Evaluation of a new dispersion technique for assessing triboelectric charging of powders

Discrete Element Method Evaluation of Triboelectric Charging Due to Powder Handling in the Capsule of a DPI

The generation and accumulation of an electrostatic charge from handling pharmaceutical powders is a well-known phenomenon, given the insulating nature of most APIs (Active Pharmaceutical Ingredients) and excipients. In capsule-based DPIs (Dry Powder Inhalers), the formulation is stored in a gelatine capsule placed in the inhaler just before inhalation. The action of capsule filling, as well as tumbling or vibration effects during the capsule life cycle, implies a consistent amount of particle-particle and particle-wall contacts. A significant contact-induced electrostatic charging can then take place, potentially affecting the inhaler's efficiency. DEM (Discrete Element Method) simulations were performed on a carrier-based DPI formulation (salbutamol-lactose) to evaluate such effects. After performing a comparison with the experimental data on a carrier-only system under similar conditions, a detailed analysis was conducted on two carrier-API configurations with different API loadings per carrier particle. The charge acquired by the two solid phases was tracked in both the initial particle settling and the capsule shaking process. Alternating positive-negative charging was observed. Particle charging was then investigated in relation to the collision statistics, tracking the particle-particle and particle-wall events for the carrier and API. Finally, an analysis of the relative importance of electrostatic, cohesive/adhesive, and inertial forces allowed the importance of each term in determining the trajectory of the powder particles to be estimated.

Modelling Deaggregation Due to Normal Carrier–Wall Collision in Dry Powder Inhalers

Powder deaggregation in Dry Powder Inhalers (DPI) with carrier-based formulations is a key process for the effectiveness of drug administration. Carrier-wall collisions are one of the recognised mechanisms responsible for active pharmaceutical ingredient (API) aerosolisation, and DPI geometries are designed to maximise their efficacy. The detachment of fine and cohesive API particles is investigated at a fundamental level by simulating with DEM the normal collision of a carrier sphere with an API particle attached. The impact velocity at which detachment occurs (escape velocity) is determined as a function of key parameters, such as cohesiveness, coefficient of restitution, static and rolling friction. An analytical model for the escape velocity is then derived, examining the role of the initial position of the particle, cohesion model and particle size. Finally, the results are framed in the context of DPI inhalers, comparing the results obtained with impact velocities typically recorded in commercial devices.

Discrete Element Modeling (DEM) based investigation of tribocharging in the pharmaceutical powders during hopper discharge

Triboelectric charging is defined as the phenomenon of charge transfer between two different material surfaces when they are brought into contact and separated. The focus of this research is the development of a Discrete Element Method (DEM) based simulation model to predict tribocharging during hopper discharge. Due to decreased particle-wall interactions and reduced particle wall contact times, net charges generated during hopper discharge are low. The simulation model confirmed this effect and was implemented to predict the triboelectric behavior of glass beads and MCC particles during hopper flow, along with the prediction of percent charged and uncharged particles. Approximately one-third of the particles were predicted to remain uncharged during the hopper discharge simulations for mono-dispersed particles, thus rendering a comparatively high amount of charge distribution into a small concentration of materials. The DEM model acted as a tool to predict charges that can be generated during hopper discharge at a specified geometry, with a potential to mitigate particle charging, when used for appropriate selection of hopper angles, and hopper wall materials.