Dual plating with bone block arthrodesis of the first metatarsophalangeal joint: A clinical retrospective review

Arthrodesis for Hallux Rigidus

First metatarsophalangeal (MTP) joint fusion, or arthrodesis, has been a cornerstone treatment for advanced joint degeneration since the 1950s, benefiting not only older patients but also younger individuals. The procedure boasts favorable long-term outcomes and a low rate of revision when fusion is successful. However, complications such as interphalangeal arthritis may occur, and nonunion or malunion can necessitate revision. While the first MTP fusion provides significant relief, its applicability varies, underscoring the need for careful patient selection.

Primary Isolated Arthrodesis of the First Metatarsophalangeal Joint for Hallux Rigidus: Clinical, Radiologic, and Pedobarographic Evaluation

Background

Arthrodesis of the first metatarsophalangeal joint is an effective treatment of advanced hallux rigidus. Numerous options have been described for performing this intervention. The aim of this study was to evaluate the outcomes following a consistent surgical technique of joint preparation with hand tools and fixation with 2 crossed screws and a dorsal compression plate.

Methods

Thirteen patients (16 feet) who underwent primary isolated arthrodesis of the first metatarsophalangeal joint between March 2019 and June 2021 were available for clinical, radiologic, and pedobarographic evaluation at a minimum of 12 months after surgery. American Orthopaedic Foot & Ankle Society scores, numerical pain rating scale, the radiologic hallux valgus and intermetatarsal 1-2 angles as well as the distribution of plantar pressure during gait were compared between the pre- and postoperative conditions.

Results

After an average follow-up period of 26 months, union was achieved in all cases and the mean AOFAS score raised significantly by 39 points. All the patients were satisfied with the result. Only 1 patient complained of mild residual pain at walk. Hardware removal was performed in 2 cases. The mean hallux valgus angle dropped from 12.3 to 6.3 degrees. The mean postoperative dorsiflexion angle was 21.6 degrees. After the procedure, peak pressure was significantly higher beneath the first metatarsal head and heel, whereas pressure-time integral was significantly lower beneath the hallux and medial lesser toes.

Conclusion

Arthrodesis of the first metatarsophalangeal joint with 2 crossed screws and a dorsal compression plate is a safe and effective treatment of advanced hallux rigidus. This procedure provides adequate pain relief and functional improvement of gait.

Level of Evidence

Level IV, therapeutic, retrospective case series.

The First Metatarsophalangeal Joint: Updates on Revision Arthrodesis and Malunions

First metatarsophalangeal joint (MPJ) arthrodesis procedures are a mainstay of forefoot surgery and are associated with high rates of patient satisfaction for addressing a multitude of first ray pathologic conditions. This procedure is often also used as a fallback option for the revision of poor outcomes after other surgical procedures involving the first ray. Despite its successes, there remain instances of complications that can develop after primary first MPJ arthrodesis. This article reviews first MPJ arthrodesis as a procedure for revisional surgery of the first ray, and potential surgical options after failed primary first MPJ arthrodesis.

First Metatarsophalangeal Joint Distraction Arthrodesis With Bicortical Calcaneal Autograft

First metatarsophalangeal joint (MTPJ) arthrodesis is a surgical treatment option for failed first MTPJ procedures. In cases of failed MTPJ arthroplasty, removal of failed implants and necrotic bone can cause shortening and biomechanical insufficiency of the first ray. Distraction arthrodesis with bone grafting can be used to maintain first ray length. We describe a technique of autograft harvest from the ipsilateral calcaneus. We present a retrospective case series of clinical and radiographic outcomes of distraction arthrodesis with bicortical calcaneal autograft in patients with failed procedures of the first MTPJ. We achieved a 100% osseous union rate. There was an insignificant change in first ray length from preoperative to postoperative (P = .2402). First ray length was maintained with a median autograft length of 10 (range 5 to 14) mm. We were able to correct first ray deformity with a significant reduction in preoperative to postoperative intermetatarsal angle and hallux abduction angle (P = .0156, P = .0068, respectively). Seven (88%) of 8 patients with available subjective follow-up were satisfied with the outcome of the procedure and would undergo the procedure again. Our results indicate that first MTPJ distraction arthrodesis with calcaneal autograft is a viable option for failed first MTPJ procedures. Surgeons who implement our techniques can expect high rates of osseous union, deformity correction, and patient satisfaction.

Joint Preparation and Ray Shortening in Arthroscopic Versus Open First Metatarsophalangeal Fusion: A Cadaver Study

Purpose This study compares the amount of joint preparation and first ray shortening following first metatarsophalangeal (MTP) joint fusion utilizing open conical reaming versus arthroscopic technique. Methods Ten below-knee cadaver specimens were randomly assigned to undergo either open or arthroscopic first MTP fusion. Following fixation, first ray length measurements were obtained from pre-operative and post-operative radiographs and were used to determine first ray shortening. Additionally, the ratio of first ray length to second ray length was calculated both pre-operatively and post-operatively and compared between the two approaches. All ankles were then completely dissected, and prepared surface areas were demarcated. ImageJ photo analysis software (National Institutes of Health, Bethesda, MD, USA) was used to calculate the percentage of prepared and unprepared cartilage of each articular surface of each specimen.  Results Overall, the open approach resulted in 99.3% ± 1.6% joint surface preparation, whereas the arthroscopic approach yielded 92.9% ± 7.2% (p = 0.089). On average, the head of the first metatarsal was significantly more prepared with the use of the open approach (99.5% ± 1.1%) than with the arthroscopic approach (96.6% ± 1.5%) (p = 0.008). However, with respect to the base of the phalanx, the average difference in preparation between the arthroscopic approach and the open approach was not statistically significant (90.0% ± 12.8% vs. 99.0% ± 2.2%; p = 0.160). The average amount of first ray shortening in the arthroscopic approach was 2.2 ± 1.8 mm compared to 2.1 ± 3.2 mm in the open approach (p = 0.934). The average change in the first to second ray length ratio was 0.02 for both approaches (p = 0.891). Conclusion Arthroscopic first MTP fusion can be used to achieve joint preparation comparable to open technique while maintaining first ray length.

Biomechanical Comparison of Low-Profile Contoured Locking Plate With Single Compression Screw to Fully Threaded Compression Screws for First MTP Fusion

BACKGROUND

Open metatarsophalangeal (MTP) arthrodesis using locked plates produces good clinical outcomes. However, arthroscopic fusion with new-generation fully threaded compression screws is emerging as an alternative. The purpose of this study was to compare low-profile contoured locked plates with fully threaded compression screws for first MTP fusion, in a biomechanical cadaveric model.

METHODS

The first rays of 8 matched pairs of fresh frozen cadaveric feet underwent dissection and dual-energy x-ray absorptiometry (DEXA) scanning to measure bone mineral density (BMD). The "plate" group was prepared with cup-and-cone reamers, and fixation of the MTP joint with 1 compression screw and low-profile dorsal locked plate. The matched-pair "screws" group was prepared through a simulated arthroscopic technique, achieving fixation with 2 new-generation fully threaded compression screws. The plantar MTP gap was recorded with an extensometer during 250 000 90-N cyclic loads followed by a single load to failure.

RESULTS

The screw group demonstrated significantly greater stiffness, 31.6 N/mm (plates) and 51.7 N/mm (screws) (P = .0045). There was no significant difference in plantar gapping or load to failure, 198.6 N (plates) and 290.1 N (screws) (P = .2226). Stiffness and load to failure were highly correlated to BMD for the screw group, r =0.79 and r = 0.94, respectively, but less so for the plate group, r = 0.36 and r = 0.62, respectively. The maximum metatarsal head height measured on the lateral view was strongly correlated with load to failure for both the plate- and screw-only groups (r > 0.9).

CONCLUSION

These data demonstrate that hallux MTP arthrodesis utilizing fully threaded compression screws had similar plantar gapping and load to failure when compared with the low-profile locking plate, but with significantly more stiffness. These results support an increased role of fully threaded screws for MTP arthrodesis using either the arthroscopic or open technique. However, with decreased BMD plate fixation may remain the better fixation choice.

CLINICAL RELEVANCE

Our data suggest that with regard to construct stability, fully threaded headless compression screws may be just as effective as low-profile locking plates, but BMD and MTP joint fluoroscopic measurements should be considered in the decision-making process for fixation.

Result of IOFIX (Intra Osseous FIXation) device for first metatarsophalangeal joint arthrodesis: A single surgeon's series

BACKGROUND

Arthrodesis of the first metatarsophalangeal joint (MTPJ) is a common procedure to treat significant first MTPJ arthritis. However, dorsal plates used for this have been associated with high incidence of metalwork removal. The IOFIX (Intra-Osseous FIXation) is a fixed angle device that is noted to provide a more uniform compression over a larger aspect of the fusion surfaces than a screw construct alone with the advantage of minimizing soft tissue irritation which can reduce the need for subsequent implant removal.

METHODS

Twenty one consecutive patients who underwent primary first MTPJ fusion with the IOFIX were reviewed. The mean age of the cohort was 63 years (range 47-81), with 80% female. The ratio of left to right was 9:12. The mean follow up of was 28 months (range 13.4-48.2 months). Outcomes analyzed were rate of fusion, Manchester-Oxford foot questionnaire (MOXFQ) score, patient satisfaction, improvement in the intermetatarsal angle and complications.

RESULTS

Complete fusion of the first MTPJ was achieved in twenty (95%) patients. One patient had a non union and another patient developed a delayed union. The mean preoperative MOXFQ score improved from 49.7 (95% confidence interval: 46-52) to 17.9 (95% confidence interval: 12-22), p<0.05.Improvement gained in all the domains of the MOXFQ score (walking/standing, pain and social) was statistically significant (p<0.05). Eighteen out of 21 patients (85%) were very pleased or fairly pleased with the procedure.

CONCLUSION

Early results show that the rate of fusion achieved by using the IOFIX device for the first MTPJ arthrodesis in our series was found to be comparable to other devices quoted in the literature.

Bone-block arthrodesis procedure in failures of first metatarsophalangeal joint replacement

BACKGROUND

The treatment for the failure of a first metatarsophalangeal joint (MTP1) prosthesis can be complex. There is no consensus regarding the ideal treatment. One of the main issues is the available bone stock after prosthesis removal. The aim of the study was to report the clinical and radiographic results for MTP1 arthrodesis with autologous calcaneus bone graft (bone-block fusion) as a revision procedure of a previous MTP1 implant failure.

METHODS

This study included 12 patients diagnosed with failure of a MTP1 prosthesis. All patients were treated with MTP1 arthrodesis using ipsilateral calcaneal bone graft. Patients were evaluated with the Foot Ankle Disability Index (FADI), the visual analogue pain scale (VAS) and AOFAS Hallux Metatarsophalangeal Interphalangeal scoring system (AOFAS-HMI), weight-bearing radiograph of the foot, and a computed tomography scan. The 1-2 intermetatarsal angle, hallux valgus angle, and first ray length were measured before surgery and at final follow-up.

RESULTS

Complications included 3 cases of arthrodesis nonunion, (1 symptomatic, 2 asymptomatic) with 2 of the 3 patients experiencing hardware failure and 1 superficial wound infection. The average FADI improved from 41.8 preoperatively to 84.6 at final follow-up (p<0.05); the average VAS improved from 8.5 preoperatively to 2 at final follow-up (p<0,05); the average AOFAS-HMI significantly improved from 50.7 preoperatively to 73.8 at final follow-up (p<0.05). The average length of the bone-block used was 14.3mm (range 11-19mm). The 1-2 intermetatarsal angle decreased from 9.5° preoperatively to 8.4° at final follow-up (p<0.05); hallux valgus angle improved from 19.7° preoperatively to 14.3° at final follow-up (p<0.05).

CONCLUSIONS

The management of a failed first metatarsophalangeal joint prosthesis remains controversial. Bone-block arthrodesis using ipsilateral calcaneal autograft appears to be a viable option restoring the bone loss, and avoiding hallux shortening. Nonunion is the most frequent complication with 25% of patients affected, but only 1/3 of patients with nonunion were symptomatic and required revision.