Comparison of fluorotelomer alcohol emissions from wastewater treatment plants into atmospheric and aquatic environments

Is it raining PFAS in France? An analysis of 52 PFAS at nanogram per liter levels in French rainwaters during autumn season

Per- and polyfluoroalkyl substances (PFAS) are of increasing concern due to their pervasive nature, high persistence, and their impacts on human health and the environment. Many studies have attempted to assess the presence of PFAS along the water cycle, but few have analyzed rainwater PFAS content and its contribution to water contamination. The present study aims to improve knowledge by providing the first analysis of PFAS rainwater samples from France. A total of 52 PFAS were analyzed at nanogram per liter levels in rainwater samples collected in 14 locations in France using a cutting-edge liquid chromatography-tandem mass spectrometry (LC/MS/MS) method for multiresidue determination. Depending on the quantity of rainwater collected, the PFAS concentrations were analyzed either by direct injection or after solid-phase extraction (SPE), allowing to quantify 20 PFAS with a limit of quantification (LOQ) ≤ 100 ng/L and 52 PFAS with a LOQ ≤ 1 ng/L, respectively. For the five locations for which the collected samples were analyzed by direct injection, no PFAS could be detected (i.e., their concentrations in the samples were below the LOQs of the method). The samples from four locations out of the nine analyzed by SPE-LC/MS/MS show results above the method's LOQs for up to 10 PFAS. Among the quantified PFAS, three compounds (perfluorononanoic acid, perfluoroundecanoic acid, and perfluorohexanoic acid) have been found to be of most significance. These results bring out the presence of PFAS in rainwater samples in France, highlighting the need for PFAS environmental surveillance and risk assessment and the necessity of continuous improvement of existing analysis methods.

Rapid, efficient, and green analytical technique for determination of fluorotelomer alcohol in water by stir bar sorptive extraction

Fluorotelomer alcohols (FTOHs) are one of the major classes of per- and polyfluoroalkyl substances (PFAS). Due to their potential toxicity, persistence, and ubiquitous presence in the environment, some common PFAS are voluntarily phased out; while FTOHs are used as alternatives to conventional PFAS. FTOHs are precursors of perfluorocarboxylic acids (PFCAs) and therefore they are commonly detected in water matrices, which eventually indicate PFAS contamination in drinking water supplies and thus a potential source of human exposure. Even though studies have been conducted nationwide to evaluate the degree of FTOHs in the water environment, robust monitoring is lacking because of the unavailability of simple and sustainable analytical extraction and detection methods. To fill the gap, we developed and validated a simple, rapid, minimal solvent use, no clean-up, and sensitive method for the determination of FTOHs in water by stir bar sorptive extraction (SBSE) coupled with thermal desorption-gas chromatography-mass spectrometry (TD-GC-MS). Three commonly detected FTOHs (6:2 FTOH, 8:2 FTOH, and 10:2 FTOH) were selected as the model compounds. Factors such as extraction time, stirring speed, solvent composition, salt addition, and pH were investigated to achieve optimal extraction efficiency. This "green chemistry" based extraction provided good sensitivity and precision with low method limits of detection ranging from 2.16 ng/L to 16.7 ng/L and with an extraction recovery ranging 55%-111%. The developed method were tested on tap water, brackish water, and wastewater influent and effluent. 6:2 FTOH and 8:2 FTOH were detected in two wastewater samples at 78.0 and 34.8 ng/L, respectively. This optimized SBSE-TD-GC-MS method will be a valuable alternative to investigate FTOHs in water matrices.

pKa prediction of per- and polyfluoroalkyl acids in water using in silico gas phase stretching vibrational frequencies and infrared intensities

To successfully understand and model the environmental fate of per- and polyfluoroalkyl substances (PFAS), it is necessary to know key physicochemical properties (PChPs) such as pKa; however, measured PChPs of PFAS are scarce and of uncertain reliability. In this study, quantitative structure-activity relationships (QSARs) were developed by correlating calculated (M062-X/aug-cc-pVDZ) vibrational frequencies (VF) and corresponding infrared intensities (IRInt) to the pKa of carboxylic acids, sulfonic acids, phosphonic acids, sulfonamides, betaines, and alcohols. Antisymmetric stretching VF of the anionic species were used for all subclasses except for alcohols where the OH stretching VF performed better. The individual QSARs predicted the pKa for each subclass mostly within 0.5 pKa units from the experimental values. The inclusion of IRInt as a pKa predictor for carboxylic acids improved the results by decreasing the root-mean-square error from 0.35 to 0.25 (n > 100). Application of the developed QSARs to estimate the pKa of PFAS within each subclass revealed that the length of the perfluoroalkyl chain has minimal effect on the pKa, consistent with other models but in stark contrast with the limited experimental data available.

Per- and polyfluoroalkyl substances in the atmosphere of waste management infrastructures: Uncovering secondary fluorotelomer alcohols, particle size distribution, and human inhalation exposure

Per- and polyfluoroalkyl substances (PFAS) have been applied in numerous industrial and consumer products, the majority of which flow into waste management infrastructures (WMIs) at the end of their life cycles, but little is known about atmospheric releases of PFAS from these facilities. In this study, we addressed this key issue by investigating 49 PFAS, including 23 ionic and 26 neutral and precursor PFAS, in the potential sources (n = 4; within or adjacent to WMIs) and reference sites (n = 2; coastal and natural reserve sites) in urban and rural areas of Hong Kong, China. Duplicate samples of air and size-segregated particulate matter were collected for 48 h continuously using a 11-stage Micro-Orifice Uniform Deposit Impactor (MOUDI). In general, fluorotelomer alcohols (FTOHs) and perfluoroalkane sulfonamides were the predominant PFAS classes found across sampling sites. We also demonstrated the release of several less frequently observed semivolatile intermediate products (e.g., secondary FTOHs) during waste treatment. Except for perfluorooctane sulfonate, the size-segregated distributions of particulate PFAS exhibited heterogeneity across sampling sites, particularly in the WMIs, implying combined effects of sorption affinity and emission sources. A preliminary daily air emission estimation revealed that landfill was a relatively important source of PFAS relative to the wastewater treatment plant. A simplified International Commission on Radiological Protection model was used to estimate lung depositional fluxes, and the results showed that inhaled particulate PFAS were mainly deposited in the head airway while fine and ultrafine particles carried PFAS deeper into the lung alveoli. The cumulative daily inhalation dose of gaseous and particulate PFAS ranged from 81.9 to 265 pg/kg/d. In-depth research is required to understand the health effect of airborne PFAS on workers at WMIs.

Long-term trends of fluorotelomer alcohols in a wastewater treatment plant impacted by textile manufacturing industry

Fluorotelomer alcohols (FTOHs) are important precursors and substitutes of perfluoroalkyl carboxylic acids (PFCAs). This study investigated the long-term trends of FTOHs in a municipal wastewater treatment plant impacted by textile manufacturing industry (T-WWTP) in Wuxi city from 2013 to 2021. For comparison, four domestic wastewater treatment plants (D-WWTPs) were also selected for the investigation. The total concentrations of FTOHs, which were 9.8-43 ng/L, 5.9-29 ng/L and 10-50 ng/g in influent, secondary effluent, and sludge samples from the T-WWTP, were significantly higher than those of the D-WWTPs (p < 0.01). The significant correlation between decrease of mass loads for FTOHs and the increase for PFCAs was observed, suggesting the potential biotransformation of FTOHs to PFCAs. Concentration variation in FTOH concentrations was observed for the T-WWTP, which was in accord with the variation in annual output of textile products in Wuxi city (p = 0.005). The predominance of 8:2 FTOH in the influents of T-WWTP between 2013 and 2016 switched over to 6:2 FTOH in 2020-2021. This work highlighted the textile manufacturing industry as a significant discharge route for FTOHs to municipal WWTP, as well as the dramatic change in the usage of FTOHs in the textile manufacturing industry in Wuxi.

Per- and Polyfluoroalkyl Substances in Outdoor and Indoor Dust from Mainland China: Contributions of Unknown Precursors and Implications for Human Exposure

Per- and polyfluoroalkyl substances (PFASs) were analyzed in outdoor (n = 101) and indoor dust (n = 43, 38 paired with outdoors) samples across mainland China. From 2013 to 2017, the median concentration of ∑PFASs in outdoor dust tripled from 63 to 164 ng/g with an elevated contribution of trifluoroacetic acid and 6:2 fluorotelomer alcohol. In 2017, the indoor dust levels of ∑PFASs were in the range 185-913 ng/g, which were generally higher than the outdoor dust levels (105-321 ng/g). Emerging PFASs were found at high median levels of 5.7-97 ng/g in both indoor and outdoor dust samples. As first revealed by the total oxidized precursors assay, unknown perfluoroalkyl acid (PFAA)-precursors contributed 37-67 mol % to the PFAS profiles in indoor dust samples. A great proportion of C8 PFAA-precursors were precursors for perfluorooctanesulfonic acid, while C6 and C4 PFAA-precursors were mostly fluorotelomer based. Furthermore, daily perfluorooctanoic acid (PFOA) equivalent intakes of PFAAs (C4-C12) mixtures via indoor dust were first estimated at 1.3-1.5 ng/kg b.w./d for toddlers at high scenarios, which exceeds the derived daily threshold of 0.63 ng/kg b.w./d. from the European Food Safety Authority (EFSA). On this basis, an underestimation of 56%-69% likely remains without considering potential risks due to the biotransformation of unknown PFAA-precursors.

Per and polyfluoroalkyl substances (PFAS) at high concentrations in neonatal Australian pinnipeds

Per and polyfluorinated substances (PFAS) exposure was investigated in Australian pinnipeds. Concentrations of 16 PFAS were measured in the livers of Australian sea lion (Neophoca cinerea), Australian fur seal (Arctocephalus pusillus doriferus) and a long-nosed Fur Seal (Arctocephalus forsteri) pup sampled between 2017 and 2020 from colonies in South Australia and Victoria. Findings reported in this study are the first documented PFAS concentrations in Australian pinnipeds. Median and observed range of values in ng/g wet weight were highest for perfluorooctane sulfonate (PFOS), perfluorooctanoic acid (PFOA) and perfluorononanoic acid (PFNA) in the liver of N. cinerea (PFOS = 7.14, 1.00-16.9; PFOA = 2.73, 0.32-11.2; PFNA = 2.96, 0.61-8.22; n = 28), A. forsteri (PFOS = 15.98, PFOA = 2.02, PFNA = 7.86; n = 1) and A. p. doriferus (PFOS = 27.4, 10.5-2119; PFOA = 0.98, 0.32-52.2; PFNA = 2.50, 0.91-44.2; n = 20). PFAS concentrations in A. p. doriferus pups were significantly greater (p < 0.05) than in N. cinerea pups for all PFAS except PFOA and were of similar magnitude to those reported in northern hemisphere marine animals. These results demonstrate exposure differences in both magnitude and PFAS profiles for N. cinerea in South Australia and A. p. doriferus in Victoria. This study reports detectable PFAS concentrations in Australian pinniped pups indicating the importance of maternal transfer of these toxicants. As N. cinerea are endangered and recent declines in pup production has been reported for A. p. doriferus at the colony sampled, investigation of potential health impacts of these toxicants on Australian pinnipeds is recommended.

A critical review of modeling Poly- and Perfluoroalkyl Substances (PFAS) in the soil-water environment

Due to their health effects and the recalcitrant nature of their CF bonds, Poly- and Perfluoroalkyl Substances (PFAS) are widely investigated for their distribution, remediation, and toxicology in ecosystems. However, very few studies have focused on modeling PFAS in the soil-water environment. In this review, we summarized the recent development in PFAS modeling for various chemical, physical, and biological processes, including sorption, volatilization, degradation, bioaccumulation, and transport. PFAS sorption is kinetic in nature with sorption equilibrium commonly quantified by either a linear, the Freundlich, or the Langmuir isotherms. Volatilization of PFAS depends on carbon chain length and ionization status and has been simulated by a two-layer diffusion process across the air water interface. First-order kinetics is commonly used for physical, chemical, and biological degradation processes. Uptake by plants and other biota can be passive and/or active. As surfactants, PFAS have a tendency to be sorbed or concentrated on air-water or non-aqueous phase liquid (NAPL)-water interfaces, where the same three isotherms for soil sorption are adopted. PFAS transport in the soil-water environment is simulated by solving the convection-dispersion equation (CDE) that is coupled to PFAS sorption, phase transfer, as well as physical, chemical, and biological transformations. As the physicochemical properties and concentration vary greatly among the potentially thousands of PFAS species in the environment, systematic efforts are needed to identify models and model parameters to simulate their fate, transport, and response to remediation techniques. Since many process formulations are empirical in nature, mechanistic approaches are needed to further the understanding of PFAS-soil-water-plant interactions so that the model parameters are less site dependent and more predictive in simulating PFAS remediation efficiency.