Photocatalytic abatement of trichlorethylene over Au and Pd–Au supported on TiO2 by combined photomineralization/hydrodechlorination reactions under simulated solar irradiation

Photocatalytic removal of trichloroethylene from water with LaFeO3

Tricholorethylene (TCE) has been recognized as second common organic pollutant found in groundwater in Taiwan. Several advanced oxidation processes (AOPs) have been applied for TCE removal and photocatalytic is one of promising AOP techniques. In this study, LaFeO₃ is successfully synthesized via sol-gel method and investigated for its photocatalytic oxidation rate toward TCE in water. Experimental results indicate that 95% removal efficiency of TCE can be achieved in aqueous solution with LaFeO₃ (2 g/L) as photocatalyst within 1 h of Xenon lamp illumination. Additionally, the influences of initial TCE concentration, light intensity, photocatalyst loading, and pH value on the TCE removal efficiency are evaluated as well. The highest energy efficiency obtained in this study is 10.8 mg TCE/kWh and the value is higher than those reported in previous studies. Besides, removal mechanisms have been identified and the results indicate that the overall removal efficiency reaches 82%, with adsorption and photolysis accounting for 20% and 39%, respectively.

Catalytic Hydrodechlorination of Chlorophenols in a Continuous Flow Pd/CNT-Ni Foam Micro Reactor Using Formic Acid as a Hydrogen Source

Catalytic hydrodechlorination (HDC) has been considered as a promising method for the treatment of wastewater containing chlorinated organic pollutants. A continuous flow Pd/carbon nanotube (CNT)-Ni foam micro reactor system was first developed for the rapid and highly efficient HDC with formic acid (FA) as a hydrogen source. This micro reactor system, exhibiting a higher catalytic activity of HDC than the conventional packed bed reactor, reduced the residence time and formic acid consumption significantly. The desired outcomes (dichlorination >99.9%, 4-chlorophenol outlet concentration <0.1 mg/L) can be obtained under a very low FA/substrate molar ratio (5:1) and short reaction cycle (3 min). Field emission scanning electron microcopy (FESEM) and deactivation experiment results indicated that the accumulation of phenol (the main product during the HDC of chlorophenols) on the Pd catalyst surface can be the main factor for the long-term deactivation of the Pd/CNT-Ni foam micro reactor. The catalytic activity deactivation of the micro reactor could be almost completely regenerated by the efficient removal of the absorbed phenol from the Pd catalyst surface.

Particularities of photocatalysis and formation of reactive oxygen species on insulators and semiconductors: cases of SiO2, TiO2 and their composite SiO2–TiO2

Highly defected tubular SiO₂ outperforms the photocatalytic activity of TiO₂-P25 and the SiO₂–TiO₂ composite.