Mechanical, thermal, and morphological properties of natural rubber/45S5 Bioglass® fibrous mat with ribbon-like morphology produced by solution blow spinning

Solution blow spinning of PLLA/hydroxyapatite composite scaffolds for bone tissue engineering

Composite poly-L-lactide acid-based scaffolds with hydroxyapatite (HAp) content up to 75 wt.% were fabricated via solution blow spinning. The influence of HAp concentration on structure, wettability, mechanical properties and chemical and phase composition of the produced materials was examined. It was found that with an increase of HAp content the average fiber diameter was increased, the uniaxial strength and relative elongation were reduced, while the phase composition and surface wettability did not change. The performance of the scaffolds during implantation in the parietal bone of a rat skull for a period from 15 to 90 days was studied. The materials have shown high ability to integrate with both soft and hard tissues. It was found that scaffolds with 25 wt.% HAp content significantly enhance osteogenesis during scarification (damage) of the periosteum. Overall, the fabricated scaffolds proved to be highly efficient for replacing bone defects in long tubular bones.

Pulsed Laser Deposition Derived Bioactive Glass-Ceramic Coatings for Enhancing the Biocompatibility of Scaffolding Materials

The purpose of this work was to propose and evaluate a new composition for a bioactive glass-ceramic starting from the well-known 45S5 commercial product. Thus, we developed a modified version, including MgO, an oxide that turned out to induce superior mechanical properties and improved biological response. This had the following molar percentages: 46.1% SiO₂, 2.6% P₂O₅, 16.9% CaO, 10.0% MgO, and 24.4% Na₂O. The precursor alkoxides and nitrates were processed by a standard sol-gel technique, resulting in a glass-ceramic target, suitable for laser ablation experiments. Combeite (Na₂Ca₂Si₃O₉) was identified as a main crystalline phase within the calcined sol-gel powder, as well as in the case of the target sintered at 900 °C. The thin films were deposited on silicon substrates, at room temperature or 300 °C, being subsequently characterized from the material point of view, as well as in terms of bioactivity in simulated conditions and biocompatibility in relation to human fibroblast BJ cells. The investigations revealed the deposition of nanostructured glassy layers with a low proportion of crystalline domains; it was shown that a higher substrate temperature promoted the formation of surfaces with less irregularities, as a consequence of material arrangement into a shell with better morphological homogeneity. The complex elemental composition of the target was successfully transferred to the coatings, which ensured pronounced mineralization and a stimulating environment for the cell cultures. Thereby, both samples were covered with a thick layer of apatite after immersion in simulated body fluid for 28 days, and the one processed at room temperature was qualified to be the best in relation to the cells.