Effect of applied temperature gradient on instability of template-assisted metal electrodeposition

Copper Recovery from Industrial Bimetallic Composite Ionic Liquids by Direct Electrodeposition and the Effect of Temperature and Ultrasound

Critical processing protocols of industrial bimetallic composite ionic liquid (IL) are necessary to assure good mass transfer rates for process optimization and efficient metal recovery. Here, the effects of different conditions on the electrochemical behavior and copper recovery from the industrial bimetallic composite IL are crucial for effective resource utilization. Cyclic voltammetry (CV) shows that the reduction of Cu(I) to Cu(0) during the cathodic reduction region is the irreversible diffusion-controlled process, and the diffusion coefficient increased with temperature which indicated that increasing temperature could promote the diffusion and mass transfer. During electrodeposition, metallic copper is obtained exclusively on the cathode, while CuCl₂ accumulates exclusively on the anode. Scanning electron microscopy shows that the micron-size electrodeposits become larger and significantly rougher with increasing temperature and ultrasonic frequency, illustrating that these factors hasten the nucleation and crystallization rates at high overpotentials. The efficiency of copper recovery is greatly improved by employing high temperature and ultrasonic cavitation, and the highest values correspond to r = 76.9% at 80 °C and r = 63.6% at 40 kHz. The study lays the foundation for efficient and rapid recovery of copper from spent ILs.

Tuning the Optical Properties of Hyperbolic Metamaterials by Controlling the Volume Fraction of Metallic Nanorods

Porous films of anodic aluminum oxide are widely used as templates for the electrochemical preparation of functional nanocomposites containing ordered arrays of anisotropic nanostructures. In these structures, the volume fraction of the inclusion phase, which strongly determines the functional properties of the nanocomposite, is equal to the porosity of the initial template. For the range of systems, the most pronounced effects and the best functional properties are expected when the volume fraction of metal is less than 10%, whereas the porosity of anodic aluminum oxide typically exceeds this value. In the present work, the possibility of the application of anodic aluminum oxide for obtaining hyperbolic metamaterials in the form of nanocomposites with the metal volume fraction smaller than the template porosity is demonstrated for the first time. A decrease in the fraction of the pores accessible for electrodeposition is achieved by controlled blocking of the portion of pores during anodization when the template is formed. The effectiveness of the proposed approach has been shown in the example of obtaining nanocomposites containing Au nanorods arrays. The possibility for the control over the position of the resonance absorption band corresponding to the excitation of collective longitudinal oscillations of the electron gas in the nanorods in a wide range of wavelengths by controlled decreasing of the metal volume fraction, is shown.