On the electrochemical properties of platinum stepped surfaces vicinal to the (100) pole. A computational study

Monitoring of CO Binding Sites on Stepped Pt Single Crystal Electrodes in Alkaline Solutions by in Situ FTIR Spectroscopy

The site geometry preference of CO binding on stepped Pt single crystals in alkaline solution was investigated by in situ FTIR spectroscopy. The surfaces of the Pt single crystals consisted of different width (111) terraces, interrupted by (110) or (100) monatomic steps. Experiments carried out with CO adsorbed exclusively on the top of the steps revealed that only linearly bonded CO formed on the (110) steps, while two CO binding geometries (linear and bridge) were observed on the (100) steps. On one hand, for CO adsorbed only on the steps, the positions of the bands corresponding to linearly bonded CO were similar, regardless of the density of steps, suggesting the existence of an interaction between CO_ads only along the line of the steps. On the other hand, for full CO coverage, the CO stretching frequencies and the geometry of bound CO were sensitive to the width of the (111) terraces and the step orientations. Consequently, the CO binding sites favored linearly bonded CO for surfaces consisting of shorter (111) terraces and (110) steps. Bridge-bonded CO was favored on surfaces consisting of shorter (111) terraces interrupted by (100) steps. In order to understand the origin of the preference of CO binding sites, the results were compared to the corresponding behavior in acid media, which revealed that, in addition to the effect inherent to the Pt surface, the charge on the metal side in an aqueous environment should be taken into consideration. The analysis suggested that the CO adlayers formed at full coverage in acidic and alkaline media had different structures. On the other hand, the structure of the layer of CO adsorbed only at the steps was independent of pH.

A comparison of the uniaxial deformation of copper and nickel (1 1 19) surfaces: a molecular dynamics study

While a lot is known about the deformation of metallic surfaces from experiments, elasticity theory and simulations, this investigation represents the first molecular-dynamics-based simulation of uniaxial deformation for the vicinal surfaces in a comparison of copper and nickel. These vicinal surfaces are composed of terraces divided by equidistant, mono-atomic steps. The periodicity of vicinals makes them good candidates for the study of the surface steps’ influences on surface dynamics. The simulations of tensile and compressive uniaxial deformations were performed for the (1 1 19) vicinal surfaces. Since the steps on the surfaces serve as stress concentrators, the first defects were expected to nucleate here. In the case of copper, this was found to be the case. In the case of nickel, however, dislocations nucleated beneath the near-surface layer affected by the displacement field generated by the steps. Slip was hindered at the surface step by the vortex in the displacement field. The differences in the deformation mechanisms for the Ni(1 1 19) and Cu(1 1 19) surfaces can be linked to the differences in their displacement fields. This could lead to novel bottom-up approaches to the nanostructuring of surfaces using strain.