Enhanced bioaromatics synthesis via catalytic co-pyrolysis of cellulose and spent coffee ground over microporous HZSM-5 and HY

Improving the Conversion of Biomass in Catalytic Pyrolysis via Intensification of Biomass—Catalyst Contact by Co-Pressing

Biomass pyrolysis is a promising technology for fuel and chemical production from an abundant renewable source. It takes place usually in two stages; non-catalytic pyrolysis with further catalytic upgrading of the formed pyrolysis oil. The direct catalytic pyrolysis of biomass reduces the pyrolysis temperature, increase the yield to target products and improves their quality. However, in such one-stage process the contact between biomass and solid catalyst particles is poor leading to an excessively high degree of pure thermal pyrolysis reactions. The aim of this study was to enhance the catalyst-biomass contact via co-pressing of biomass and catalyst particles as a pre-treatment method. Catalytic pyrolysis of biomass components with HY and USY zeolites was studied using thermogravimetric analysis (TGA), as well as experiments in a pyrolysis reactor. The liquid and coke yields were characterized using gas chromatography, and TGA respectively. The TGA results showed that the degradation of the co-pressed cellulose occurred at lower temperatures compared to the pure thermal degradation, as well as catalytic degradation of non-pretreated cellulose. All biomass components produced better results using the co-pressing method, where the liquid yields increased while coke/char yields decreased. Bio-oil from catalytic pyrolysis of cellulose with HY catalyst mainly produced heavier fractions, while in the presence of USY catalyst medium fraction was mainly produced within the gasoline range. For hemicellulose catalytic pyrolysis, the catalysts had similar effects in enhancing the lighter fraction, but specifically, HY showed higher selectivity to middle fraction while USY has produced higher percentage of lighter fraction. Using with both catalysts, co-pressing had the best effect of eliminating the heavier fraction and improving the gasoline range fraction. Spent catalyst from co-pressed sample had lower concentrations of coke/char components due to the shorter residence times of volatiles, which suppresses the occurrence of secondary reactions leading to coke/char formations.

One-pot conversion of alginic acid into furfural using Amberlyst-15 as a solid acid catalyst in γ-butyrolactone/water co-solvent system

One-pot conversion of alginic acid, which was derived from brown algae, to furfural was investigated using various solid acid catalysts. Among the solid acid catalysts tested, Amberlyst-15 showed the highest activity in furfural production in aqueous media. When the effect of reaction media was examined by applying various organic solvent mixtures, it was found that γ-butyrolactone/water co-solvent system was selected as the most appropriate system for the reaction. Maximum furfural yield of 32.2% was obtained using Amberlyst-15 in the γ-butyrolactone/H₂O at 210 °C for 20 min. Catalyst showed gradual deactivation behavior as the reaction proceeded, although the catalyst recovered its activity upon the simple treatment with sulfuric acid. N₂ adsorption-desorption experiments, Fourier-transform infrared spectroscopy (FT-IR), back titration, and CHNS analysis were applied to investigate the physicochemical property of post-reaction samples, confirming that the leaching of the active sulfonic acid group and decrease in acid density was the major cause of deactivation.