Assessment and accumulation of microplastics in sewage sludge at wastewater treatment plants located in Cádiz, Spain

Innovating Ferro-sonication approach for extracting microplastics from wastewater

For accurate and reliable analysis of microplastics (MPs) in wastewater (WW), it is imperative to comprehend the significance of pre-treating WW before analysis. The suspended solids (SS) in the matrix tend to adhere to the MPs during filtration, which interferes with the detection of the MPs. In this regard, the present study aims to develop and optimize a pretreatment method to improve the extraction efficiency of MPs from WW by reducing the SS. A combination of the Fenton reaction and ultrasonication, ferro-sonication (Fe-UlS), was proposed to digest and eliminate the SS from WW. This hybrid pretreatment, Fe-UlS, was optimized for ultrasonication amplitude, treatment time, and hydrogen peroxide dose using response surface methodology (RSM) with a Box-Behnken design, achieving a desirability of 0.984. The optimum conditions for the Fe-UlS, such as the (1:1) Fenton reagent ratio (0.05 M FeSO4: 30 % H2O2), ultrasonication amplitude (31 %), and total process time (30 min) were found to be statistically significant (p < 0.05). The developed method was then employed for the extraction of spiked polyethylene (PE), polypropylene (PP) and polyethylene terephthalate (PET) MPs in real WW and found efficient in removing 83 % of the TSS present in the primary influent were in 30 min at a temperature of 45 °C. Also, the method did not affect the physio-chemical characteristics of the MPs; however, the thermal analysis of PE and PP MPs showed a statistically significant decrease in the melting temperature, as proven by paired t-test analysis. Further, a non-targeted liquid chromatography-mass spectrometry (LC-MS) analysis proved that Fe-UlS is a stable process, as it did not cause any leaching of MPs under the optimum pretreatment conditions. Finally, Laser Direct-Infrared Imaging (LD-IR) analysis was conducted to validate the developed Fe-UlS pretreatment approach for MP analysis in real WW. About 3434 MPs were detected in 100 mL of WW primary influent, within the size range of 9 to 500 μm. This hybrid pretreatment approach not only streamlines WW sample processing but also reduces the required concentration of Fenton reagent and processing time, yielding accurate and reliable results for monitoring MPs in WW.

Occurrence, characteristics, and microbial community of microplastics in anaerobic sludge of wastewater treatment plants

Wastewater treatment plants (WWTPs) usually contain microplastics (MPs) due to daily influents of domestic and municipal wastewater. Thus, the WWTPs act as a point source of MPs distribution in the environment due to their incapability to remove MPs completely. In this study, MPs occurrence and distribution in anaerobic sludge from WWTPs in different regions (Kaifeng "KHP", Jinan "JSP", and Lanzhou "LGP") were studied. Followed by MPs identification by microscopy and Fourier transform infrared (FTIR) spectrum. The microbial communities associated with anaerobic sludge and MPs were also explored. The results showed that MPs concentrations were 16.5, 38.5, and 17.2 particles/g of total solids (TS) and transparent MPs accounted for 49.1%, 58.5%, and 48.3% in KHP, JSP, and LGP samples, respectively. Fibers represented the most common shape of MPs in KHP (49.1%), JSP (56.0%), and LGP (69.0%). The FTIR spectroscopy indicated the predominance of polyethylene polymer in 1-5 mm MPs. The Proteobacteria, Chloroflexi, Actinobacteria, Bacteroidetes, and Planctomycetes were the abundant phyla in all anaerobic sludge. The bacterial genera in KHP and LGP were similar, in which Caldilinea (>23%), Terrimonas (>10%), and Ferruginibacter (>7%) formed the core bacterial genera. While Rhodococcus (15.3%) and Rhodoplanes (10.9%) were dominating in JSP. The archaeal genera Methanosaeta (>69%) and Methanobrevibacter (>10%) were abundant in KHP and LGP sludge. While Methanomethylovorans accounted for 90% of JSP. Acetyltransferase and hydratase were the major bacterial enzymes, while reductase was the key archaeal enzyme in all anaerobic sludge. This study provided the baseline for MPs distribution, characterization, and MPs associated microbes in WWTPs.

Characteristics and removal efficiency of microplastics at secondary wastewater treatment plant in Lithuania

Wastewater treatment plants (WWTPs) are the most significant barrier between anthropogenic microplastics and environmental ecosystems. The distribution and characteristics of microplastics in WWTPs remain uncertain and incompletely understood, particularly in northeastern Europe (Baltic States), where there is a lack of data on microplastic pollution and distribution. This study presents the removal efficiency and variation in characteristics of microplastics in different stages of the secondary WWTP during a 3-month sampling campaign in Lithuania. The abundance, size, shape, color, and chemical composition of microplastics in the wastewater at different treatment stages were thoroughly examined, in a size range from 20 to 1000 μm. On average, 2962 ± 25 particles/L of microplastic enter the studied WWTP. The obtained microplastic removal efficiency was 55.4% ± 3.9%, highlighting the necessity to enhance wastewater treatment strategies focusing on microplastic removal. Fragment-type microplastics smaller than 100 μm were removed from wastewater samples with the highest removal efficiency. Furthermore, our study includes recommendations to improve microplastic removal efficiency and contribute to mitigating microplastic pollution. PRACTITIONER POINTS: A large number of MPs in the size range of 20-1000 μm enter Lithuanian WWTP. Small-sized MPs within a range of 20-50 μm and 50-100 μm were removed with the highest efficiency of 54.07 ± 1.68% and 56.4 ± 2.43%, respectively. The shape and size of MPs have a major impact on the efficiency of their removal. Future research should prioritize the development of economical and energy-efficient systems, specifically designed for the removal of MPs in WWTPs.

Sludge drying and dewatering processes influence the abundance and characteristics of microplastics in wastewater treatment plants

Wastewater treatment plants (WWTPs) have been identified as high-load receptors of microplastics (MPs) from different sources. However, the influence of specific treatment stanges requires further research. The main objective of this research was to evaluate the abundance and chemical characteristics of MPs in the sludge of two major wastewater treatment plants in the Agadir metropolis (Central Atlantic of Morocco). The Aourir plant receives urban influents and the inputs of the M'zar facility were urban and industrial. Samples were collected from the sludge matrices after primary settling, clarifying, dewatering, and drying systems. In addition, the effect of seasonality on MP load was assessed. The results showed that a higher abundance was noticed in raw sludge than in dewatered one in Aourir WWTP, while in M'zar WWTP, a very low decrease is noticed in dried sludge compared to raw sludge. The concentration of MPs in the summer season was significantly higher compared to other seasons for Aourir WWTP, while the winter season was higher for M'zar WWTP. Moreover, the most abundant shapes were fibers and the fraction 100-500 μm was the most preponderant. Eleven polymers were identified by ATR-FTIR, being polyester, polyethylene, polypropylene, and polystyrene the most abundant ones. Scanning Electron Microscopy coupled with Energy Dispersive X-ray revealed the visible degradation and fragmentation of MPs from sewage sludge and their ability to adsorb inorganic elements. It was estimated that between 2.2 × 107 and 7.4 × 108 MPs were evacuated with the sludge per day. The obtained findings confirmed that WWTP sludge acts as a vector of MPs with a high level of hazard to various matrices, such as landfills, agricultural soils, and groundwater. Overall, consideration must be given to the regulatory system managing the fate of sewage sludge to mitigate the collateral effects and provide solutions.

Potential transmission of SARS-CoV-2 through microplastics in sewage: A wastewater-based epidemiological review

In light of the current COVID-19 pandemic caused by the virus SARS-CoV-2, there is an urgent need to identify and investigate the various pathways of transmission. In addition to contact and aerosol transmission of the virus, this review investigated the possibility of its transmission via microplastics found in sewage. Wastewater-based epidemiological studies on the virus have confirmed its presence and persistence in both influent sewage as well as treated ones. The hypothesis behind the study is that the huge amount of microplastics, especially Polyvinyl Chloride and Polyethylene particles released into the open waters from sewage can become a good substrate and vector for microbes, especially Polyvinyl Chloride and Polyethylene particles, imparting stability to microbes and aiding the "plastisphere" formation. A bibliometric analysis highlights the negligence of research toward plastispheres and their presence in sewage. The ubiquity of microplastics and their release along with the virus into the open waters increases the risk of viral plastispheres. These plastispheres may be ingested by aquatic organisms facilitating reverse zoonosis and the commercial organisms already reported with accumulating microplastics through the food chain poses a risk to human populations as well. Reliance of high population density areas on open waters served by untreated sewage in economically less developed countries might bring back viral transmission.

Degradation mechanism of microplastics and potential risks during sewage sludge co-composting: A comprehensive review

Microplastics (MPs) as a kind of emerging contaminants, widely exists in various kinds of medium, sewage sludge (SS) is no exception. In the sewage treatment process, a large number of microplastics will be deposited in SS. More seriously, microplastics in sewage sludge can migrate to other environmental media and threaten human health. Therefore, it is necessary to remove MPs from SS. Among the various restorations, aerobic composting is emerging as a green microplastic removal method. There are more and more reports of using aerobic compost to degrade microplastics. However, there are few reports on the degradation mechanism of MPs in aerobic composting, hindering the innovation of aerobic composting methods. Therefore, in this paper, the degradation mechanism of MPs in SS is discussed based on the environmental factors such as physical, chemical and biological factors in the composting process. In addition, this paper expounds the MPs in potential hazards, and combined with the problems in the present study were studied the outlook.

Plastics and Micro/Nano-Plastics (MNPs) in the Environment: Occurrence, Impact, and Toxicity

Plastics, due to their varied properties, find use in different sectors such as agriculture, packaging, pharmaceuticals, textiles, and construction, to mention a few. Excessive use of plastics results in a lot of plastic waste buildup. Poorly managed plastic waste (as shown by heaps of plastic waste on dumpsites, in free spaces, along roads, and in marine systems) and the plastic in landfills, are just a fraction of the plastic waste in the environment. A complete picture should include the micro and nano-plastics (MNPs) in the hydrosphere, biosphere, lithosphere, and atmosphere, as the current extreme weather conditions (which are effects of climate change), wear and tear, and other factors promote MNP formation. MNPs pose a threat to the environment more than their pristine counterparts. This review highlights the entry and occurrence of primary and secondary MNPs in the soil, water and air, together with their aging. Furthermore, the uptake and internalization, by plants, animals, and humans are discussed, together with their toxicity effects. Finally, the future perspective and conclusion are given. The material utilized in this work was acquired from published articles and the internet using keywords such as plastic waste, degradation, microplastic, aging, internalization, and toxicity.