Study on stable mass transfer and enrichment of phenol by 1-octanol/kerosene/polyvinyl chloride polymer inclusion membrane

Characterization and Kinetic Studies of Poly(vinylidene fluoride-co-hexafluoropropylene) Polymer Inclusion Membrane for the Malachite Green Extraction

Textile industry effluent contains a high amount of toxic colorants. These dyes are carcinogenic and threats to the environment and living beings. In this study, poly(vinylidene fluoride-co-hexafluoropropylene) (PVDF-co-HFP) was used as the based polymer for PIMs with bis-(2-ethylhexyl) phosphate (B2EHP) and dioctyl phthalate (DOP) as the carrier and plasticizer. The fabricated PIMs were employed to extract the cation dye (Malachite Green; MG) from the feeding phase. PIMs were also characterized by scanning electron microscopy (SEM), atomic force microscope (AFM), contact angle, water uptake, Fourier-transform infrared spectroscopy (FTIR) and ions exchange capacity. The performance of the PIMs was investigated under various conditions such as percentage of carrier and initial dye concentration. With permeability and flux values of 0.1188 cm/min and 1.1913 mg cm/min, PIM produced with 18% w/w PVDF-co-HFP, 21% w/w B2EHP, 1% w/w DOP and 40% w/w THF and was able to achieve more than 97% of MG extraction. The experimental data were then fitted with a pseudo-second-order (PSO) model, and the calculated R2 value was ~0.99. This shows that the data has a good fit with the PSO model. PIM is a potential alternative technology in textile industry effluent treatment; however, the right formulation is crucial for developing a highly efficient membrane.

Electro-membrane extraction of cadmium(II) by bis(2-ethylhexyl) phosphate/kerosene/polyvinyl chloride polymer inclusion membrane

The development of the electroplating and battery industries has increased the environmental problems and the needs for resource recovery of Cd(II). In this study, the Electro-membrane extraction (EME) behaviour of Cd(II) was investigated by using polymer inclusion membrane with bis(2-ethylhexyl) phosphate as carrier and polyvinyl chloride as base polymer(PD-PIM) at 0-80 V. Results showed that the EME of Cd(II) by PD-PIM can be obtained in the feed phase with pH 3-8 and stripping phase of dilute acid. Voltage is the main factor to increase the mass transfer rate of Cd(II). The applied electric field reduced the mass transfer activation energy of Cd(II) by PD-PIM and weakened the mass transfer interference of Cd(II) on the background material of the feed phase. After using kerosene-stabilised PD-PIM for operation at pH5, 60 V for 120 h, Cd(II) in the 1 L solution reduced from 15 mg/L to 0.08 mg/L, and the enrichment factor was 9.79.