Fabrication of antifouling polypropylene hollow fiber membrane breaking through the selectivity-permeability trade-off

Improving selectivity and antifouling properties of a PES hollow fibre membrane with a photo-enzyme for the removal of ciprofloxacin and sulfamethoxazole

A multifunctional hollow fibre was prepared by the modification of polyethersulfone (PES) with laccase (Lac) and phosphorus-doped graphitic carbon nitride (P-gC3N4) for the removal of ciprofloxacin and sulfamethoxazole. The properties and structure elucidation of the prepared membranes were evaluated using contact angle analysis, Fourier transform infrared spectroscopy (FTIR), scanning electron microscopy (SEM), correlative light electron microscopy (CLEM), atomic force microscopy (AFM), tensile strength, water-intake capacity, and pure water flux. The modified multifunctional hollow fibre membranes showed increased root mean square surface roughness from 50 nm for neat PES to 104 nm, which contributed to the significantly higher water flux of 90 L.m-2h-1 compared to 54 L.m-2h-1 for pristine PES. The hydrophilicity also improved after modification as the contact angle reduced from 72° ± 1.01° to 42° ± 2.26°. The modified hollow fibre membranes showed an enhanced removal of ciprofloxacin (77%) and sulfamethoxazole (80%). Moreover, antifouling properties towards bovine serum albumin were 89% for FRR, 7% for Rr, 9% for Rir and 17% for Rt. Regeneration studies showed that the multifunctional hollow fibre membrane obtained a high removal percentage of 79% towards sulfamethoxazole after five cycles. Hence, this work proposes a new system that can be successfully utilized in the treatment of emerging pharmaceutical pollutants in water.

Polypropylene Hollow-Fiber Membrane Made Using the Dissolution-Induced Pores Method

The efficient preparation of hydrophilic polypropylene membranes has always been a problem. Here, a twin-screw extruder was used to melt-blend ethylene-vinyl alcohol copolymer and polypropylene; then, hollow fibers were extrusion-molded with a spinneret and taken by a winder; after this, dimethyl sulfoxide was used to dissolve the ethylene-vinyl alcohol copolymer of the fiber to obtain a polypropylene hollow-fiber membrane. This procedure was used to study the effects of different contents and segment structure of ethylene-vinyl alcohol copolymer on the structure and filtration performance of the membranes; furthermore, the embedded factor and blocked factor were used to evaluate the ethylene-vinyl alcohol copolymer embedded in the matrix without dissolving and or being completely blocked in the matrix, respectively. The results show that the increase in ethylene-vinyl alcohol copolymer could reduce the embedded factor and increase the blocked factor. The increase in the polyethylene segments of ethylene-vinyl alcohol copolymer could increase both the embedded factor and blocked factor. The water permeation of the membrane reached 1300 Lm⁻²·h⁻¹·bar⁻¹ with a 100% rejection of ink (141 nm) and the elongation at break reached 188%, while the strength reached 22 MPa. The dissolution-induced pores method provides a completely viable alternative route for the preparation of polypropylene membranes.