Eu(III)-organic framework as a multi-responsive photoluminescence sensor for efficient detection of 1-naphthol, Fe3+ and MnO4− in water

A Novel 3D-Morphology Pyrene-Derived Conjugated Fluorescence Polymer for Picric Acid Detection

Aggregation-induced quenching (ACQ) is a hard problem in fluorescence material, leading to a poor utilization rate of fluorophores. In this work, 1,3,6,8-tetrakis(4-formylphenyl)pyrene (TFPPy) was synthesized and used as a precursor to build two kinds of fluorescence polymer. The TFFPy molecule with D2h symmetry can easily form polymers with C3 symmetry amines through the Schiff base reaction, making the resulting polymer a 3D amorphous material. Thus, ACQ of fluorophore can be reduced to minimum, making the most usage of the fluorescence of pyrene core. Fluorescence titration and DFT calculation can clearly prove this conclusion. The resulting CPs showed a highly sensitivity to picric acid, down to 3.43 ppm in solution, implying its potential in explosive detection.

Heterometallic Europium(III)–Lutetium(III) Terephthalates as Bright Luminescent Antenna MOFs

A new series of luminescent heterometallic europium(III)–lutetium(III) terephthalate metal–organic frameworks, namely (Eu_xLu_1−x)₂bdc₃·nH₂O, was synthesized using a direct reaction in a water solution. At the Eu³⁺ concentration of 1–40 at %, the MOFs were formed as a binary mixture of the (Eu_xLu_1−x)₂bdc₃ and (Eu_xLu_1−x)₂bdc₃·4H₂O crystalline phases, where the Ln₂bdc₃·4H₂O crystalline phase was enriched by europium(III) ions. At an Eu³⁺ concentration of more than 40 at %, only one crystalline phase was formed: (Eu_xLu_1−x)₂bdc₃·4H₂O. All MOFs containing Eu³⁺ exhibited sensitization of bright Eu³⁺-centered luminescence upon the 280 nm excitation into a ¹ππ* excited state of the terephthalate ion. The fine structure of the emission spectra of Eu^{3+ 5}D₀-⁷F_J (J = 0–4) significantly depended on the Eu³⁺ concentration. The luminescence quantum yield of Eu³⁺ was significantly larger for Eu-Lu terephthalates containing a low concentration of Eu³⁺ due to the absence of Eu-Eu energy migration and the presence of the Ln₂bdc₃ crystalline phase with a significantly smaller nonradiative decay rate compared to the Ln₂bdc₃·4H₂O.

Controllable Enhanced Ru(bpy)32+ Electrochemiluminescence Detection Systems Based on Eu@MOF253@AuNPs/GCE for the Sensitive Detection of Carbaryl in Food

In this study, an electrochemiluminescence detection system for the sensitive detection of carbaryl was constructed based on the dual identification of Eu@MOF253, which has a recognition effect on carbaryl, and the electrochemiluminescence system of Ru(bpy)₃²⁺/S₂O₈^2-, which can react with carbaryl in a redox reaction. This method not only overcame the weakness of the electrochemiluminescence instability of the Ru(bpy)₃²⁺/S₂O₈^2- system but also changed the sensitivity of the sensing detection system to the target by adjusting the concentration of Ru(bpy)₃²⁺ and then proposed a detection strategy with a controllable detection range. After analyzing the electrochemiluminescence signal change mechanism of this system and optimizing the detection conditions, it was concluded that the strategy has good linear detection of carbaryl in the range of 1-1000 and 0.02-0.3 μg L^-1, and the detection limits were 0.058 and 0.014 μg L^-1. Finally, the strategy was also successfully applied to the detection of actual samples.

Construction of an ECL Detection Platform for Sensitive Detection of Carbaryl Based on an Eu3+-Functionalized Metal–Organic Framework Encapsulated with Nanogold

In this work, an Eu3+-MOF-253@Au electrochemiluminescence sensor was successfully constructed for the first time by encapsulating nanogold in the metal–organic frameworks (MOFs) backbone and pore channels, and assembling Eu3+ on the MOF backbone. Firstly, the introduction of nanogold overcomes the weakness of MOFs, which was difficult to achieve, and enhances its catalytic performance, followed by the modification of Eu3+ to confer the electrochemiluminescence performance and the function of target detection on the sensor. Moreover, carbaryl was placed in an alkaline working solution to enhance the intensity of electrochemiluminescence signal, as well as to promote the hydrolysis of carbaryl into 1-naphthol, which caused the burst of Eu3+-MOF-253@Au electrochemiluminescence sensor, thereby achieving the sensitive detection of carbaryl. On this basis, the electrochemiluminescence detection conditions were optimized, the performance was analyzed, and finally it was successfully used for the detection of carbaryl with good linearity in the range of 0.2–200 μg L−1 and a low detection limit (0.14 μg L−1).

Ultrasound-Assisted Synthesis of Luminescent Micro- and Nanocrystalline Eu-Based MOFs as Luminescent Probes for Heavy Metal Ions

The luminescent coarse-, micro- and nanocrystalline europium(III) terephthalate tetrahydrate (Eu₂bdc₃·4H₂O) metal-organic frameworks were synthesized by the ultrasound-assisted wet-chemical method. Electron micrographs show that the europium(III) terephthalate microparticles are 7 μm long leaf-like plates. According to the dynamic light scattering technique, the average size of the Eu₂bdc₃·4H₂O nanoparticles is equal to about 8 ± 2 nm. Thereby, the reported Eu₂bdc₃·4H₂O nanoparticles are the smallest nanosized rare-earth-based MOF crystals, to the best of our knowledge. The synthesized materials demonstrate red emission due to the ⁵D₀–⁷F_J transitions of Eu³⁺ upon 250 nm excitation into ¹ππ* state of the terephthalate ion. Size reduction results in broadened emission bands, an increase in the non-radiative rate constants and a decrease in both the quantum efficiency of the ⁵D₀ level and Eu³⁺ and the luminescence quantum yields. Cu²⁺, Cr³⁺, and Fe³⁺ ions efficiently and selectively quench the luminescence of nanocrystalline europium(III) terephthalate, which makes it a prospective material for luminescent probes to monitor these ions in waste and drinking water.

A Facile One-Pot Approach to the Synthesis of Gd-Eu Based Metal-Organic Frameworks and Applications to Sensing of Fe3+ and Cr2O72- Ions

Gadolinium metal-organic frameworks (Gd-MOFs) and Eu-doped Gd-MOFs have been synthesized through a one-pot green approach using commercially available reagents. The 1,4-benzenedicarboxylic acid (H2-BDC) and 2,6-naphthalenedicarboxylic acid (H2-NDC) were chosen as ditopic organic linkers to build the 3D structure of the network. The Gd-MOFs were characterized using powder X-ray diffraction (XRD), FT-IR spectroscopy, field emission scanning electron microscopy (FE-SEM) and N2 adsorption-desorption analysis. The Gd-MOF structures were attributed comparing the XRD patterns, supported by the FT-IR spectra, with data reported in the literature for Ln-MOFs of similar lanthanide ionic radius. FE-SEM characterization points to the effect of the duration of the synthesis to a more crystalline and organized structure, with grain dimensions increasing upon increasing reaction time. The total surface area of the MOFs has been determined from the application of the Brunauer-Emmett-Teller method. The study allowed us to correlate the processing conditions and ditopic linker dimension to the network surface area. Both Gd-MOF and Eu-doped Gd-MOF have been tested for sensing of the inorganic ions such as Fe3+ and Cr2O72-.

In situ self-assembled cationic lanthanide metal organic framework membrane sensor for effective MnO4- and ascorbic acid detection

Developing portable membrane sensors to accurately detect the biomolecule ascorbic acid (AA) is extremely important for food safety and human health. Herein, we successfully design and synthesize a novel cationic metal organic framework (Eu-pbmc, Hpbmc = 2-(pyridine-2-yl)-1H-benzimidazole-5-carboxylic acid) and assemble polyacrylonitrile/Eu-pbmc membrane (PEM) by an in-situ growth strategy. Benefiting from the appreciable loading of Eu-pbmc nanoparticles and high water permeation flux, PEM possesses effective detection for MnO₄^- with a limit of detection (LOD) of 17 nM. Utilizing the cationic porous framework, we load MnO₄^- into PEM and construct a "on-off-on" system for effective AA detection. The oxidative MnO₄^- can be reduced by AA and the resulting turn-on luminescence can reflect the concentration of AA. Compared with pure Eu-pbmc crystals, PEM exhibits improved AA detection performance with LOD of 48 nM and detection time of 1 min via a concise detection operation. The stable membrane sensor realizes an accurate detection in real biological samples, meeting the practical requirement. Moreover, an IMP logic gate is helpful to analyze MnO₄^- and AA in water. The proposed novel luminescence platform as well as reasonable "on-off-on" luminescence mode provide a promising method for AA detection.