Photoelectrochemical evidence of inhomogeneous composition at nm length scale of anodic films on valve metals alloys

The Effect of Anodizing Bath Composition on the Electronic Properties of Anodic Ta-Nb Mixed Oxides

Anodic oxides were grown to 50 V on Ta-Nb sputtering deposited alloys, with high Nb content, in acetate ions containing an aqueous solution to study the effect of the anodizing bath composition on anodic layers' dielectric properties. Photoelectrochemical measurements proved the presence of a photocurrent in the band gap of photon energy lower than oxides, due to optical transitions involving localized electronic states as a consequence of acetate ions incorporation. Flat band potential value estimates assessed the insulating nature of the anodic oxides grown in the acetate buffer solution. Differential capacitance measurements showed that the highest capacitance value was measured for the sample grown on Ta-66%Nb. This capacitance value was higher with respect to those estimated for pure Ta and pure Nb anodic layers and with respect to the same alloy anodized in NaOH solution, i.e., acetate-free anodizing bath.

FeTiO3 Perovskite Nanoparticles for Efficient Electrochemical Water Splitting

The use of water splitting has been investigated as a good alternate for storing electrical energy. While the general interest in developing non-toxic, high-performance, and economically feasible catalysts for oxygen evolution reaction (OER) is noteworthy, there is also significant interest in water splitting research. Recently, perovskite-type oxides have performed as an alternative to non-precious metal catalysts and can act as a new class of effective catalysts in water splitting systems. Herein, a perovskite-structured FeTiO3 was prepared via a facile one-step solvothermal method using ionic liquid as templates. The results of structural and morphological studies have supported the formation of FeTiO3 perovskite. Furthermore, FeTiO3 perovskite demonstrated OER activity with a lower onset potential of 1.45 V vs. RHE and Tafel slope value of 0.133 V.dec−1 at 1 M KOH solution using mercury/mercurous oxide (Hg/HgO) were used as working electrodes.

A Generalized Semiempirical Approach to the Modeling of the Optical Band Gap of Ternary Al-(Ga, Nb, Ta, W) Oxides Containing Different Alumina Polymorphs

A generalization of the modeling equation of optical band gap values for ternary oxides, as a function of cationic ratio composition, is carried out based on the semiempirical correlation between the differences in the electronegativity of oxygen and the average cationic electronegativity proposed some years ago. In this work, a novel approach is suggested to account for the differences in the band gap values of the different polymorphs of binary oxides as well as for ternary oxides existing in different crystalline structures. A preliminary test on the validity of the proposed modeling equations has been carried out by using the numerous experimental data pertaining to alumina and gallia polymorphs as well as the crystalline ternary Ga(1-x)AlxO3 polymorphs (α-Ga(1-x)AlxO3 and β-Ga(1-x)AlxO3) covering a large range of optical band gap values (4.50-8.50 eV). To make a more rigorous test of the modeling equation, we extended our investigation to amorphous ternary oxides anodically formed on Al-d-metal alloys (Al-Nb, Al-Ta, and Al-W) covering a large range of d-metal composition (xd-metal ≥ 0.2). In the last case, the novel approach allows one to overcome some difficulties experienced in fitting the optical band gap dependence from the Al-d-metal mixed anodic oxide composition as well as to provide a rationale for the departure, at the lowest d-metal content (xd-metal < 0.2), from the behavior observed for anodic films containing higher d-metal content.

Compositionally Dependent Nonlinear Optical Bandgap Behavior of Mixed Anodic Oxides in Niobium-Titanium System

Optical bandgap mapping of Nb-Ti mixed oxides anodically grown on a thin film parent metallic combinatorial library was performed via variable angle spectroscopic ellipsometry (VASE). A wide Nb-Ti compositional spread ranging from Nb-90 at.% Ti to Nb-15 at.% Ti deposited by cosputtering was used for this purpose. The Nb-Ti library was stepwise anodized at potentials up to 10 V SHE, and the anodic oxides optical properties were mapped along the Nb-Ti library with 2 at.% resolution. The surface dissimilarities along the Nb-Ti compositional gradient were minimized by tuning the deposition parameters, thus allowing a description of the mixed Nb-Ti oxides based on a single Tauc-Lorentz oscillator for data fitting. Mapping of the Nb-Ti oxides optical bandgap along the entire compositional spread showed a clear deviation from the linear model based on mixing individual Nb and Ti electronegativities proportional to their atomic fractions. This is attributed to the strong amorphization and an in-depth compositional gradient of the mixed oxides. A systematic optical bandgap decrease toward values as low as 2.0 eV was identified at approximately 50 at.% Nb. Mixing of Nb₂O₅ and TiO₂ with both amorphous and crystalline phases is concluded, whereas the possibility of complex Nb_aTi_bO_y oxide formation during anodization is unlikely.