An efficient removal approach for degradation of metformin from aqueous solutions with sulfate radicals

Co-occurrence, toxicity, and biotransformation pathways of metformin and its intermediate product guanylurea: Current state and future prospects for enhanced biodegradation strategy

Accumulation of metformin and its biotransformation product "guanylurea" are posing an increasing concern due to their low biodegradability under natural attenuated conditions. Therefore, in this study, we reviewed the unavoidable function of metformin in human body and the route of its release in different water ecosystems. In addition, metformin and its biotransformation product guanylurea in aquatic environments caused certain toxic effects on aquatic organisms which include neurotoxicity, endocrine disruption, production of ROS, and acetylcholinesterase disturbance in aquatic organisms. Moreover, microorganisms are the first to expose and deal with the release of these contaminants, therefore, the mechanisms of biodegradation pathways of metformin and guanylurea under aerobic and anaerobic environments were studied. It has been reported that certain microbes, such as Aminobacter sp. and Pseudomonas putida can carry potential enzymatic pathways to degrade the dead-end product "guanylurea", and hence guanylurea is no longer the dead-end product of metformin. However, these microbes can easily be affected by certain geochemical cycles, therefore, we proposed certain strategies that can be helpful in the enhanced biodegradation of metformin and its biotransformation product guanylurea. A better understanding of the biodegradation potential is imperative to improve the use of these approaches for the sustainable and cost-effective remediation of the emerging contaminants of concern, metformin and guanylurea in the near future.

A combined experimental and computational approach to unravel degradation mechanisms in electrochemical wastewater treatment

Electrochemical wastewater treatment is a promising technique to remove recalcitrant pollutants from wastewater. However, the complexity of elucidating the underlying degradation mechanisms hinders its optimisation not only from a techno-economic perspective, as it is desirable to maximise removal efficiencies at low energy and chemical requirements, but also in environmental terms, as the generation of toxic by-products is an ongoing challenge. In this work, we propose a novel combined experimental and computational approach to (i) estimate the contribution of radical and non-radical mechanisms as well as their synergistic effects during electrochemical oxidation and (ii) identify the optimal conditions that promote specific degradation pathways. As a case study, the distribution of the degradation mechanisms involved in the removal of benzoic acid (BA) via boron-doped diamond (BDD) anodes was elucidated and analysed as a function of several operating parameters, i.e., the initial sulfate and nitrate content of the wastewater and the current applied. Subsequently, a multivariate optimisation study was conducted, where the influence of the electrode nature was investigated for two commercial BDD electrodes and a customised silver-decorated BDD electrode. Optimal conditions were identified for each degradation mechanism as well as for the overall BA degradation rate constant. BDD selection was found to be the most influential factor favouring any mechanism (i.e., 52-85% contribution), given that properties such as its boron doping and the presence of electrodeposited silver could dramatically affect the reactions taking place. In particular, decorating the BDD surface with silver microparticles significantly enhanced BA degradation via sulfate radicals, whereas direct oxidation, reactive oxygen species and radical synergistic effects were promoted when using a commercial BDD material with higher boron content and on a silicon substrate. Consequently, by simplifying the identification and quantification of underlying mechanisms, our approach facilitates the elucidation of the most suitable degradation route for a given electrochemical wastewater treatment together with its optimal operating conditions.

Study on triphase of polymorphs TiO2 (anatase/rutile/brookite) for boosting photocatalytic activity of metformin degradation

The elution of pharmaceutical products such as metformin at higher concentrations than the safe level in aquatic systems is a serious threat to human health and the ecosystem. Photocatalytic technology using TiO2 semiconductors potentially fixes this problem. This study aims to synthesize triphasic anatase-rutile-brookite TiO2 using ultrasound assisted sol-gel technique in the presence of acid and its application to photodegradation of metformin under UV light irradiation. Based on X-ray diffraction analysis, a TiO2 sample consisted of anatase (76%), rutile (7%), and brookite (17%) polymorph (A76R7B17) that was fully crystallized. Scanning electron microscopy (EM)-energy dispersive X-ray spectra results showed agglomerated triphasic A76R7B17 with irregular spherical clusters. Transmission EM results revealed that the crystal size of A76R7B17 was 4-14 nm. The Brunauer-Emmett-Teller analysis showed the sample's specific surface area of 149 m2 g-1. The degradation test of metformin demonstrated that the A76R7B17 exhibited a 75.4% degradation efficiency after 120 min under UV light irradiation, significantly higher than using biphasic and single-phase TiO2 photocatalysts. This difference could be attributed to the heterojunction effect of triphasic materials that effectively reduced electron-hole recombination rate as well as the combination of effective electron transfer from conduction band of brookite and anatase and the utilization of wider range of UV-visible light using rutile.

Next-generation hybrid technologies for the treatment of pharmaceutical industry effluents

Water and industries are intangible units of the globe that are always set to meet the population's demand. The global population depends on one-third of freshwater increasing the demand. The increase in population along with urbanization has polluted the fresh water resources. The pharmaceutical industry is marked as an emerging contaminant of water pollution. The most common type of pharmaceutical drugs that are detected in the environment includes antibiotics, analgesics, NSAIDs, and pain-relieving drugs. These drugs alter the food chain of the organisms causing chaos mainly in the marine ecosystem. Pharmaceutical drugs are found only in shallow amounts (ng/mg) they have a huge impact on the living system. The consumption of water contaminated with pharmaceutical ingredients can disrupt reproduction, hormonal imbalance, cancer, and respiratory problems. Various methods are used to remove these chemicals from the environment. In this review, we mainly focused on the emerging hybrid technologies and their significance in the effective treatment of pharmaceutical wastewater. This review paper primarily elaborates on the merits and demerits of existing conventional technologies helpful in developing integrated technologies for the modern era of pharmaceutical effluent treatment. This review paper further in detail discusses the various strategies of eco-friendly bioremediation techniques namely biostimulation, bioaugmentation, bacterial degradation, mycoremediation, phytoremediation, and others for the ultimate removal of pharmaceutical contaminants in wastewater. The review makes clear that targeted and hybrid solutions are what the world will require in the future to get rid of these pharmacological prints.

Improvement of ferrioxalate assisted Fenton and photo-Fenton processes for paracetamol degradation by hydrogen peroxide dosage

This work aimed to investigate the impact of hydrogen peroxide (HP) punctual dosage on paracetamol (PCT) degradation, through Fenton and photo-Fenton processes under near-neutral pH conditions, using ferrioxalate and artificial sunlight. The assays were performed using a D-optimal experimental design, to statistically evaluate the influence of radiation (ON or OFF), HP concentration (94.5-756 mg L-1), and HP dosage (YES or NO), on PCT conversion. The optimal conditions determined from the study were: HP = 378 mg L-1, DOS = YES, and RAD = ON, achieving a predicted PCT conversion of 99.68% in 180 min. This result obtained from the model was very close to the experimental one (98.80%). It was verified that HP dosage positively influenced the iron catalytic cycle since higher Fe2+ concentrations were reached at shorter reaction times, accelerating not only PCT conversion but also its by-products hydroquinone and 1,4-benzoquinone, leading to better performances of Fenton and photo-Fenton reactions. Under optimal conditions and employing real water matrices (an artificial matrix with inorganic anions, a real groundwater sample, and a synthetic industrial wastewater), HP dosage demonstrated the ability to mitigate the negative effects caused by the content of different ions and other organic compounds and significantly improve HP consumption in challenging wastewater conditions.

Deep Eutectic Solvent-Assisted Synthesis of a Strontium Tungstate Bifunctional Catalyst: Investigation on the Electrocatalytic Determination and Photocatalytic Degradation of Acetaminophen and Metformin Drugs

In this work, we propose a modified solid-state approach for the sustainable preparation of a SrWO₄ bifunctional catalyst using thymol-menthol-based natural deep eutectic green solvents (NADESs). Various spectroscopic and morphological techniques analyzed the as-synthesized SrWO₄ particles. Acetaminophen (ATP) and metformin (MTF) were selected as the model drug compounds. The electrochemical detection and photocatalytic degradation of ATP and MTF upon ultraviolet-visible (UV-vis) light irradiation in the presence of as-prepared SrWO₄ particles as an active catalyst are examined. The present study displayed that the proposed catalyst SrWO₄ has enhanced catalytic activity in achieving the optimum experimental conditions, and linear ranges of ATP = 0.01-25.90 μM and MTF = 0.01-25.90 μM, a lower limit of detection (LOD) value (ATP = 0.0031 μM and MTF = 0.008 μM), and higher sensitivity toward ATP and MTF determination were obtained. Similarly, the rate constant was found to be k = ATP = 0.0082 min^-1 and MTF = 0.0296 min^-1 according to the Langmuir-Hinshelwood model, benefitting from the excellent synergistic impact of the SrWO₄ catalyst toward the photocatalytic degradation of the drug molecule. Hence, this work offers innovative insights into the applicability of the as-prepared SrWO₄ bifunctional catalyst as an excellent functional material for the remediation of emerging pollutants in water bodies with a recovery range of 98.2-99.75%.