Anion-dependent Hg 2+ -sensing of colorimetric (dppe)Pt(dmit) chemosensor (dppe: 1,2-bis(diphenylphosphino)ethane; dmit: 1,3-dithiole-2-thione-4,5-dithiolate)

cis/trans-[Pt(C∧N)(C≡CR)(CNBut)] Isomers: Synthesis, Photophysical, DFT Studies, and Chemosensory Behavior

cis/trans Isomerism can be a crucial factor for photophysical properties. Here, we report the synthesis and optical properties of a series of trans- and cis-alkynyl/isocyanide cycloplatinated compounds [Pt(C^∧N)(C≡CR)(CNBu^t)] [R = C₆H₄-4-OMe 1, 3-C₄H₃S 2; C^∧N = 2-(2,4-difluorophenyl)pyridine (dfppy) (a), 4-(2-pyridyl)benzaldehyde (ppy-CHO) (b)]. The trans-forms do not isomerize thermally in MeCN solution to the cis forms, but upon photochemical irradiation in this medium at 298 K, a variable isomerization to the cis forms was observed. This behavior is in good agreement with the theoretically calculated energy values. The trans/cis configuration, the identity of the cyclometalated, and the alkynyl ligand influence on the absorption and emission properties of the complexes in solution, polystyrene (PS) films, and solid state are reported. All complexes are efficient triplet emitters in all media (except for trans-1a and trans-2a in CH₂Cl₂ solution at 298 K), with emission wavelengths depending mainly on the cyclometalated ligand in the region 473-490 nm (dfppy), 510-550 (ppy-CHO), and quantum yields (ϕ) ranging from 18.5 to 40.7% in PS films. The combined photophysical data and time-dependent density functional theory calculations (TD-DFT) at the excited-state T₁ geometry reveal triplet excited states of ³L'LCT (C≡CR → C^∧N)/³IL (C^∧N) character with minor ³MLCT contribution. The dfppy (a) complexes show a greater tendency to aggregate in rigid media than the ppy-CHO (b) and the cis with respect to the trans, showing red-shifted structureless bands of ³MMLCT and/or excimer-like nature. Interestingly, trans-1a,2a and cis-1a,2a undergo significant changes in the ultraviolet (UV) and emission spectra with Hg²⁺ ions enabling their use for sensing of Hg²⁺ ions in solution. This is clearly shown by the hypsochromic shift and substantial decrease of the low-energy absorption band and an increase of the intensity of the emission in the MeCN solution upon the addition of a solution of Hg(ClO₄)₂ (1:5 molar ratio). Job's plot analysis estimated a 1:1 stoichiometry in the complexation mode of Hg²⁺ by trans-2a. The binding constant (log K) calculated for this system from absorption titration data resulted to be 2.56, and the limit of the detection (LOD) was 6.54 × 10^-7 M.

Heteroleptic Pt(II)-dithiolene-based Colorimetric Chemosensors: Selectivity Control for Hg(II) Ion Sensing

Hg²⁺ ions can accumulate in the natural environment and in organisms, where they cause damage to the central nervous system. Therefore, the detection of Hg²⁺ ions is essential for monitoring environmental contamination and human health. Herein, we demonstrate a simple method for tuning chemosensor signal ratios that significantly increased chemosensor selectivity for Hg²⁺ detection. Selectivity tuning was accomplished for chemosensors of the type (diphosphine)Pt(dmit), bearing the two different terminal groups 1,2-bis(diphenylphosphino)ethane (dppe) and 1,2-bis[bis(pentafluorophenyl)phosphino]ethane) (dfppe) due to the modulation of specific intermolecular interactions between the dmit ligand and Hg²⁺ ion. The structure exhibited a large pseudo-Stokes shift, which was advantageous for the internal reference signal and for eliminating potential artifacts. Straightforward chain-end manipulation enabled the tuning of chemosensor properties without additional chemical alterations. Based on these findings, we propose a new platform for improving the selectivity and sensitivity of colorimetric cation sensors. The results of this study will facilitate the designing of organic materials whose certain properties can be enhanced through precise control of the materials’ chemical hybridization by simple functional end-group manipulation.