Electrochemical sensing of 2D condensation in amyloid peptides

Adsorption/desorption behavior of hyaluronic acid fragments at charged hydrophobic surface

This work reveals the growing potential of novel electrochemical methods that are applicable for polysaccharides. It was shown for the first time that the molecules of hyaluronic acid (HA) exhibit electrochemical response using phase-sensitive alternating current (AC) voltammetry in phase-out mode. Adsorption and desorption processes of HA fragments at a charged interface of mercury electrode were observed in buffered HA solutions. Electrostatic and hydrophobic manners of interactions were distinguished for native hyaluronan fragments in a wide electric potential range. The AC voltammetry response depended on the temperature, concentration, and length of HA chains. Results of this work open possibilities for further structural characterization of widely used HA fragments and understanding manners of interactions with charged hydrophobic surfaces that could be useful in the future for understanding HA interactions at biological levels.

Adsorption/desorption of biomacromolecules involved in catalytic hydrogen evolution

Previously, it has been shown that proteins and some polysaccharides (PSs) catalyse hydrogen evolution, producing electrochemical signals on mercury electrodes. The catalytic hydrogen evolution reaction (CHER) of the above-mentioned biomacromolecules was studied by voltammetric and chronopotentiometric stripping (CPS) methods. To obtain more information about electrode processes involving CHER, here we used protein such as BSA, and chitosan as a PS; in addition, we investigated dextran as a control PS not involved in CHER. We studied biomacromolecules by phase-sensitive alternating current (AC) voltammetry. Using phase-in AC voltammetry, for CHER-involved biomacromolecules we observed a CHER peak at highly negative potentials, similar to that observed with other voltammetric and CPS methods. On the other hand, by means of the adsorption/desorption processes studied in phase-out AC voltammetry, we uncovered a sharp and narrow decrease of capacitive current in the potential range of the CHER peak, denominated as the tensammetric minimum. This minimum was closely related to the CHER peak, as demonstrated by similar dependences on specific conditions affecting the CHER peak such as buffer capacity and pH. A tensammetric minimum was not observed for dextran. Our results suggest specific organization of biopolymer layers at negative potentials observed only in biomacromolecules involved in CHER.

General Signal Amplification Strategy for Nonfaradic Impedimetric Sensing: Trastuzumab Detection Employing a Peptide Immunosensor

A label-free and reagent-free peptide mimotope capacitive biosensor has been developed for cancer drug (trastuzumab) quantification based on nonfaradic readout. The low sensitivity issue of capacitive biosensors was overcome with two innovations: peptide mimotope mixed self-assembled monolayer (SAM) biointerface and dilution of the analysis buffer. Signal amplification was achieved through dilution of phosphate-buffered saline (PBS) to tune C_dl to dominate the overall capacitance change upon target binding, which contribution is often negligible without dilution. After 1000× dilution, the limit of detection was lowered 500-fold (0.22 μg/mL) and the sensitivity was increased 20-fold [0.04192 (μg/mL)^-1] in comparison with undiluted PBS. The proposed signal amplification strategy is more straightforward and practical compared to biorecognition element engineering and other strategies. The proposed method was further applied to planar electrodes for optimizing sensing response time to less than 1 min.