Nickel/MWCNT-Al 2 O 3 electrochemical co-deposition: Structural properties and mechanistic aspects

Carbon and Carbon-Based Composite Thin Films/Coatings: Synthesis, Properties and Applications

The production of composite thin films/coatings with desired properties is currently an important scientific and technical area [...]

Pulsed Electrodeposition and Properties of Nickel-Based Composite Coatings Modified with Graphene Oxide

Composite electrochemical coatings (CECs) on the basis of nickel modified with multilayer graphene oxide (GO) were deposited from a sulfate–chloride electrolyte in pulsed electrolysis mode. The microstructure of these CECs was studied by X-ray phase analysis and scanning electron microscopy. It was found that the microhardness of nickel–GO CECs increases by approximately 1.40 times compared to pure nickel. The corrosion–electrochemical behavior of nickel–GO composite coatings in 0.5 M H2SO4 was studied. Based on tests in 3.5% NaCl, it was found that the addition of graphene oxide particles into the matrix of nickel electrodeposits, increases their corrosion resistance by 1.40–1.50 times. This can be explained by the uniformity of the distribution of GO in the nickel matrix, which contributes to the reduction in grain size, as well as the impermeability and stability of graphene oxide.

Electrodeposition and Corrosion Properties of Nickel-Graphene Oxide Composite Coatings

Nickel-based composite electrochemical coatings (CEC) modified with multilayer graphene oxide (GO) were obtained from a sulfate-chloride electrolyte in the reverse electrolysis mode. The microstructure of these CECs was investigated by X-ray phase analysis and scanning electron microscopy. The corrosion-electrochemical behavior of nickel–GO composite coatings in a 0.5 M solution of H₂SO₄was studied. Tests in a 3.5% NaCl solution showed that the inclusion of GO particles into the composition of electrolytic nickel deposits makes their corrosion rate 1.40–1.50 times less.

A Novel Processing for CNT-Reinforced Mg-Matrix Laminated Composites to Enhance the Electromagnetic Shielding Property

The microstructure, electrical conductivity, and electromagnetic interference (EMI) shielding effectiveness (SE) of CNTs/Mg Matrix composites prepared by accumulative roll bonding (ARB) were systematically investigated to understand the effects of CNTs on the electromagnetic interference shielding effectiveness property of magnesium. A model based on the shielding of the electromagnetic plane wave was used to theoretically discuss the EMI shielding mechanisms of ARB-processed composites. The experimental results indicated that the methods were feasible to prepare laminated composites. The SE of the material increased gradually with the increase of electrophoretic deposition time. When the electrophoretic deposition time reached 8 min, the value of SE remained 87–95 dB in the frequency range of 8.2–12.4 GHz. The increase in SE was mainly attributed to the improvement in the reflection and multiple reflection losses of incident electromagnetic wave due to the increased amounts of CNTs and interfaces. The methods provided an efficient strategy to produce laminated metal matrix composites with high electromagnetic shielding properties.