Rapid and high selective removal of Hg(II) ions using tannic acid cross-linking cellulose/polyethyleneimine functionalized magnetic composite

Fabrication of a novel polyvinylpyrrolidone/chitosan-Schiff base/Fe2O3 nanocomposite for efficient adsorption of Pb(II) and Hg(II) ions from aqueous solution

A novel magnetic polyvinylpyrrolidone/chitosan-Schiff base/Fe2O3 (PVP/CS-SB/Fe2O3) adsorbent was prepared by one-pot facile co-precipitation route for adsorption of Pb(II) and Hg(II) ions from aqueous solution. Fourier transform infrared-spectroscopy (FT-IR), X-ray diffraction (XRD), scanning electron microscope (SEM), vibrating sample magnetometer (VSM) and Brunauer-Emmett-Teller (BET) were used to characterize the synthesized PVP/CS-SB/Fe2O3. The results predicted that the successfully synthesis of magnetic CSSB-PVP@Fe2O3. The effects of important factors such as pH solution, contact time, concentration of metal ions, adsorbent dose and co-existing ions on Pb(II) and Hg(II) adsorption were investigated. The maximum adsorption capacities of Pb(II) and Hg(II) ions at optimal conditions were 120 mg/g and 102.5 mg/g, respectively. The kinetic studies predicted that the adsorption followed the pseudo-second-order (PSO) model as chemisorption using the coordination of active sites of PVP/CS-SB/Fe2O3 with the metal ions and also n-π interactions. Reproducibility results predicted that the excellent regeneration ability after 6 adsorption cycles. According to the results of this work, the PVP/CS-SB/Fe2O3 nanocomposite is promising for Pb(II) and Hg(II) ions adsorption and can be potential as a simple, low-cost, high-efficient adsorbent for decontamination of other heavy metal ions from aqueous solution.

Cellulose-based adsorbent using in mercury detection and removal from water via an efficient grafting strategy of fluorometric sensors by click reaction

Mercury pollution in waters attracts lots of attention due to its serious toxicity and high bioenrichment and many efforts have been devoted in the development of adsorbents for mercury detection and removal. Herein, a cellulose-based adsorbent Cell-TriA-HQ is functionalized with quinoline fluorophore by covalent immobilization through "Click reaction" with high yield. In addition to the admirable adsorptive performance, the prepared adsorbent exhibits excellent selectivity and sensitivity towards Hg (II) in water that the detection limit for Hg (II) is determined to be as low as 1.92 × 10-7 M. The sensitive fluorescence enhancement response is considered to be resulted from the inhibition of photo-induced electron transfer between triazole and quinoline groups and the reinforcement of structural rigidity. The easy manipulation along with excellent performance of adsorption capacity, detective ability and reusability for the multifunctional adsorbent makes it potential in mercury monitoring and removal from aqueous solutions in the field of water treatment.

Advances in green materials derived from wood for detecting and removing mercury ions in water

The issue of mercury pollution in environmental remediation has garnered significant attention due to its severe health hazards to humans. Various strategies have been devised to mitigate the impact of toxic mercury ions, including coagulation, ion exchange, adsorption, membrane technology, and electrochemical treatment. Among these approaches, adsorption has emerged as an efficient and widely employed method for the uptake of low concentrations of mercury ions. It offers convenient operation, high removal efficiency, and facile regeneration of the adsorbent. Wood, being the most abundant renewable and sustainable bioresource, has garnered attention as a promising material for treating heavy metal wastewater. This is attributed to its unique physical and chemical characteristics, encompassing hierarchical pores, aligned channels, active functional groups, biodegradability, and cost-effectiveness. However, a comprehensive examination of the cutting-edge applications of wood and wood-derived biopolymers in the detection and removal of mercury ions from wastewater has yet to be undertaken. Consequently, this article presents a chronological overview of recent advancements in materials and structures derived from bulk wood and its constituents, including cellulose, lignin, hemicellulose, and tannin, with a specific focus on their utility in detecting and eliminating mercury from water sources. Subsequently, the most promising techniques and strategies involving wood and wood-derived biopolymers in addressing the predicament of mercury pollution are explored. Furthermore, this piece offers insights into the existing challenges and future prospects concerning environmentally friendly materials derived from wood, aiming to foster the development of cost-effective mercury adsorbents and detection devices.

Next-Generation Water Treatment: Exploring the Potential of Biopolymer-Based Nanocomposites in Adsorption and Membrane Filtration

This review article focuses on the potential of biopolymer-based nanocomposites incorporating nanoparticles, graphene oxide (GO), carbon nanotubes (CNTs), and nanoclays in adsorption and membrane filtration processes for water treatment. The aim is to explore the effectiveness of these innovative materials in addressing water scarcity and contamination issues. The review highlights the exceptional adsorption capacities and improved membrane performance offered by chitosan, GO, and CNTs, which make them effective in removing heavy metals, organic pollutants, and emerging contaminants from water. It also emphasizes the high surface area and ion exchange capacity of nanoclays, enabling the removal of heavy metals, organic contaminants, and dyes. Integrating magnetic (Fe2O4) adsorbents and membrane filtration technologies is highlighted to enhance adsorption and separation efficiency. The limitations and challenges associated are also discussed. The review concludes by emphasizing the importance of collaboration with industry stakeholders in advancing biopolymer-based nanocomposites for sustainable and comprehensive water treatment solutions.

In situ preparation of a multifunctional adsorbent by optimizing the Fe2+/Fe3+/Mn2+/HA ratio for simultaneous and efficient removal of Cd(II), Pb(II), Cu(II), Zn(II), As(III), Sb(III), As(V) and Sb(V) from aqueous environment: Behaviors and mechanisms

Multiple potentially toxic elements (PTEs) often coexist in practical wastewater environment, which poses serious risks to the ecological environment and human health. However, few of the reported adsorbents are capable of simultaneously and effectively removing multiple PTEs from wastewater due to the unique properties of each element. In this work, a multifunctional adsorbent FMHs was developed by optimizing Fe²⁺/Fe³⁺/Mn²⁺/HA ratio, and applied to remove Cd(II), Pb(II), Cu(II), Zn(II), As(III), Sb(III), As(V) and Sb(V) from aqueous solution. Results revealed that the adsorption data obeyed the Elovich, Sips and Redlich-Peterson models in the mono-component system, and the maximum adsorption capacity of FMHs was superior to most adsorbents reported in the literatures. In addition, FMHs retained considerable removal capacity after four cycles, and maintained excellent adsorption performance under the interference of different environmental factors (including pH, ionic strength, co-existing ions and humic acid). In the multi-component system, FMHs also presented high adsorption capacity for all the selected PTEs, especially for Sb(III/V) and Pb(II). Characterization results confirmed that various removal mechanisms, such as precipitation, surface complexation, ion exchange, electrostatic attraction and redox, were responsible for the capture of PTEs by FMHs.

Covalently Functionalized Cellulose Nanoparticles for Simultaneous Enrichment of Pb(II), Cd(II) and Cu(II) Ions

Cellulose nanoparticles are sustainable natural polymers with excellent application in environmental remediation technology. In this work, we synthesized cellulose nanoparticles and covalently functionalized them with a multi-functional group possessing ligands. The hybrid material shows excellent adsorption properties for the simultaneous extraction of multiple metal ions in the sample preparation technique. The sorbent shows excellent sorption capacity in the range of 1.8-2.2 mmol/g of material. The developed method was successfully employed for the simultaneous extraction of Pb(II), Cd(II) and Cu(II) from real-world samples (industrial effluent, river water, tap and groundwater) and subsequently determined by inductively coupled plasma optical emission spectroscopy (ICP-OES). The method shows a preconcentration limit of 0.7 ppb attributes to analyze the trace concentration of studied metal ions. The detection limit obtained for Pb(II), Cd(II) and Cu(II) is found to be 0.4 ppb.

Resource utilization of pig hair to prepare low-cost adsorbents with high density of sulfhydryl for enhanced and trace level removal of aqueous Hg(II)

Pig hair (PH), a keratinous waste, was modified by ammonium thioglycolate in a ball milling to promote its performance of Hg(II) sequestration. The ball milling broke the hydrophobic cuticle sheath and enhanced the reduction of disulfide bond, which increased the sulfydryl content of the modified PH (BTPH) from 0.07 to 11.05 μmol/g. BTPH exhibited a significantly higher capture capacity of Hg(II) (415.4 mg/g) than PH (3.1 mg/g), as well as the commercial activated carbon (219.7 mg/g), and persisted its performance over a wide range of solution pH. Meanwhile, BTPH with a distribution coefficient of 5.703 × 10⁵ mL/g could selectively capture Hg(II) from the water with the coexisting metal ions such as Mg(II), Cd(II) and Pb(II). Moreover, the low-cost BTPH could reduce the Hg(II) from 1.0 mg/L to well below the limit of drinkable water (2 μg/L) in real-world samples. Density functional theory (DFT) calculations and state-of-the-art characterizations illustrated that the binding of Hg(II) to sulfydryl groups was the main adsorption mechanism. Notably, BTPH decreased the mercury content of water spinaches from 24.1 to 0.50 mg/kg and thereby significantly reduced the phytotoxicity of Hg(II). This work therefore provides a sustainable way to utilize keratinous wastes for the remediation of aqueous Hg(II).

Adsorption and Removal of Mercury(II) by a Crosslinked Hyperbranched Polymer Modified via Sulfhydryl

In this study, the highly crosslinked hyperbranched polyamide-amines (H-PAMAMs) were first prepared via one-pot methods and then modified with thiourea to synthesize a novel adsorbent containing sulfhydryl groups (CHAP-SH), which was used to adsorb Hg(II) ions from aqueous solutions. The adsorption characteristics and mechanism of CHAP-SH for Hg(II) ions were systematically studied. As expected, CHAP-SH exhibited a rapid removal performance toward Hg(II), and the maximum adsorption capacity was 282.74 mg/g at 318 K and pH = 4.5. The whole adsorption behavior could be well described by the pseudo-second-order kinetic model and Langmuir and Redlich-Peterson adsorption isotherm models, which reflected that the adsorption process was mainly monolayer chemisorption. Meanwhile, CHAP-SH had strong selectivity for Hg(II) in the presence of multimetal ions, and it had excellent recoverability after five cycles. In order to further elucidate the adsorption mechanism, the adsorbents before and after adsorption were characterized by Fourier transform infrared spectroscopy, scanning electron microscopy, X-ray photoelectron spectroscopy, thermogravimetric analysis, and energy-dispersive X-ray spectroscopy, and the results showed that the nitrogen-containing, oxygen-containing, and sulfur-containing groups in the adsorbent molecule had synergistic complexation with Hg(II). These results indicated that the adsorbents had great potential in the future treatment of aqueous solutions containing Hg(II).

Recent advances in magnetic composites as adsorbents for wastewater remediation

The scarcity of clean drinking water combined with other environmental and anthropogenic effects necessitates the demand for development of advanced technology for cleaning polluted water. Adsorption is one such technique that does not produce toxic byproducts and solves the problem of cleaning contaminated water at a lower cost. In recent years, magnetic composites, as adsorbent, have gained lot of attention due to their reusability which makes them sustainable and economical. This review article describes the challenges related to water quality, scarcity and then summarizes the current treatment technologies and advancement in the field of adsorption to resolve the prevailing concerns. The review includes an insight into the recent research being carried out in the field of magnetic composites and nanocomposites, as adsorbent, covering, probably, all aspects of what is going around the globe. Different materials, like polymers, biomaterials, clays and metal organic framework (MOF)-based magnetic composites and their applications in wastewater treatment processes have been included. The article is a comprehensive review on the application of different materials to detoxify various diverse pollutants with prime focus on magnetic composites. The thorough study of this review will surely bring upcoming researchers closer to the future possibilities of research in wastewater treatment.

Highly effective removal of Hg(ii) solution using corn bract@MoS2 as a new biomass adsorbent

As known, mercury contamination is one of the current environmental issues due to the high toxicity of mercury.