Electro-oxidation of ethylene glycol on nanoporous Ti–Cu amorphous alloy

Stimulation of ethylene glycol electrooxidation on electrodeposited Ni–PbO2–GN nanocomposite in alkaline medium

In this work, a novel system composed of non-precious nickel-based metal oxide/reduced graphene oxide nanocomposite (Ni–PbO2–GN) is used for electrooxidation of ethylene glycol (EG) in 1.0 M NaOH solution and compares its activity with that of Ni, Ni–GN, and Ni–PbO2. The facile electrodeposition technique is used to prepare the catalysts on glassy carbon (GC) substrates. The outcomes of electrochemical measurements show a high performance towards EG oxidation is obtained for Ni-nanocomposite electrodes compared to that of Ni mainly due to their higher surface areas. The excellent electrocatalytic properties of the Ni-nanocomposite could be ascribed to the synergistic contributions of PbO2 and graphene (GN) nano-sheets that help the reduction of Ni grains. A smaller charge transfer resistance value of 34.5 Ω cm2 for EG oxidation reaction at + 360 mV is recorded for GC/Ni–PbO2–GN compared to the other prepared electrodes. Moreover, it exhibits higher kinetic parameters of EG such as diffusion coefficient (D = 3.9 × 10–10 cm2 s−1) and charge transfer rate constant (ks = 32.5 mol−1 cm3 s−1). The overall performance and stability of the prepared catalysts towards EG electrooxidation have been estimated to be in the order of GC/Ni–PbO2–GN > GC/Ni–GN > GC/Ni–PbO2 > GC/Ni.

Graphical abstract

Effect of Anode Material on Electrochemical Oxidation of Low Molecular Weight Alcohols-A Review

The growing climate crisis inspires one of the greatest challenges of the 21st century-developing novel power sources. One of the concepts that offer clean, non-fossil electricity production is fuel cells, especially when the role of fuel is played by simple organic molecules, such as low molecular weight alcohols. The greatest drawback of this technology is the lack of electrocatalytic materials that would enhance reaction kinetics and good stability under process conditions. Currently, electrodes for direct alcohol fuel cells (DAFCs) are mainly based on platinum, which not only provides a poor reaction rate but also readily deactivates because of poisoning by reaction products. Because of these disadvantages, many researchers have focused on developing novel electrode materials with electrocatalytic properties towards the oxidation of simple alcohols, such as methanol, ethanol, ethylene glycol or propanol. This paper presents the development of electrode materials and addresses future challenges that still need to be overcome before direct alcohol fuel cells can be commercialized.

Fabrication and characterization of nanoporous Cu–Sn intermetallicsviadealloying of ternary Mg–Cu–Sn alloys

The dealloying of Mg–Cu–Sn alloys leads to the formation of nanoporous Cu–Sn intermetallics.