Porous boron-doped diamond electrode for detection of dopamine and pyridoxine in human serum

Enhancing electroanalytical performance of porous boron-doped diamond electrodes by increasing thickness for dopamine detection

Novel porous boron-doped diamond (BDD_porous)-based materials have attracted lots of research interest due to their enhanced detection ability and biocompatibility, favouring them for use in neuroscience. This study reports on morphological, spectral, and electrochemical characterisation of three BDD_porous electrodes of different thickness given by a number of deposited layers (2, 3 and 5). These were prepared using microwave plasma-enhanced chemical vapour deposition on SiO₂ nanofiber-based scaffolds. Further, the effect of number of layers and poly-l-lysine coating, commonly employed in neuron cultivation experiments, on sensing properties of the neurotransmitter dopamine in a pH 7.4 phosphate buffer media was investigated. The boron doping level of ∼2 × 10²¹ atoms cm^-3 and increased content of non-diamond (sp²) carbon in electrodes with more layers was evaluated by Raman spectroscopy. Cyclic voltammetric experiments revealed reduced working potential windows (from 2.4 V to 2.2 V), higher double-layer capacitance values (from 405 μF cm^-2 to 1060 μF cm^-2), enhanced rates of electron transfer kinetics and larger effective surface areas (from 5.04 mm² to 7.72 mm²), when the number of porous layers increases. For dopamine, a significant boost in analytical performance was recognized with increasing number of layers using square-wave voltammetry: the highest sensitivity of 574.1 μA μmol^-1 L was achieved on a BDD_porous electrode with five layers and dropped to 35.9 μA μmol^-1 L when the number of layers decreased to two. Consequently, the lowest detection limit of 0.20 μmol L^-1 was obtained on a BDD_porous electrode with five layers. Moreover, on porous electrodes, enhanced selectivity for dopamine detection in the presence of ascorbic acid and uric acid was demonstrated. The application of poly-l-lysine coating on porous electrode surface resulted in a decrease in dopamine peak currents by 17% and 60% for modification times of 1 h and 15 h, respectively. Hence, both examined parameters, the number of deposited porous layers and the presence of poly-l-lysine coating, were proved to considerably affect the characteristics and performance of BDD_porous electrodes.

Graphene and Carbon Nanotube-based Electrochemical Sensing Platforms for Dopamine

Dopamine (DA) is an important neurotransmitter, which is created and released from the central nervous system. It plays a crucial role in human activities, like cognition, emotions, and response to anything. Maladjustment of DA in human blood serum results in different neural diseases, like Parkinson's and Schizophrenia. Consequently, researchers have started working on DA detection in blood serum, which is undoubtedly a hot research area. Electrochemical sensing techniques are more promising to detect DA in real samples. However, utilizing conventional electrodes for selective determination of DA encounters numerous problems due to the coexistence of other materials, such as uric acid and ascorbic acid, which have an oxidation potential close to DA. To overcome such problems, researchers have put their focus on the modification of bare electrodes. The aim of this review is to present recent advances in modifications of most used bare electrodes with carbonaceous materials, especially graphene, its derivatives, and carbon nanotubes, for electrochemical detection of DA. A brief discussion about the mechanistic phenomena at the electrode interface has also been included in this review.

Conductive Nanodiamond-Based Detection of Neurotransmitters: One Decade, Few Sensors

Nanodiamond (ND) is a class of carbon nanomaterial with covalently connected sp³ carbon atoms in its core and an sp² carbon adorned surface via edge defects or doping. Endogenous chemicals that provoke physiological responses in the human system called neurotransmitters (NTs) have been detected with several sensors with carbon-based nanomaterials. Nanodiamonds (NDs), another class of carbon nanomaterial, have shown the requisite surface area and electrocatalytic activity toward NTs in the past decade. Surprisingly, only a few electrochemical ND based NT sensors are available. This work briefly looked into the performance of the available sensors, NT and ND interactions, and the possible reason for data paucity on the subject matter.

Next-Generation Diamond Electrodes for Neurochemical Sensing: Challenges and Opportunities

Carbon-based electrodes combined with fast-scan cyclic voltammetry (FSCV) enable neurochemical sensing with high spatiotemporal resolution and sensitivity. While their attractive electrochemical and conductive properties have established a long history of use in the detection of neurotransmitters both in vitro and in vivo, carbon fiber microelectrodes (CFMEs) also have limitations in their fabrication, flexibility, and chronic stability. Diamond is a form of carbon with a more rigid bonding structure (sp3-hybridized) which can become conductive when boron-doped. Boron-doped diamond (BDD) is characterized by an extremely wide potential window, low background current, and good biocompatibility. Additionally, methods for processing and patterning diamond allow for high-throughput batch fabrication and customization of electrode arrays with unique architectures. While tradeoffs in sensitivity can undermine the advantages of BDD as a neurochemical sensor, there are numerous untapped opportunities to further improve performance, including anodic pretreatment, or optimization of the FSCV waveform, instrumentation, sp2/sp3 character, doping, surface characteristics, and signal processing. Here, we review the state-of-the-art in diamond electrodes for neurochemical sensing and discuss potential opportunities for future advancements of the technology. We highlight our team's progress with the development of an all-diamond fiber ultramicroelectrode as a novel approach to advance the performance and applications of diamond-based neurochemical sensors.

Boron-Doped Diamond Electrodes: Recent Developments and Advances in View of Electrochemical Drug Sensors

Conductive boron-doped diamond (BDD), in addition to its superior material properties, offers many important advantages that make it an interesting material for electroanalytical studies. It has been considered as an excellent electrode material for electrooxidation of drug active compounds in their dosage forms or in biological materials due to its good physical and chemical properties. It contains not only the largest solvent working potential window compared to other electrode materials, but also it has low background and capacitive currents; lower problems with passivation and it has the ability to withstand extreme potentials, corrosive, and high temperature/pressure environments. The aim of this review is not only to provide a state-of-the-art of diamond electrochemistry but also to serve as a reference point for any researcher wishing to commence work with diamond electrodes and understand electrochemical data. Therefore, it is focused on the carbon-based materials, electrochemical properties of the BDD film electrode, its fundamental research, and its electrochemical pretreatment process are discussed in detail. In this case, there are important studies to show the effective BDD drug sensors for the detection and determination of drugs and the present review critically summarizes the available data in this field between 2015 and 2020.

Polycrystalline boron-doped diamond-based electrochemical biosensor for simultaneous detection of dopamine and melatonin

In this study, boron-doped diamond (BDD) electrodes with varied B contents are prepared to determine the feasibility of the direct usage of BDD as an electrochemical biosensor without any modification. The electrochemical performance of the electrodes was investigated through the characterization of electrochemical impedance spectroscopy for potassium ferricyanide/potassium ferrocyanide (K₃Fe(CN)₆/K₄Fe(CN)₆) redox couples, as well as through qualitative and quantitative analysis of the two biomolecules dopamine (DA) and melatonin (MLT). The results show that the B content of BDD is the primary parameter for controlling the electrocatalytic current, that is, the response sensitivity. However, the abundant crystal planes and low background current are the key factors in improving the selectivity of the biomarkers to identify multiple analytes. Considering the catalytic current and its ability to distinguish the biomolecules, BDD with a B source carrier gas flow rate of 18 sccm is used as the sensing electrode for the simultaneous detection of DA and MLT. The response peak potential difference reaches 500 mV, and the linear concentration range for the two analytes is 0.4-600 μM, with detection limits of 0.1 μM for DA and 0.003 μM for MLT. These results match those observed for electrochemical sensors modified by various sensitive materials. BDD electrodes show good chemical resistance, good stability, and no pollution and are suitable for long-term usage as biomarker sensors.

Comparison of electrochemical performance of various boron-doped diamond electrodes: Dopamine sensing in biomimicking media used for cell cultivation

Chemically inert and biocompatible boron-doped diamond (BDD) has been successfully used in neuroscience for sensitive neurochemicals sensing and/or as a growth substrate for neurons. In this study, several types of BDD differing in (i) fabrication route, i.e. conventional microwave plasma enhanced chemical vapour deposition (MW-PECVD) reactor vs. MW-PECVD with linear antenna delivery system, (ii) morphology, i.e. planar vs. porous BDD, and (iii) surface treatment, i.e. H-terminated (H-BDDs) vs. O-terminated (O-BDDs), were characterized from a morphological, structural, and electrochemical point of view. Further, planar and porous BDD-based electrodes were tested for sensing of dopamine in common biomimicking environments of pH 7.4, namely phosphate buffer (PB) and HEPES buffered saline (HBS). In HBS, potential windows are narrowed due to electrooxidation of its buffering component (i.e. HEPES), however, dopamine sensing in HBS is possible. H-BDDs (both planar and porous) outperformed O-BDDs as they provided clearer dopamine signals with higher peak currents. As expected, due to its enlarged surface area and increased sp² content, the highest sensitivity and lowest detection limits of 8 × 10^-8 mol L^-1 and 6 × 10^-8 mol L^-1 in PB and HBS media, respectively, were achieved by square-wave voltammetry on porous H-BDD.

Tyrosinase/Chitosan/Reduced Graphene Oxide Modified Screen-Printed Carbon Electrode for Sensitive and Interference-Free Detection of Dopamine

Tyrosinase, chitosan, and reduced graphene oxide (rGO) are sequentially used to modify a screen-printed carbon electrode (SPCE) for the detection of dopamine (DA), without interference from uric acid (UA) or ascorbic acid (AA). The use of tyrosinase significantly improves the detection’s specificity. Cyclic voltammetry (CV) measurements demonstrate the high sensitivity and selectivity of the proposed electrochemical sensors, with detection limits of 22 nM and broad linear ranges of 0.4–8 μM and 40–500 μM. The fabricated tyrosinase/chitosan/rGO/SPCE electrodes achieve satisfactory results when applied to human urine samples, thereby demonstrating their feasibility for analyzing DA in physiological samples.

Self-stacking of exfoliated charged nanosheets of LDHs and graphene as biosensor with real-time tracking of dopamine from live cells

This study introduces a new strategy for periodic stacking of positively charged NiAl layered double hydroxides (LDHs) nanosheets with negatively charged monolayers of graphene (G) by systematically optimizing several parameters in a controlled co-feeding fashion and resultant heterostacked NiAl LDH/G LBL nanocomposites have been practically applied in sensitive detection of dopamine released from live cells as early Parkinson's disease (PD) diagnostic tool. PD is the second most chronic neurodegenerative disorder with gradual progressive loss of movement and muscle control causing substantial disability and threatening the life seriously. Unfortunately majority of dopaminergic neurons present in substantia nigra of PD patients are destroyed before it is being clinically diagnosed, so early stages PD diagnosis is essential. Because of direct neighboring of extremely conductive graphene to semiconductive LDHs layers, enhanced intercalation capability of LDHs, and huge surface area with numerous active sites, good synergy effect is harvested in heteroassembled NiAl LDH/G LBL material, which in turn shows admirable electrocatalytic ability in DA detection. The interference induced by UA and AA is effectively eliminated especially after the modifying the electrode with Nafion. The outstanding electrochemical sensing performance of NiAl LDH/G LBL modified electrode has been achieved in terms of broad linear range and lowest real detection limit of 2 nM (S/N = 3) towards DA oxidation. Benefitting from superior efficiency, biosensor has been successfully used for real-time in-vitro tracking of DA efflux from live human nerve cell after being stimulated. We believe that our biosensing platform of structurally integrated well-ordered LBL heteroassembly by inserting graphene directly to the interlayer galleries of LDHs material will open up new avenue in diseases determination window.