there is potential for this new member of the graphene family to be beneficially utilised in various electrochemical applications.