Conceptual design of scalable vacuum pump to validate sintered getter technology for future NBI application

Novel Non-Evaporable Getter Materials and Their Possible Use in Fusion Application for Tritium Recovery

Non-evaporable getters (NEGs) are metallic compounds of the IV group, particularly titanium and/or zirconium-based alloys and are usually used as pumps in vacuum technologies since they are able to sorb, by chemical reactions, most of the active gas molecules, with particular efficacy towards hydrogen isotopes. This work suggests an alternative application of these materials to fusion nuclear reactors, where there is the need to recover small amount of tritium from the large helium flow rate composing the primary coolant loop. Starting from the tritium mass balance inside the primary coolant loop, the amount of coolant to be routed inside the coolant purification system (CPS) is identified. Then a feasibility study, based on the bulk getter theory, is presented by considering three different commercial alloys, named ST707, ST101 and ZAO. The results provide the mass, the area and the regeneration parameters of the three different alloys necessary to fulfill the requirements of the CPS unit. By comparing the features of the three alloys, the ZAO material appears the most promising for the proposed application because it requires the lower amount of material and a lower number of regeneration cycles.

Numerical simulation of experimental tests performed on ZAO® non-evaporable-getter pump designed for neutral beam injector applications

Vacuum systems of neutral beam injectors have very demanding requirements in terms of pumping speed, throughput, and capacity. Due to their high affinity to hydrogenic species, porous sintered Non-Evaporable Getters (NEG) are a possible candidate for deployment in giant hydrogen ion sources and neutral beam injectors for fusion. This paper presents the numerical interpretation of experimental tests on a recently developed NEG cartridge, that is part of a modular pump under development for neutral beam injectors. The cartridge is composed of six stacks of ZAO® porous sintered NEG disks and a heater. It was tested under hydrogen loads relevant for neutral beam injectors, namely, at constant pressure or constant flow, such that the hydrogen pressure was in the range of 20 mPa-40 mPa. The result of the sorption test was reproduced by a three dimensional flow simulation in molecular regime to determine the actual pumping speed, the effective sticking coefficient, and the uniformity of the gas load on the various NEG disks. The procedure developed and the results obtained provide the basic understanding for interpreting the large-scale tests on the modular pump, consisting of 34 of these cartridges.