The diverse effect of antiplasticizer in the molecular dynamics of an organic dye-doped polymer observed at different motional lengthscales

The influence of additives on polymer matrix mobility and the glass transition

In the region near an interface, the microscopic properties of a glass forming liquid may be perturbed from their equilibrium bulk values. In this work, we probe how the interfacial effects of additive particles dispersed in a matrix can influence the local mobility of the material and its glass transition temperature, Tg. Experimental measurements and simulation results indicate that additives, such as nanoparticles, gas molecules, and oligomers, can shift the mobility and Tg of a surrounding polymer matrix (even for relatively small concentrations of additive; e.g., 5-10% by volume) relative to the pure bulk matrix, thus leading to Tg enhancement or suppression. Additives thus provide a potential route for modifying the properties of a polymer material without significantly changing its chemical composition. Here we apply the Limited Mobility (LM) model to simulate a matrix containing additive species. We show that both additive concentration, as well as the strength of its very local influence on the surrounding matrix material, will determine whether the Tg of the system is raised or lowered, relative to the pure matrix. We demonstrate that incorporation of additives into the simple LM simulation method, which has successfully described the behavior of bulk and thin film glassy solids, leads to direct connections with available experimental and simulation results for a broad range of polymer/additive systems.

Electronic energy migration on different time scales: concentration dependence of the time-resolved anisotropy and fluorescence quenching of Lumogen Red in poly(methyl methacrylate)

Electronic energy transfer plays an important role in many types of organic electronic devices. Forster-type theories of exciton diffusion provide a way to calculate diffusion constants and lengths, but their applicability to amorphous polymer systems must be evaluated. In this paper, the perylenediimide dye Lumogen Red in a poly(methyl methacrylate) host matrix is used to test theories of exciton motion over Lumogen Red concentrations (C(LR)'s) ranging from 1 x 10(-4) to 5 x 10(-2) M. Two experimental quantities are measured. First, time-resolved anisotropy decays in films containing only Lumogen Red provide an estimate of the initial energy transfer rate from the photoexcited molecule. Second, the Lumogen Red lifetime decays in mixed systems where the dyes Malachite Green and Rhodamine 700 act as energy acceptors are measured to estimate the diffusive quenching of the exciton. From the anisotropy measurements, it is found that theory accurately predicts both the C(LR)(-2) concentration dependence of the polarization decay time tau(pol), as well as its magnitude to within 30%. The theory also predicts that the diffusive quenching rate is proportional to C(LR)(alpha), where alpha ranges between 1.00 and 1.33. Experimentally, it is found that alpha = 1.1 +/- 0.2 when Malachite Green is used as an acceptor, and alpha = 1.2 +/- 0.2 when Rhodamine 700 is the acceptor. On the basis of the theory that correctly describes the anisotropy data, the exciton diffusion constant is projected to be 4-9 nm(2)/ns. By use of several different analysis methods for the quenching data, the experimental diffusion constant is found to be in the range of 0.32-1.20 nm(2)/ns. Thus the theory successfully describes the early time anisotropy data but fails to quantitatively describe the quenching experiments which are sensitive to motion on longer time scales. The data are consistent with the idea that orientational and energetic disorder leads to a time-dependent exciton migration rate, suggesting that simple diffusion models cannot accurately describe exciton motion within this system.