The electrochemical performanceand multielectron reaction mechanism of NiV2O6 as anovel anode material for lithium-ion batteries

Pre-lithiation strategy to design a high-performance zinc oxide anode for lithium-ion batteries

Zinc oxide (ZnO) shows great potential as an anode material for advanced energy storage devices owing to its good structural stability and low cost. However, its inferior cycling capacity seriously restricts its practical application. In this work, a pre-lithiation strategy is adopted to construct pre-lithiated ZnO (Li-ZnO) via the facile solid-state reaction method. This well-designed Li-ZnO is polycrystalline, consisting of fine particles. XPS analysis and Raman results confirm the successful pre-lithiation strategy. The pre-lithiation strategy increases the electronic conductivity of Li-ZnO without further carbon coating and suppresses the volume expansion during the electrochemical reaction. As a result, 5 mol% Li-ZnO displays good reversible capacity with a specific capacity of 639 mA h g-1 after 200 cycles at 0.1 A g-1. After 1440 cycles at 1.0 A g-1, the capacity retention is 380 mA h g-1. The pseudocapacitance contribution can reach up to 72.5% at 1.0 mV s-1. Electrochemical kinetic analysis shows that this pre-lithiation strategy can accelerate the lithium-ion diffusion and charge transfer kinetics of the Li-ZnO anode and suppress the pulverization of the electrochemical reaction. This study demonstrates the necessity of developing new anode materials with good cycling stability via this pre-lithiation strategy.

MgMoO4 as an anode material for lithium ion batteries and its multi-electron reaction mechanism

Single-phase magnesium molybdate, MgMoO4, is successfully synthesized by a facile sol-gel method. Attributed to the multielectron reaction and the synergistic effect of the elements molybdenum (Mo) and magnesium (Mg), the...

Synthesis of a full range Fe-doped ZnFexCo2-xO4 and its application as anode material for lithium-ion battery

Fe-Doped ZnFe_xCo_2-xO₄ (x = 0.00, 0.17, 0.33, 0.47, 0.67, 0.87, 1.17, 1.37, 1.67, 1.87, 2.00) compounds were prepared by a sol-gel method. X-ray diffraction measurements show that Fe-doping does not change the crystal structure of ZnCo₂O₄ and dopant Fe successfully occupies the 16c Co site. Because of the bigger radius of the doping ion, the cell parameters and cell volumes of ZnFe_xCo_2-xO₄ compounds present an obvious linear increase with increasing Fe content. In addition, attributed to the similar crystal structures for ZnFe₂O₄ and ZnCo₂O₄, a full range (0 ≤ x ≤ 2) of ZnFe_xCo_2-xO₄ solid solution phases was obtained. V/I measurement results show that a small Fe doping content obviously improved the electronic conductivity of the sample. In addition, due to the smaller particles size and uniform particle distribution caused by Fe doping, the lithium ion diffusion coefficient of the sample was increased by 2 orders of magnitude. Based on the improved electronic conductivity combined with the significantly increased lithium-ion diffusion coefficient, a sample with Fe doping content of x = 0.33, ZnFe_0.33Co_1.67O₄, presents a high reversible specific capacity and excellent rate cycle stability. At a rate of 100 mA g^-1, a relatively high discharge capacity of 850 mA h g^-1 can still be obtained after 100 cycles, which is obviously higher than that of pure ZnCo₂O₄ (only 295 mA h g^-1). Even at a higher discharge rate of 500 mA g^-1, a discharge capacity of 450 mA h g^-1 with a capacity retention of nearly 100% was obtained. Based on its excellent electrochemical properties, ZnFe_0.33Co_1.67O₄ will be a promising anode material for rechargeable lithium-ion batteries.

Facile synthesis of one-dimensional vanadyl acetate nanobelts toward a novel anode for lithium storage

Transition metal oxides (TMOs) are prospective anode materials for lithium-ion batteries (LIBs), owing to their high theoretical specific capacity. However, the inherently low conductivity of TMOs restricts their application. The coupling of lithium-ion conducting polymer ligands with TMO structures is favorable for the dynamics of electrochemical processes. Herein, vanadyl acetate (VA) nanobelts, an organic-inorganic hybrid material, are synthesized for the first time as an anode material for LIBs. As a result, the VA nanobelt electrode displays an outstanding electrochemical performance, including a highly stable reversible specific capacity (around 1065 mA h g^-1 at 200 mA g^-1), superior long-term cyclability (with a capacity of approximately 477 mA h g^-1 at 2 A g^-1 over 500 cycles) and attractive rate capability (1012 mA h g^-1 when the current density recovers to 200 mA g^-1). In addition, scanning electron microscopy (SEM), cyclic voltammetry (CV) curves at different scanning rates and electrochemical impedance spectroscopy (EIS) are used to investigate the variation of the specific capacity and the electrochemical kinetic characteristics of the VA electrode during cycling in detail, respectively. Also, the structural variations of the VA electrode in the initial two cycles are also investigated by in situ XRD testing. The periodic evolution of the in situ XRD patterns demonstrates that the VA nanobelt electrode shows excellent reversibility for Li⁺ ion insertion/extraction. This work offers an enlightening insight into the future research into organo-vanadyl hybrids as advanced anode materials.

Selective detection of glutathione by flower-like NiV2O6 with only peroxidase-like activity at neutral pH

In view of the broad application prospect of peroxidase-like nanozymes in biomedical analysis, it is of great significance to eliminate the interference of their oxidase-like activity and enable them to work under neutral conditions. Herein, flower-like NiV₂O₆ was synthesized and their enzyme-mimicking activity was investigated. Through the regulation of pH, NiV₂O₆ nanozyme showed only peroxidase-like activity but not oxidase-like activity under neutral conditions, which could catalyze the oxidation of colorless 3,3',5,5'-tetramethylbenzidine into its blue product in the presence of H₂O₂. Furthermore, based on the competitive effect of glutathione (GSH) on the catalytic activity of nanozymes, a semi-quantitative/quantitative colorimetric assay was established for GSH detection by using peroxidase-like NiV₂O₆. The assay exhibited a good linear relationship in GSH concentration ranging from 3-100 μmol L^-1, with a detection limit of 0.89 μmol L^-1. Moreover, in the presence of formaldehyde as masking agent, this method showed satisfactory specificity for GSH under the interference of a variety of interfering substances and even biothiols. Concerning the practical application, the system was applied to monitor GSH level in fetal bovine serum, human serum and SiHa cells. Satisfyingly, the obtained results were consistent well with those of Ultra performance liquid chromatography (UPLC) and assay kit, indicating the constructed assay has great potential in clinical application.