Cryptosporidium-contaminated water disinfection by a novel Fenton process

Synergistic effect between Ce-doped SnO2 and bio-carbon for electrocatalytic degradation of tetracycline: Experiment, CFD, and DFT

Carbon-based sandwich-like electrocatalyst with a hierarchical structure, carbon sheet (CS)-loaded Ce-doped SnO₂ nanoparticles, were successfully prepared using a simple method, which presented a high-efficiency electrocatalytic performance for tetracycline decomposition. Among them, Sn_0.75Ce_0.25O_y/CS exhibits superior catalytic activity, such as more than 95% of tetracycline was removed (120 min), and over 90% of total organic carbon was mineralized (480 min). It is found from morphology observation and computational fluid dynamics simulation that the layered structure is conducive to improving the mass transfer efficiency. Through X-Ray powder diffraction, X-ray photoelectron spectroscopy, Raman spectrum, and density functional theory calculation analyze that the structural defect in Sn_0.75Ce_0.25O_y caused by Ce doping is considered to play the key role. Moreover, electrochemical measurements and degradation experiments further prove that the outstanding catalytic performance is attributable to the initiated synergistic effect established between CS and Sn_0.75Ce_0.25O_y. These results explain the effectiveness of Sn_0.75Ce_0.25O_y/CS for the remediation of tetracycline-contaminated water and mitigating the potential risks and imply that the Sn_0.75Ce_0.25O_y/CS composite has a deeply practical value in tetracycline wastewater degradation and a promise for further application.

Treatment of Olefin plant spent caustic by combination of Fenton-like and foam fractionation methods in a bench scale

Spent Merox caustic (SMC) is a hazardous waste that is produced during the Merox desulfurization process in the petroleum refinery industry and should be treated before discharging to environment. In the present study, treatment of SMC was investigated by three methods including Fenton-like process, foam fractionation, and a combination of both processes. Immobilized TiO₂/Fe⁰ on modified silica nanoparticles was used as a heterogeneous Fenton-like catalyst. The chemical and physical characteristics of the catalyst were determined using Fourier-transform infrared spectroscopy, X-ray diffraction, diffuse reflectance spectroscopy, thermogravimetric analysis, differential scanning calorimetry, and transmission electron microscopy techniques. The treatment performance of the combined method was measured as a cost-effective method with chemical oxygen demand (COD) removal percentage. The effect of parameters including pH, gas flow rate, surfactant type and concentration of hydrogen peroxide, catalyst, and chelate were investigated. It is found that the prepared heterogeneous catalyst has high activity for the treatment of SMC. In addition, the results showed that the combined method achieved 97.6 ± 0.5% COD removal, while the measured values for Fenton or foam fractionation methods alone did not exceed 85.5 ± 1% and 47.2 ± 0.4%, respectively. The advantage of combination process over foam fractionation was the use of an advanced oxidation process in the separating column to eliminate or reduce the secondary phase contamination load. Besides, the role of the column in the effective contact of contaminants with the rising bubbles improved the degradation performance of the proposed process and reduced the consumption of hydrogen peroxide by 46% compared to the Fenton-like method.