A missing layer in COVID-19 studies: Transmission of enveloped viruses in mucus-rich droplets

Evaporation of Concentrated Polymer Solutions Is Insensitive to Relative Humidity

A recent theory suggests that the evaporation kinetics of macromolecular solutions is insensitive to the ambient relative humidity (RH) due to the formation of a "polarization layer" of solutes at the air-solution interface. We confirm this insensitivity up to RH≈80% in the evaporation of polyvinyl alcohol solutions from open-ended capillaries. To explain the observed drop in evaporation rate at higher RH, we need to invoke compressive stresses due to interfacial polymer gelation. Moreover, RH-insensitive evaporation sets in earlier than theory predicts, suggesting a further role for a gelled "skin." We discuss the relevance of these observations for respiratory virus transmission via aerosols.

Assessing suspension and infectivity times of virus-loaded aerosols involved in airborne transmission

Airborne transmission occurs through droplet-mediated transport of viruses following the expulsion of an aerosol by an infected host. Transmission efficiency results from the interplay between virus survival in the drying droplet and droplet suspension time in the air, controlled by the coupling between water evaporation and droplet sedimentation. Furthermore, droplets are made of a respiratory fluid and thus, display a complex composition consisting of water and nonvolatile solutes. Here, we quantify the impact of this complex composition on the different phenomena underlying transmission. Solutes lead to a nonideal thermodynamic behavior, which sets an equilibrium droplet size that is independent of relative humidity. In contrast, solutes do not significantly hinder transport due to their low initial concentration. Realistic suspension times are computed and increase with increasing relative humidity or decreasing temperature. By uncoupling drying and suspended stages, we observe that enveloped viruses may remain infectious for hours in dried droplets. However, their infectivity decreases with increasing relative humidity or temperature after dozens of minutes. Examining expelled droplet size distributions in the light of these results leads to distinguishing two aerosols. Most droplets measure between 0 and 40 µm and compose an aerosol that remains suspended for hours. Its transmission efficiency is controlled by infectivity, which decreases with increasing humidity and temperature. Larger droplets form an aerosol that only remains suspended for minutes but corresponds to a much larger volume and thus, viral load. Its transmission efficiency is controlled by droplet suspension time, which decreases with increasing humidity and decreasing temperature.

A Study on Flow Field Characteristics and Air Purifier with Barrier Effects

An air curtain machine is used in the entrances and exits of public places where air conditioners are used. The high-speed centrifugal or axial fan blows out the air, creating an airflow barrier to prevent air convection inside and outside, reducing air conditioning losses, and maintaining the indoor air quality by preventing dust, insects, and harmful gases from entering the room. Observation of the airflow behavior was conducted using CFD simulation, to explore whether it has a blocking effect, and the air curtain principle was applied to the air purification equipment. It is mainly composed of several rows of arrayed hole air outlets to form a multi-composite air wall. The airflow on the two sides, or below, can be blocked by the composite air wall and integrated into the main airflow, so that the air walls will not affect each other, and form a barrier effect to prevent infection. This research includes the measurement of impedance characteristics for three layers of filters made of different materials. These filters are used as the input characteristic parameters in the simulation analysis. Four scenarios are discussed, including the consultation room, hospital ward, quarantine station, and conference room. From the simulation results, it is known that when there are many people, the equipment can be set to high speed to increase the volume of air, forming a wind wall to effectively block airflow from the people in the chairs, reducing the risk of infection. Note that the rotation speed should not be too high. The air outlet equipment is susceptible to turbulent flow, which will make the airflow deviate from the expected direction and increase the possibility of mutual infection between adjacent people. Partitions can be used to block airflow to reduce the risk of infection.