Electrochromic properties of thin nanocrystalline TiO 2 films coated electrodes with adsorbed Co(II) or Fe(II) 2,2′-bipyridine complexes

Advances in nanomaterials for electrochromic devices

This review article systematically highlights the recent advances regarding the design, preparation, performance and application of new and unique nanomaterials for electrochromic devices.

Nanocrystalline Sb-doped SnO2 films modified with cyclometalated ruthenium complexes for two-step electrochromism

Sb-Doped nanocrystalline SnO2 (SnO2:Sb) thin films functionalized with cyclometalated ruthenium complexes 1 or 2 on FTO conductive glasses have been prepared and characterized. These complexes contain a redox-active amine unit separated from the ruthenium ion by a phenyl or biphenyl linker, respectively, to modify the absorption wavelengths at different redox states. Near-infrared electrochromism of both films has been examined by oxidative spectroelectrochemical measurements and double-potential-step chronoamperometry. A contrast ratio (ΔT%) of 33% at 1070 nm and 63% at 696 nm has been achieved for the SnO2:Sb/1 film in two stepwise oxidation processes, respectively. The other film with complex 2 shows two-step electrochromism at 1310 and 806 nm with ΔT% of 36% and 76%, respectively. The response time of electrochromic switching is around a few seconds. Taking advantage of the good contrast ratio, the rapid response, and the long retention time of each oxidation state, these films have been successfully used to demonstrate surface-confined flip-flop memory functions with a high ON/OFF ratio.

Sulfur-, nitrogen- and platinum-doped titania thin films with high catalytic efficiency under visible-light illumination

Titanium dioxide photocatalysts have received a lot of attention during the past decades due to their ability to degrade various organic pollutants to CO₂ and H₂O, which makes them suitable for use in environmental related fields such as air and water treatment and self-cleaning surfaces. In this work, titania thin films and powders were prepared by a particulate sol-gel route, using titanium tetrachloride (TiCl₄) as a precursor. Afterwards, the prepared sols were doped with nitrogen (ammonium nitrate, urea), sulfur (thiourea) and platinum (chloroplatinic acid), coated onto glass substrates by dip-coating, and thermally treated in a muffle furnace to promote crystallization. The resulting thin films were then characterized by various techniques (i.e., TGA-DSC-MS, XRD, BET, XPS, SEM, band gap measurements). The photocatalytic activity of the prepared thin films was determined by measuring the degradation rate of plasmocorinth B (PB), an organic pigment used in the textile industry, which can pose an environmental risk when expelled into wastewater. A kinetic model for adsorption and subsequent degradation was used to fit the experimental data. The results have shown an increase in photocatalytic activity under visible-light illumination of nonmetal and metal doped and co-doped titania thin films compared to an undoped sample.