Biomimetic mineralization of nacre-inspired multiple crosslinked PVA/CaAlg/SiO2 membrane with simultaneously enhanced mechanical and separation properties

A Hydrogel-coated Wood Membrane with Intelligent Oil Pollution Detection for Emulsion Separation

Considering the potential threats posed by oily wastewater to the ecosystem, it is urgently in demand to develop efficient, eco-friendly, and intelligent oil/water separation materials to enhance the safety of the water environment. Herein, an intelligent hydrogel-coated wood (PPT/PPy@DW) membrane with self-healing, self-cleaning, and oil pollution detection performances is fabricated for the controllable separation of oil-in-water (O/W) emulsions and water-in-oil (W/O) emulsions. The PPT/PPy@DW is prepared by loading polypyrrole (PPy) particles on the delignified wood (DW) membranes, further modifying the hydrogel layer as an oil-repellent barrier. The layered porous structure and selective wettability endow PPT/PPy@DW with great separation performance for various O/W emulsions (≥98.69% for separation efficiency and ≈1000 L m-2 h-1 bar-1 for permeance). Notably, the oil pollution degree of PPT/PPy@DW can be monitored in real-time based on the changed voltage generated during O/W emulsion separation, and the oil-polluted PPT/PPy@DW can be self-cleaned by soaking in water to recover its separation performance. The high affinity of PPT/PPy@DW for water makes it effective in trapping water from the mixed surfactant-stabilized W/O emulsions. The prepared eco-friendly and low-cost multifunctional hydrogel wood membrane shows promising potential in on-demand oil/water separation and provides new ideas for the functional improvement of new biomass oil/water separation membrane materials.

High performance polyvinyl alcohol/lignin fibers with excellent mechanical and water resistance properties

To address the shortcoming of Polyvinyl alcohol (PVA) fibers for food or medical packaging materials including low mechanical strength and poor water resistance, lignin (LN) was used as raw material, acetone/H2O as solvent to self-assemble into lignin nanoparticles (LNP) by adverse solvent precipitation approach, and then PVA/LNP composite fibers with different LNP contents were fabricated successfully by wet and dry spinning. Herein, vast hydrophilic hydroxyl groups in PVA decreased owing to the hydrogen bond between LN and PVA, Especially, with only 0.5 wt% loading of LNP into the PVA/LNP fibers, the diameter was 94.4 dtex, tensile strength was 10.1 cN/dtex (1279.8 MPa), initial modulus was 94.7 cN/dtex (12.0 GPa), the crystallinity was 56.7 %, the orientation was 97.1 %, and water contact angle was 103.1°. Compared with pure PVA fibers, the tensile strength of PVA/LNP-0.5 fibers was increased by 44.2 % and the contact angle was increased 37°. This work provides novel insights into obtaining lignin-reinforced PVA composite fibers with strong mechanical properties and excellent water resistance properties, indicating the potential of the PVA/LNP fibers for food or medical packaging application.

The antifouling mechanism and application of bio-inspired superwetting surfaces with effective antifouling performance

With the rapid development of industries, the issue of pollution on Earth has become increasingly severe. This has led to the deterioration of various surfaces, rendering them ineffective for their intended purposes. Examples of such surfaces include oil rigs, seawater intakes, and more. A variety of functional surface techniques have been created to address these issues, including superwetting surfaces, antifouling coatings, nano-polymer composite materials, etc. They primarily exploit the membrane's surface properties and hydration layer to improve the antifouling property. In recent years, biomimetic superwetting surfaces with non-toxic and environmental characteristics have garnered massive attention, greatly aiding in solving the problem of pollution. In this work, a detailed presentation of antifouling superwetting materials was made, including superhydrophobic surface, superhydrophilic surface, and superhydrophilic/underwater superoleophobic surface, along with the antifouling mechanisms. Then, the applications of the superwetting antifouling materials in antifouling domain were addressed in depth.

Efficient adsorption of chloroquine phosphate by a novel sodium alginate/tannic acid double-network hydrogel in a wide pH range

In this work, a novel double-network composite hydrogel (SA/TA), composed of sodium alginate (SA) and tannic acid (TA), was designed and fabricated by a successive cross-linking method using Ti(IV) and Ca(II) as crosslinkers. SA/TA exhibited reinforced mechanical strength and anti-swelling properties because of the double-network structure. SA/TA was used as an adsorbent for removal of a popular antiviral drug, chloroquine phosphate (CQ), in water. The adsorption performance of SA/TA was systematically investigated, to study various effects including those of TA mass content, solution pH, adsorption time, and initial CQ concentration. Adsorption was also examined in presence of inorganic and organic coexisting substances commonly found in wastewater, and under different actual water samples. Batch experimental results indicated that SA/TA could maintain higher and more stable CQ uptakes within a wide solution pH range from 3.0 to 10.0, compared to its precursor, SA hydrogel, owing to the addition of TA-Ti(IV) coordination network. The maximum experimental CQ uptake exhibited by the 1:1 (by wt) SA/TA (SA/TA2) was as high as 0.699 mmol/g at the initial pH of 9.0. A high concentration of coexisting NaCl evidently reduced the CQ uptakes of SA/TA2 due to the electrostatic shielding effect, moreover, divalent cations including Ca(II) and Mg(II) also inhibited the adsorption of CQ due to competitive adsorption. However, humic acid had little effect on this adsorption. Considering the apparent adsorption performance, the aforementioned effects of various factors and the spectroscopic characterizations, multi-interactions are suggested for adsorption including chelation, electrostatic interactions, π-π electron donor-acceptor interaction and hydrogen bonding. SA/TA showed a slight loss in adsorption capacity toward CQ and sustained physicochemical structural stability, even after six adsorption-desorption cycles. In addition to CQ, SA/TA could be efficiently used for adsorption of two other antivirus drugs, namely, hydroxychloroquine sulfate and oseltamivir phosphate. This work provides an effective strategy for the design and fabrication of novel adsorbents that can effectively adsorb antiviral drugs over a wide pH range.

Preparation of strong, tough and conductive soy protein isolate/poly(vinyl alcohol)-based hydrogel via the synergy of biomineralization and salting out

Conductive hydrogels have shown a great potential in the field of flexible electronic devices. However, conductive hydrogels prepare by traditional methods are difficult to combine high strength and toughness, which limits their application in various fields. In this study, a strategy for preparing conductive hydrogels with high strength and toughness by using the synergistic effect of biomineralization and salting-out was pioneered. In simple terms, by immersing the CaCl2 doped soy protein isolate/poly(vinyl alcohol)/dimethyl sulfoxide (SPI/PVA/DMSO) hydrogel in Na2CO3 and Na3Cit complex solution, the biomineralization aroused by Ca2+ and CO32-, and the salting-out effect of both NaCl and Na3Cit would enhance the mechanical properties of SPI/PVA/DMSO hydrogel. Meanwhile, the ionic conductivity of the hydrogel would also increase due the introduction of cation and anion. The mechanical and electrical properties of SPI/PVA/DMSO/CaCO3/Na3Cit hydrogels were significantly enhanced by the synergistic effect of biomineralization and salting-out. The optimum tensile strength, toughness, Young's modulus and ionic conductivity of the hydrogel were 1.4 ± 0.08 MPa, 0.51 ± 0.04 MPa and 1.46 ± 0.01 S/m, respectively. The SPI/PVA/DMSO/CaCO3/Na3Cit hydrogel was assembled into a strain sensor. The strain sensor had good sensitivity (GF = 3.18, strain in 20 %-500 %) and could be used to accurately detect various human movements.

Efficient antibacterial and dye adsorption by novel fish scale silver biochar composite gel

A silver-loaded carbon-chitosan-polyvinyl alcohol gel (C/CTS/PVA) was designed for suppressing microbial growth and dye adsorption. The antibacterial test results showed that C/CTS/PVA gel had a good antibacterial ability against Staphylococcus aureus, Escherichia coli, and Pseudomonas aeruginosa. The inhibition rate in water was 100 %, and the antibacterial rate remained above 95 % within 35 days after preparation. The tight spatial structure provided by the adhesive effect of PVA and CTS effectively prevented water loss and enhanced the stability of the gel. The adsorption curves of the gel were fitted by establishing the pseudo-first order and pseudo-second order kinetic models. The adsorption curves were more consistent with the pseudo-second-order kinetic model. The best adsorption effect for Malachite green was 128.12 mg/g. C/CTS/PVA gel had a remarkable adsorption effect on Malachite green, Congo red, Methyl orange, and Methylene blue. In general, C/CTS/PVA gels have great potential for the treatment of sewage in the future.

Natural and Natural-Based Polymers: Recent Developments in Management of Emerging Pollutants

Anthropogenic activities lead to the issue of new classes of pollutants in the environment that are not currently monitored in environmental studies. This category of pollutants (known as emerging contaminants) includes a very wide range of target substances, such as pharmaceuticals, plant protection products, personal care products, dyes, toxins, microplastics and many other industrially important intermediaries. Together with an increasing demand for clean water (both for agricultural necessities and for the increasing population consumption), the need for the removal of emerging pollutants, simultaneously with the current "green chemistry" approach, opens the door for the industrial application of natural polymers in the area of environmental protection. Recent developments in this area are presented in this paper, as well as the application of these particular natural materials for the removal of other contaminants of interest (such as radioisotopes and nanoparticles). The current knowledge regarding the processes' kinetics is briefly presented, as well as the future development perspectives in this area.