Starch-fueled microbial fuel cells by two-step and parallel fermentation using Shewanella oneidensis MR-1 and Streptococcus bovis 148

Expansion of carbon source utilization range of Shewanella oneidensis for efficient azo dye wastewater treatment through co-culture with Lactobacillus plantarum

Shewanella oneidensis has demonstrated excellent potential for azo dye decolorization and degradation. However, in anaerobic environments, S. oneidensis has a narrow carbon source spectrum, which requires additional electron donors, such as sodium lactate. This increases the practical application costs for wastewater treatment. Here, we aimed to expand the carbon source utilization range of S. oneidensis FJAT-2478 by co-culturing it with Lactobacillus plantarum FJAT-7926, leveraging their commensalism relationship to develop a metabolic chain. Results showed that a 1:2 initial ratio of L. plantarum FJAT-7926 to S. oneidensis FJAT-2478 achieved a 97.16% decolorization rate of methyl orange when glucose served as the sole carbon source. This co-culture system achieved a decolorization rate comparable to that obtained using sodium lactate as an electron donor and was significantly higher than that achieved by L. plantarum FJAT-7926 (7.88%) or S. oneidensis FJAT-2478 (6.89%) alone. After undergoing five cycles, the co-culture system continued to exhibit effective decolorization. It was demonstrated that the co-culture system could use common and inexpensive carbon sources, such as starch, molasses, sucrose, and maltose, to decolorize azo dyes. For instance, 100 mg/L methyl orange could be degraded by over 98.05% within 24 h. The results indicated that the degradation rates of methyl orange were higher when L. plantarum was inoculated first, followed by a subsequent inoculation of S. oneidensis after 2 h. The co-culturing of L. plantarum FJAT-7926 and S. oneidensis FJAT-2478 proved to be an effective strategy in treating azo dye wastewater, expanding the potential practical applications of S. oneidensis.

Microbial fuel cells using α-amylase-displaying Escherichia coli with starch as fuel

Escherichia coli JM109 (pGV3-SBA) can assimilate starch by fusing the starch-digesting enzyme α-amylase from Streptococcus bovis NRIC1535 to an OprI' lipoprotein anchor on the cell membrane. This study shows microbial fuel cells (MFCs) development using this recombinant type of E. coli and starch as fuel. We observed the current generation of MFCs with E. coli JM109 (pGV3-SBA) for 120 h. During this period, it consumed 7.1 g/L of starch. A mediator in the form of anthraquinone-2,6-disulfonic acid disodium salt at 0.2, 0.4, and 0.8 mM was added to the MFCs. The highest maximum-current density (271 mA/m²) and maximum-power density (29.3 mW/m²) performances occurred in the 0.4 mM mediator solution. Coulomb yields were calculated as 3.4%, 3.0%, and 3.5% in 1.0, 5.0, and 10.0 g/L of initial starch, respectively. The concentrations of acetic acid, succinic acid, fumaric acid, and ethanol as metabolites were determined. In particular, 38.3 mM of ethanol was produced from 7.1 g/L of starch. This study suggests the use of recombinant E. coli which can assimilate starch present in starch-fueled MFCs. Moreover, it proposes the possibility of gene recombination technology for using wide variety of biomass as fuel and improving MFC's performance.

Engineering S. oneidensis for Performance Improvement of Microbial Fuel Cell-a Mini Review

Microbial fuel cell (MFC) is a promising technology that utilizes exoelectrogens cultivated in the form of biofilm to generate power from various types of sources supplied. A metal-reducing pathway is utilized by these organisms to transfer electrons obtained from the metabolism of substrate from anaerobic respiration extracellularly. A widely established model organism that is capable of extracellular electron transfer (EET) is Shewanella oneidensis. This review highlights the strategies used in the transformation of S. oneidensis and the recent development of MFC in terms of intervention through genetic modifications. S. oneidensis was genetically engineered for several aims including the study on the underlying mechanisms of EET, and the enhancement of power generation and wastewater treating potential when used in an MFC. Through engineering S. oneidensis, genes responsible for EET are identified and strategies on enhancing the EET efficiency are studied. Overexpressing genes related to EET to enhance biofilm formation, mediator biosynthesis, and respiration appears as one of the common approaches.

Direct electron transfer of Cellulomonas fimi and microbial fuel cells fueled by cellulose

The strain of Cellulomonas fimi NBRC 15513 can generate electricity with cellulose as fuel without mediator using a single chamber type microbial fuel cell (MFC) which had 100 mL of chamber and 50 cm² of the air cathode. The MFCs were operated over five days and showed the maximum current density of 10.0 ± 1.8 mA/m², the maximum power density of 0.74 ± 0.07 mW/m² and the ohmic resistance of 6.9 kΩ. According to the results of cyclic voltammetry, the appearance of the oxidation or reduction peak was not observed from the cell removed solution. The fact is that C. fimi does not secrete mediator-like compounds, while the oxidation peak was observed at +0.68 V from the phosphate buffer containing the washed cell. The peak appearance was caused by the electron transfer activity of which corresponds to cytochrome c, and disappeared after adding antimycin A which inhibits the electron transfer activity. The cell was alive throughout the experiment as the result of a colony forming unit on Luria-Bertani agar plates. This was thought that cytochrome c was on the membrane surface of the living cell and played a role in the direct electron transfer between the cells and anode.

Novel Gas Diffusion Cloth Bioanodes for High-Performance Methane-Powered Microbial Fuel Cells

Microbial fuel cells (MFCs) are a promising technology that converts chemical energy into electricity. However, up to now only few MFCs have been powered by gas fuels, such as methane, and their limited performance is still challenged by the low solubility and bioavailability of gases. Here, we developed a gas diffusion cloth (GDC) anode to significantly enhance the performance of methane-powered MFCs. The GDC anode was constructed by simply coating waterproof GORE-TEX cloth with conductive carbon cloth in one step. After biofilm enrichment, the GDC anodes obtained a methane-dependent current up to 1130.2 mA m^-2, which was 165.2 times higher than conventional carbon cloth (CC) anodes. Moreover, MFCs equipped with GDC anodes generated a maximum power density of 419.5 mW m^-2. Illumina high-throughput sequencing revealed that the GDC anode biofilm was dominated mainly by Geobacter, in contrast with the most abundant Methanobacterium in planktonic cells. It is hypothesized that Methanobacterium reversed the methanogenesis process by transferring electrons to the anodes, and Geobacter generated electricity via the intermediates (e.g., acetate) of anaerobic methane oxidation. Overall, this work provides an effective route in preparing facile and cost-effective anodes for high-performance methane MFCs.

Microbial fuel cells equipped with an iron-plated carbon-felt anode and Shewanella oneidensis MR-1 with corn steep liquor as a fuel

A single chamber type microbial fuel cell (MFC) with 100 mL of chamber volume and 50 cm² of air-cathode was developed in this study wherein a developed iron-plated carbon-felt anode and Shewanella oneidensis MR-1 were used. The performance of the iron-plated carbon-felt anode and the possibility of corn steep liquor (CSL) as a fuel, which was the byproduct of corn wet milling and contained lactic acid, was investigated here. MFCs equipped with iron-plated or non-plated carbon-felt anodes exhibited maximum current densities of 443 or 302 mA/m² using 10 g/L of reagent-grade lactic acid, respectively. In addition, using centrifuged CSL without insoluble ingredients or non-centrifuged CSL as a fuel, the maximum current densities of the MFCs with iron-plated carbon-felt anode were 321 or 158 mA/m², respectively. This report demonstrated the effect of iron-plated carbon-felt anode for electricity generation of MFC using S. oneidensis MR-1 and the performance of CSL as a fuel.