2,2'-Bipyridine as a new and sensitive spectrophotometric reagent for the determination of nanoamounts of certain dibenzazepine class of tricyclic antidepressant drugs

Development of Visible Spectrophotometric Methods for the Determination of Tricyclic Antidepressants Based on Formation of Molecular Complexes with p-Benzoquinones

Tricyclic antidepressants are commonly employed in the management of major depressive disorders. The present work describes two visible (VIS) spectrophotometric techniques that utilize the formation of charge transfer complexes between four antidepressant compounds, namely, amitriptyline hydrochloride (AMI), imipramine hydrochloride (IMI), clomipramine hydrochloride (CLO), and trimipramine maleate (TRI) acting as electron donors and two p-benzoquinones, namely, p-chloranilic acid (pCA) and 2,3-dichloro-5,6-dicyano-1,4-benzoquinone (DDQ), serving as electron acceptors. The stoichiometry of the compounds produced exhibited a consistent 1:1 ratio in all instances, as established by Job's method. Molar absorptivities, equilibrium association constants, and several other spectroscopic properties were determined for all complexes. The developed spectrophotometric techniques were validated intra-laboratory and successfully applied for quantitative assessment of the four antidepressant active ingredients in several commercial pharmaceutical formulations. The methods are relatively simple, fast, and use readily available laboratory instrumentation, making them easily applicable by most quality control laboratories worldwide.

Liquid three-phase microextraction based on hollow fiber for highly selective and sensitive determination of using an ion selective electrode

In this paper, for the first time, a combination of hollow fiber based liquid 3-phase microextraction with a potentiometric method was applied as a highly selective and sensitive method of analysis. Desipramine, as a model compound, was extracted from a small volume in the presence of 0.10 mol L-1 NaOH (donor solution) through a thin phase of propyl benzoate inside the pores of a polypropylene hollow fiber and finally into a 10 μL acidic acceptor solution inside the hollow fiber. Two microelectrodes were designed and inserted into the two ends of a hollow fiber inside the acceptor solution. Potentiometric analysis was performed in situ within an extraction time of 15 min; the final stable signal was used for analytical application. Under the optimized conditions, an enrichment factor of 296 was achieved and the relative standard deviation (RSD%) of the method was 4.5%. The calibration curve was obtained in the range of 3.0 × 10-5 to 3.4 × 10-8 mol L-1 with a reasonable linearity (R2 > 0.9849) and a limit of detection (LOD) of 3.1 × 10-8 mol L-1. Finally, the applicability of the proposed method was evaluated by extraction and determination of desipramine in plasma and urine samples without any special pretreatment.

Spectrophotometric determination of etodolac in pure form and pharmaceutical formulations

BACKGROUND

Etodolac (ETD) is a non-steroidal anti-inflamatory antirheumatic drug. A survey of the literature reveals that there is no method available for the determination of ETD in pure form and pharmaceutical formulations by oxidation-reduction reactions.

RESULTS

We describe three simple, sensitive and reproducible spectrophotometric assays (A-C) for the determination of etodolac in pure form and in pharmaceutical formulations. Methods A and B are based on the oxidation of etodolac by Fe3+ in the presence of o-phenanthroline (o-phen) or bipyridyl (bipy). The formation of the tris-complex on reaction with Fe3+-o-phen and/or Fe3+-bipy mixtures in acetate buffer solution at optimum pH was demonstrated at 510 and 520 nm with o-phen and bipy. Method C is based on the oxidation of etodolac by Fe3+ in acidic medium, and the subsequent interaction of iron(II) with ferricyanide to form Prussian blue, with the product exhibiting an absorption maximum at 726 nm. The concentration ranges are 0.5-8, 1.0-10 and 2-18 microg mL(-1) respectively for methods A, B and C. For more accurate analysis, Ringbom optimum concentration ranges were calculated, in addition to molar absorptivity, Sandell sensitivity, detection and quantification limits.

CONCLUSION

Our methods were successfully applied to the determination of etodolac in bulk and pharmaceutical formulations without any interference from common excipients. The relative standard deviations were Collapse

Key Words Collapse

MESH Headings Collapse

Grants Collapse

Affiliation(s)

Ayman A Gouda Chemistry Department, Faculty of Science, Zagazig University, Zagazig, Egypt
Wafaa S Hassan Department of analytical Chemistry, Faculty of Pharmacy, Zagazig University, Zagazig, Egypt

Collapse

Individual and simultaneous determinations of phenothiazine drugs using PCR, PLS and (OSC)-PLS multivariate calibration methods

Individual and simultaneous determinations of some phenothiazine drugs are described. The individual determination method is based on the reaction of chlorpromazine hydrochloride (CPH), promethazine hydrochloride (PH), trifluoperazine hydrochloride (TFPH), trimipramine maleate (TPM) and thioridazine hydrochloride (TRDH) with complex of [Fe(Bpy)3]3+. In the presence of phenothiazine derivatives, [Fe(Bpy)3]3+ is reduced easily to the colored complex [Fe(Bpy)3]2+, which shows an absorption maximum at 525 nm. The individual method is highly sensitive and suitable for 0.3-190 ?g ml-1 concentrations, with detection limits in the range 0.18-2.46 ?g ml-1. Simultaneous kinetic-spectrophotometric determination of ternary mixture of CPH, PH and TPM using principal component regression (PCR), partial least squares (PLS) and orthogonal signal correction (OSC)-PLS multivariate calibration methods is also described. The simultaneous methods are based on the difference observed in the reduction rate of the [Fe(Bpy)3]3+ complex with CPH, PH and TPM in acidic media. The results showed that the simultaneous determination of CPH, PH and TPM can be performed in the concentration ranges of 0.5-120.0, 0.3-80.0 and 5.0-100.0 ?g ml-1, respectively, for three methods (PCR, PLS and OSC-PLS). The root mean square errors of prediction (RMSEP) of CPH, PH and TPM were 0.346, 0.663 and 0.820 (for PCR) 0.317, 0.659 and 0.830 (for PLS) and 0.087, 0.124 and 0.085 (for OSC-PLS), respectively. The proposed methods were successfully applied to the individual and simultaneous determination of phenothiazine derivatives in pharmaceutical preparations, the results of which compared well with those obtained by the official method, and several synthetic (spiked) samples, whereby satisfactory results were obtained.

Fast urinary screening for imipramine and desipramine using on-line solid-phase extraction and selective derivatization

A continuous-flow configuration based on sequential solid-phase extraction and derivatization is proposed for the screening of urine samples for imipramine and related metabolites. For the first time, a 50/50 (v/v) methanol/nitric acid mixture is used as both eluent and derivatizing reagent. Sample aliquots are injected into the flow manifold and driven by a water stream to an RP-C(18) column where the drugs are quantitatively retained. Following clean-up step with 40/60 (v/v) methanol/water, the eluent/derivatizing reagent is injected and passed through the sorbent column, eluted drugs reacting with nitric acid to form a blue dye that is monitored at 600 nm. The global signal thus obtained for the antidepressants can be used to estimate their total concentration in the samples without the need to individually quantify the analytes. This total index can be used for timely decision-making in case of overdosage. The proposed method is sensitive and selective; thus, typical interferents such as endogenous and diet compounds have no substantial effect on the analytical signal. This allows imipramine and its metabolites to be determined at therapeutic levels in urine samples.