Differential dynamic potentiometric responses obtained with anion-selective electrodes for perchlorate, thiocyanate, iodide, nitrate, sulfate, picrate and bis(trifluoromethylsulfonyl) imide

A Simultaneous Determination Method for the Analysis of Chloride and Nitrate Ions in Air Samples by PLS1

This study describes a multi-ion-selective electrode system for the simultaneous determination of nitrate and chloride ions in air samples by using multivariate calibration methods. The measurement system was constituted of two ion-selective electrodes, an Ag/AgCl double-junction reference electrode and a multi-potentiometer. The measurements were performed at pH 5.0 acetic acid/sodium acetate buffer. The obtained data were evaluated by using Partial Least Squares (PLS1). The system was used to analyze the synthetic samples and fume-hood samples in terms of the amount of chloride and nitrate. The percentage recovery values obtained from fume-hood samples were 93.8% ± 3.8 and 102.4% ± 2.5 for chloride and nitrate, respectively. The presented system could be an easy-to-use approach for monitoring the amount of chloride and nitrate species in the scope of occupational health and safety analysis.

Exploring Protein-Inorganic Hybrid Nanoflowers and Immune Magnetic Nanobeads to Detect Salmonella Typhimurium

Early screening of pathogenic bacteria is key to preventing and controlling outbreaks of foodborne diseases. In this study, protein-inorganic hybrid nanoflowers were synthesized for signal amplification and used with a calcium ion selective electrode (Ca-ISE) to establish a new enzyme-free assay for rapid and sensitive detection of Salmonella. Calcium hydrophosphate crystals were first conjugated with polyclonal antibodies against Salmonella to synthesize immune calcium nanoflowers (CaNFs), and streptavidin modified magnetic nanobeads (MNBs) were conjugated with biotinylated monoclonal antibodies against Salmonella to form immune MNBs. After target bacteria were separated using immune MNBs to form magnetic bacteria, immune CaNFs were conjugated with magnetic bacteria to form nanoflower conjugated bacteria. Then, hydrogen chloride was used to release calcium ions from nanoflower conjugated bacteria. After magnetic separation, the supernatant was finally injected as a continuous-flow to fluidic chip with Ca-ISE for specific detection of calcium ions. The supernatant's potential had a good linear relationship with bacteria concentration, and this assay was able to detect the S. Typhimurium cells as low as 28 colony forming units/mL within two hours. The mean recovery of target bacteria in spiked chicken samples was 95.0%. This proposed assay shows the potential for rapid, sensitive, and on-line detection of foodborne pathogens.

A colorimetric probe based on desensitized ionene-stabilized gold nanoparticles for single-step test for sulfate ions

Desensitized ionene-stabilized gold nanoparticles have been prepared and applied as a colorimetric probe for the single-step test for sulfate ions at the relatively high concentration level. The approach is based on aggregation of the nanoparticles leading to the change in absorption spectra and color of the solution. These nanoparticles are characterized by the decreased sensitivity due to both electrostatic and steric stabilization, which allows for simple, and rapid direct single-step determination of sulfate at the relatively high concentration level in real water samples without sample pretreatment or dilution. Influence of different factors (the time of interaction, pH, the concentrations of sulfate ions and the nanoparticles) on the aggregation and analytical performance of the procedure was investigated. The method allows for the determination of sulfate ions in the mass range of 0.2-0.4 mg with RSD of 5% from the sample volume of less than 2 mL. It has a sharp dependence of the colorimetric response on the concentration of sulfate, which makes it prospective for indicating deviations of the sulfate concentration regarding some declared value chosen within the above range. The time of the analysis is 2 min. The method was applied to the analysis of mineral water samples.