Reaction dynamics of metal/oxide catalysts: Methanol oxidation at vanadium oxide films on Rh(1 1 1) from UHV to 10−2 mbar

In situ Low-Energy Electron Microscopy of Chemical Waves on a Composite V-oxide/Rh(110) Surface

Chemical wave patterns and V-oxide redistribution in catalytic methanol oxidation on a VOx/Rh(110) surface have been investigated in the 10-4 mbar range with low-energy electron microscopy (LEEM) and micro spot low-energy electron diffraction (micro-LEED) as in situ methods. V coverages of θV=0.2 and 0.4 MLE (monolayer equivalents) were studied. Pulses display a c(2×2) pattern in the reduced part and (1×2) and c(2×8) structures in the oxidized part of the surface. At θV=0.4 MLE (1×2)/(1×4) patterns with streaks along the [001]-direction at the 1/8 positions are present on the oxidized part of the surface. This phase can be assigned to V-oxide. On a tentative basis, an excitation mechanism for pulses is presented, Annealing the surface to 990 K under reaction conditions results in a macroscopic hole pattern in which holes of low VOx coverage are surrounded by a V-oxide layer. Chemical waves propagate inside the holes as well as on the VOx covered parts of the surface. The results demonstrate for the first time that also in supported oxidic overlayers selforganization processes can take place leading to chemical waves and a large scale redistribution of the oxide.

Modulation of Surface Ti-O Species in 2D-Ti3C2TX MXene for Developing a Highly Efficient Electrocatalyst for Hydrogen Evolution and Methanol Oxidation Reactions

Developing cost-effective and earth-abundant noble-metal-free electrocatalysts is imperative for the imminent electrochemical society. Two-dimensional Ti₃C₂T_X (MXene) exhibits tunable properties with high electrical conductivity and a large specific surface area, which improve its electrochemical performance. Herein, the low-temperature annealing method is used to enrich MXene with a maximum number of Ti-O terminals without formation of titanium dioxide (TiO₂) under neutral pH conditions. MXene annealed at 200 °C is found to have a large number of Ti-O termination groups, resulting in a large electrochemically active surface area and increased active sites (-O termination groups) and hence excellent electrocatalytic performance compared to other samples as well as previous reported work. The optimized sample is found to show the lowest overpotential value of 0.07 V at 10 mA cm^-2 and a Tafel slope of 0.15 V dec^-1 toward the hydrogen evolution reaction (HER), whereas for the methanol oxidation reaction (MOR), the current density is 18.08 mA cm^-2, and the onset potential is -0.51 V. In addition, it also shows long-term stability and durability toward HER as well as MOR.

Reactivity and Stability of Ultrathin VOx Films on Pt(111) in Catalytic Methanol Oxidation

The growth of ultrathin layers of VOx (< 12 monolayers) on Pt(111) and the activity of these layers in catalytic methanol oxidation at 10−4 mbar have been studied with low-energy electron diffraction, Auger electron spectroscopy, rate measurements, and with photoemission electron microscopy. Reactive deposition of V in O2 at 670 K obeys a Stranski–Krastanov growth mode with a (√3 × √3)R30° structure representing the limiting case for epitaxial growth of 3D-VOx. The activity of VOx/Pt(111) in catalytic methanol oxidation is very low and no redistribution dynamics is observed lifting the initial spatial homogeneity of the VOx layer. Under reaction conditions, part of the surface vanadium diffuses into the Pt subsurface region. Exposure to O2 causes part of the V to diffuse back to the surface, but only up to one monolayer of VOx can be stabilized in this way at 10−4 mbar.

Dynamics of Ultrathin Vanadium Oxide Layers on Rh(111) and Rh(110) Surfaces During Catalytic Reactions

Over the past 35 years rate oscillations and chemical wave patterns have been extensively studied on metal surfaces, while little is known about the dynamics of catalytic oxide surfaces under reaction conditions. Here we report on the behavior of ultrathin V oxide layers epitaxially grown on Rh(111) and Rh(110) single crystal surfaces during catalytic methanol oxidation. We use photoemission electron microscopy and low-energy electron microscopy to study the surface dynamics in the 10^-6 to 10^-2 mbar range. On VO _x /Rh(111) we find a ripening mechanism in which VO _x islands of macroscopic size move toward each other and coalesce under reaction conditions. A polymerization/depolymerization mechanism of VO _x that is sensitive to gradients in the oxygen coverage explains this behavior. The existence of a substructure in VO _x islands gives rise to an instability, in which a VO _x island shrinks and expands around a critical radius in an oscillatory manner. At 10^-2 mbar the VO _x islands are no longer stable but they disintegrate, leading to turbulent redistribution dynamics of VO _x . On the more open and thermodynamically less stable Rh(110) surface the behavior of VO _x is much more complex than on Rh(111), as V can also populate subsurface sites. At low V coverage, one finds traveling interface pulses in the bistable range. A state-dependent anisotropy of the surface is presumably responsible for intriguing chemical wave patterns: wave fragments traveling along certain crystallographic directions, and coexisting different front geometries in the range of dynamic bistability. Annealing to 1000 K causes the formation of macroscopic VO _x islands. Under more reducing conditions dendritic growth of a VO _x overlayer is observed.