In situ monitoring of nanoparticle formation: Antisolvent precipitation of azole anti-fungal drugs

The Preparation of Apigenin Nanoparticles and the Study of Their Anti-Inflammatory and Anti-Tumor Activities In Vitro

Apigenin (API) has many biological activities, but its poor solubility limits its clinical application. In this research, API nanoparticles were prepared by the liquid antisolvent precipitation (LAP) technique, which effectively improved the solubility and bioavailability of API. Through the design of a single-factor test, the effects of the type and dosage of surfactants, API concentration, the antisolvent to solvent volume ratio, the speed and time of stirring, the temperature of precipitation, and the dropping speed on the MPS (mean particle size) of API nanosuspension were carried out. The optimum technological conditions were determined as follows: 5 mg/mL of tween 80 as a surfactant, 20 mg/mL of API, an antisolvent/solvent volume ratio of 10, a 1200 r/min stirring speed for 5 min, a 45 °C precipitation temperature, and a 1 mL/min dropping speed. Under the optimum conditions, we obtained API nanosuspension with 170.5 nm MPS and then it was freeze-dried to obtain the API nanoparticles. Moreover, we characterized the API nanoparticles by SEM, FTIR, XRD, DSC, and TG. Results showed that although API nanoparticles transformed into an amorphous form, their internal chemical structure had not been changed and had a higher solubility. Finally, API nanoparticles’ anti-inflammatory activities were evaluated by observing the effect of API on nitric oxide (NO) production and IL-10 production toward RAW264.7 cells induced by lipopolysaccharide (LPS). Moreover, the anti-tumor effect of API was determined by testing cell viability and apoptosis. The results suggested that API nanoparticles exhibited much better anti-inflammatory and anti-tumor activities compared to raw API.

Monitoring of particle sizes distribution during Valsartan precipitation in the presence of nonionic surfactant

Particle size is a key parameter when dealing with drug particle formation, delivery or dissolution. The correct measurement of particle size depends on various factors, such as sample preparation or dilution, but also on the choice of method for its characterization. In this work, we study the process of precipitation of poorly water-soluble drug Valsartan from supersaturated solution in the presence of nonionic surfactant Tween 20. Several techniques including dynamic light scattering (DLS) operated in several measuring modes, optical microscope (OM) and static light scattering (SLS) were used to analyze the kinetics of particle formation. As concluded by the results, the increase in turbidity of the solution seriously limits the application of classical DLS to properly measure the particle size and polydispersity. One way to get around this restriction is by dilution, which however results in a decrease in the size of Valsartan particles in the studied population. In contrast, here we present for a first time technique based on modulated 3D cross correlation DLS equipped with the sample goniometer to determine size of submicron particles of the drug in highly turbid solutions. Additionally, a modified OM was used to measure micron-sized particles for samples without any dilution in a continuous mode. Measured particle sizes combined with measured Valsartan concentration allowed us to identify mechanism responsible for the particle formation from supersaturated solutions. The main mechanism, as it is shown in this work, is covering surface of precipitate particles by the amount of used Tween 20.

Experimental study on the reduction of loratadine particle size through confined liquid impinging jets

The confined liquid impinging jets (CLIJ) technique was applied as a simple and effective approach to reducing the particle size of loratadine to enhance its solubility. The effect of anti-solvent (AS) to solution (S) flow rate ratio, organic phase concentration, Reynolds number (Re), and stabilizer concentration was investigated in this reduction process. After the synthesis, the chemical and physical properties of loratadine nanoparticles were determined through different characterization and analytical techniques. The results indicated that the particle size of loratadine decreases from 320 nm to 80 nm by increasing the AS/S ratio from 1 to 25. It was found that the particle size of loratadine was unchanged at the higher AS/S ratios. The loratadine nanoparticle size was optimized by changing the solution concentration, Re, and Tween 80 as a stabilizer. The finest loratadine nanoparticle size of about 53 nm was obtained with a narrow size distribution, which corresponds to solution concentration of 35 mg/mL, Re of 5687, and 0.1% (w/v) stabilizer concentration. It was revealed that the optimized loratadine nanoparticles completely dissolved after 11 min, indicating the loratadine nanoparticle dissolution rate 50 times faster than raw loratadine.

Isolation of Itraconazole Nanostructured Microparticles via Spray Drying with Rational Selection of Optimum Base for Successful Reconstitution and Compaction

The addition of matrix formers within a formulation provides a means for enhancing the redispersibility of nanoparticles (NPs) enabling them to retain their advantageous properties imparted onto them by their sub-micron size. In this work, NPs were isolated in the solid state via spray drying with a range of sugars. The processed powders were characterized, establishing that itraconazole (ITR) nanostructured microparticles (NMPs) spray dried in the presence of mannitol and trehalose had favorable redispersibility confirmed by dynamic light scattering and nanoparticle tracking analysis. Solid-state analysis confirmed the crystalline nature of NMPs based on mannitol and the amorphous character of trehalose-based NMPs. The NMPs powders were compacted at a range of pressures, producing tablets with high tensile strength without compromising their disintegration time. A greater amount of ITR was solubilized from trehalose NMPs compared to the mannitol-based compacts in 0.1 M HCl, showing a promise for enhanced in vivo activity. Overall, as trehalose exhibited superior carrier properties for ITR NMPs, this type of excipient included in the formulation warrants careful consideration. The structured approach to matrix former selection and tabletting studies can reduce the amount of material and time required for testing in the initial stages of product development.