Black tea liquor ultrafiltration: Effect of ethanol pre-treatment upon fouling and cleaning characteristics

Integrated Membrane Process in Organic Media: Combining Organic Solvent Ultrafiltration, Nanofiltration, and Reverse Osmosis to Purify and Concentrate the Phenolic Compounds from Wet Olive Pomace

Phenolic compounds from a hydroalcoholic extract of wet olive pomace were purified and concentrated by an integrated membrane process in organic media. First, UF010104 (Solsep BV) and UP005 (Microdyn Nadir) membranes were tested to be implemented in the ultrafiltration stage, with the aim of purifying the extract and obtaining a permeate enriched in phenolic compounds. Despite the high flux observed with the UF010104 membrane (20.4 ± 0.7 L·h-1·m-2, at 2 bar), the UP005 membrane was selected because of a more suitable selectivity. Even though some secoiridoids were rejected, the permeate stream obtained with this membrane contained high concentrations of valuable simple phenols and phenolic acids, whereas sugars and macromolecules were retained. Then, the ultrafiltration permeate was subjected to a nanofiltration step employing an NF270 membrane (DuPont) for a further purification and fractionation of the phenolic compounds. The permeate flux was 50.2 ± 0.2 L·h-1·m-2, working at 15 bar. Hydroxytyrosol and some phenolic acids (such as vanillic acid, caffeic acid, and ferulic acid) were recovered in the permeate, which was later concentrated by reverse osmosis employing an NF90 membrane. The permeate flux obtained with this membrane was 15.3 ± 0.3 L·h-1·m-2. The concentrated phenolic mixture that was obtained may have important applications as a powerful antioxidant and for the prevention of diabetes and neurodegenerative diseases.

Orange juice ultrafiltration: characterisation of deposit layers and membrane surfaces after fouling and cleaning

The influence of feed condition and membrane cleaning during the ultrafiltration (UF) of orange juice for phytosterol separation was investigated. UF was performed using regenerated cellulose acetate (RCA) membranes at different molecular weight cut-off (MWCO) values with a 336 cm2 membrane area and a range of temperatures (10–40 °C) and different feed volumes (3–9 L). Fluid dynamic gauging (FDG) was applied to assess the fouling and cleaning behaviours of RCA membranes fouled by orange juice and cleaned using P3-Ultrasil 11 over two complete cycles. During the FDG testing, fouling layers were removed by fluid shear stress caused by suction flow. The cleanability was characterised by using ImageJ software analysis. A Liebermann-Buchard-based method was used to quantify the phytosterol content. The results show that RCA 10 kDa filters exhibited the best separation of phytosterols from protein in orange juice at 20 °C using 3 L feed with a selectivity factor of 17. Membranes that were fouled after two cycles showed higher surface coverage compared to one fouling cycle. The surface coverage decreased with increasing fluid shear stress from 0 to 3.9 Pa. FDG achieved 80–95% removal at 3.9 Pa for all RCA membranes. Chemical cleaning using P3-Ultrasil 11 altered both the membrane surface hydrophobicity and roughness. These results show that the fouling layer on RCA membranes can be removed by fluid shear stress without affecting the membrane surface modification caused by chemical cleaning.

Fouling Analysis and the Recovery of Phytosterols from Orange Juice Using Regenerated Cellulose Ultrafiltration Membranes

This study describes the use of regenerated cellulose (RCA) membranes with molecular weight cut-off (MWCO) values of 10, 30, and 100 kDa, respectively, to separate phytosterols from orange juice for possible nutraceutical production. A desirable membrane separation rejects protein whilst transmitting phytosterols and other low molecular mass compounds such as sugars. The ultrafiltration was performed in a cross-flow membrane system with a total filtration area of 336 cm2. Total phytosterol analysis was carried out by using a Liebermann-Buchard-based method. Protein concentration was quantified by the Bradford method. The effects of three different membranes upon the rejection of total phytosterol content, proteins, sugar, and antioxidant activity were studied. Of the membranes tested, the 10-kDa membrane displayed the highest concentration of phytosterols in the permeate. The 30-kDa and 100-kDa membranes gave comparatively higher phytosterol rejection. The membrane surface roughness and corresponding pure water flux values varied as a function of MWCO such that RCA30 > RCA100 > RCA10. Membranes with rougher surfaces displayed higher fouling than those with smoother surfaces. Hydrophobicity and surface roughness both influenced filtration performance, by controlling the development of the protein-based foulant which modified membrane selectivity.