Capillary electrophoresis with UV detection and mass spectrometry in method development for profiling metabolites of steroid hormone metabolism

Biomaterials and advanced technologies for the evaluation and treatment of ovarian aging

Ovarian aging is characterized by a progressive decline in ovarian function. With the increase in life expectancy worldwide, ovarian aging has gradually become a key health problem among women. Over the years, various strategies have been developed to preserve fertility in women, while there are currently no clinical treatments to delay ovarian aging. Recently, advances in biomaterials and technologies, such as three-dimensional (3D) printing and microfluidics for the encapsulation of follicles and nanoparticles as delivery systems for drugs, have shown potential to be translational strategies for ovarian aging. This review introduces the research progress on the mechanisms underlying ovarian aging, and summarizes the current state of biomaterials in the evaluation and treatment of ovarian aging, including safety, potential applications, future directions and difficulties in translation.

Development of transient trapping micellar electrokinetic chromatography coupled with mass spectrometry for steroids analysis

An on-line sample preconcentration technique based on transient trapping (tr-trapping) in micellar electrokinetic chromatography (MEKC) was applied for steroid detection with UV (tr-trapping-UV) and electrospray ionization mass spectrometry detection (tr-trapping-ESI-MS). ESI-MS was used to improve the sensitivity in MEKC. The MEKC separation was carried out using volatile ammonium formate as a background solution to facilitate the coupling with ESI-MS. The partial introduction of a sodium dodecyl sulfate (SDS) micellar solution before the introduction of a sample solution to the capillary provided the effective preconcentration of analytes. At the same time, the SDS micelle would not enter the ESI-MS system, so its interference in ESI-MS detection was suppressed under the optimal condition, then five steroids can be separated by the developed method. In tr-trapping-ESI-MS, an acidic condition of pH 3.5 was employed to suppress the electroosmotic flow, which can avoid micellar solution migrating to the MS instrument. The developed method showed that the micellar solution requires a twofold slower time than the sample to migrate along the column, which can prohibit the cause of the problem with the MS instrument and interference signal of SDS in the steroid's detection. The tr-trapping-ESI-MS protocol showed up to 540-fold enhancements of the peak intensity and 50-fold improvement of the limit of detection compared with capillary zone electrophoresis using androsterone as a model sample.

Androgens, oestrogens, and progesterone concentrations in wastewater purification processes measured with capillary electrophoresis

A novel analytical-scale concept to improve reliability of detection and analysis of natural and processed wastewater samples from a purification plant was developed. A sequential sample clean-up system of polymer-based octadecyl and silane-based quaternary amine sorbents were used for concentrating human based steroid hormones and their metabolites and detecting them by UV absorption with capillary electrophoresis (CE). The water samples were collected from influent and effluent processes of the water purification plant in Helsinki, Finland.The CE methods were partial-filling micellar electrokinetic chromatography and capillary zone electrophoresis. The analysis times and method concentration levels were optimized with eight steroids at the range of 0.5-10 mg/L. Since in CE the detectable quantities were higher than the existing amounts in the process waters, the real samples needed matrix removal combined with steroid enrichment. After 20,000-fold concentration testosterone-glucoside, androstenedione, progesterone, and estradiol-glucoside could be determined in the process water samples. The amounts of individual steroids in influent and effluent waters were 0-429 and 0-207 ng/L, respectively. Correspondently, their total amounts were 735 and 212 ng/L with excellent in day and inter-day repeatability. The RSD values were less than 1, 9.7, and 19% in repeated analyses, calculated from 60 analyses during 24 h, and from 130 analyses during 15 months, respectively. The steroid removal in purification process was 65% on average. The solid particles separated in three steps during the water clean-up concept contained 9.8-45 ng/g steroids in combined dry precipitates.

Determination of ultra-trace catecholamines based on hot electron-induced cathodic electrochemiluminescence at a naturally oxide-covered tantalum electrode

A naturally oxide-covered tantalum electrode is firstly used in the detection of ultra-trace catecholamines based on hot electron-induced cathodic electrochemiluminescence with extremely low background, excellent sensitivity and perfect stability.

Novel two wavelength spectrophotometric methods for simultaneous determination of binary mixtures with severely overlapping spectra

This work presents the application of different spectrophotometric techniques based on two wavelengths for the determination of severely overlapped spectral components in a binary mixture without prior separation. Four novel spectrophotometric methods were developed namely: induced dual wavelength method (IDW), dual wavelength resolution technique (DWRT), advanced amplitude modulation method (AAM) and induced amplitude modulation method (IAM). The results of the novel methods were compared to that of three well-established methods which were: dual wavelength method (DW), Vierordt's method (VD) and bivariate method (BV). The developed methods were applied for the analysis of the binary mixture of hydrocortisone acetate (HCA) and fusidic acid (FSA) formulated as topical cream accompanied by the determination of methyl paraben and propyl paraben present as preservatives. The specificity of the novel methods was investigated by analyzing laboratory prepared mixtures and the combined dosage form. The methods were validated as per ICH guidelines where accuracy, repeatability, inter-day precision and robustness were found to be within the acceptable limits. The results obtained from the proposed methods were statistically compared with official ones where no significant difference was observed. No difference was observed between the obtained results when compared to the reported HPLC method, which proved that the developed methods could be alternative to HPLC techniques in quality control laboratories.

Optimization of a pre-MEKC separation SPE procedure for steroid molecules in human urine samples

Many steroid hormones can be considered as potential biomarkers and their determination in body fluids can create opportunities for the rapid diagnosis of many diseases and disorders of the human body. Most existing methods for the determination of steroids are usually time- and labor-consuming and quite costly. Therefore, the aim of analytical laboratories is to develop a new, relatively low-cost and rapid implementation methodology for their determination in biological samples. Due to the fact that there is little literature data on concentrations of steroid hormones in urine samples, we have made attempts at the electrophoretic determination of these compounds. For this purpose, an extraction procedure for the optimized separation and simultaneous determination of seven steroid hormones in urine samples has been investigated. The isolation of analytes from biological samples was performed by liquid-liquid extraction (LLE) with dichloromethane and compared to solid phase extraction (SPE) with C18 and hydrophilic-lipophilic balance (HLB) columns. To separate all the analytes a micellar electrokinetic capillary chromatography (MECK) technique was employed. For full separation of all the analytes a running buffer (pH 9.2), composed of 10 mM sodium tetraborate decahydrate (borax), 50 mM sodium dodecyl sulfate (SDS), and 10% methanol was selected. The methodology developed in this work for the determination of steroid hormones meets all the requirements of analytical methods. The applicability of the method has been confirmed for the analysis of urine samples collected from volunteers--both men and women (students, amateur bodybuilders, using and not applying steroid doping). The data obtained during this work can be successfully used for further research on the determination of steroid hormones in urine samples.

A simple TLC and HPTLC method for separation of selected steroid drugs

Chromatographic properties of five steroid drugs: cortisone, hydrocortisone, methylprednisolone, prednisolone and norgestrel have been studied by normal-, reversed-phase and hydrophilic neutral cyano-bonded silica stationary phase with five binary mobile phases (acetonitrile-water, acetonitrile-DMSO, acetonitrile-methanol, acetone-petroleum ether, acetone-water) in which the concentration of organic modifier was varied from 0 to 100% (v/v). This study reports the optimization of steroid hormones separation. Chromatographic retention data and possible retention mechanisms are discussed. Separation abilities of mobile and stationary phases were studied using the principal component analysis method. The best separation of methylprednisolone and prednisolone is with a chromatographic system included silica gel as stationary phase and mixture of acetonitrile and DMSO (10:90 v/v). These two anti-inflammatory drugs can be fast separated from norgestrel when CN is used as stationary phase and acetone and water (40:60 v/v) as mobile phase. The highest values of the parameter Δ(ΔG°) and alfa for cortisone and hydrocortisone was observed in case of using CN as stationary phase and water-acetonitryle (40:60 v/v) as mobile phase.

Steroid profiles as potential biomarkers in patients with urogenital tract cancer for diagnostic investigations analyzed by liquid chromatography coupled to mass spectrometry

Large discrepancy remains for the hormone-responsible cancers with regards to the conditions generating the optimal opportunity for cancerogenesis. In the research, altered steroid profiles were observed in patients with urogenital tract cancer diseases, namely bladder, kidney, prostate and testis ones. The presented steroid profiles from 154 subjects, including 77 urogenital tract cancer patient and 77 healthy controls were determined by liquid chromatography coupled to mass spectrometry method. Because the original experimental data obtained as a result of analytical experiment in order to interpret them in better way required the appropriate pre-treatment, the data were standardized by scaling and centering. In order to determine which samples form a collection for a high-capacity predictive model, Kennard-Stone's algorithm was used. A principal component analysis of preprocessed data provided better consistency of the steroid profiles with health status of subjects than PCA profiles without data preprocessing and showed a tendency to separate clusters of cancer patients from healthy subjects. The discriminant analysis was also performed and the percent of correct classification of cancer patients and control group was calculated. Finally, detailed studies examined the role of steroid profiles measured in urine, and considered as potential biomarkers related to urogenital cancer and associated renal dysfunctions.

Capillary electrophoresis-mass spectrometry analysis of trehalose-6-phosphate in Arabidopsis thaliana seedlings

Trehalose-6-phosphate (T6P) is an intermediate in the plant metabolic pathway that results in trehalose production. T6P has been shown to inhibit the sucrose nonfermenting-1-related protein kinase 1, which is a major regulator of metabolism. The quantitation of T6P has proven difficult due to the complexity of the plant matrix and the low abundance of T6P in plant tissues. The aim of this work was to develop a quantitation method for T6P present in Arabidopsis tissues, with capillary electrophoresis (CE) coupled to electrospray ionization-mass spectrometry (MS) with a sheath liquid (SL) interface. The CE-MS method was first optimized with respect to T6P signal intensity and separation of isomers by studying the composition of the background electrolyte (BGE) and SL. The use of triethylamine (TEA) in the BGE was favorable, providing separation of T6P from sucrose-6-phosphate and minimizing ionization suppression. Replacing ammonium acetate with TEA enhanced T6P signal intensities more than four times. The optimized method allowed quantification of T6P in plant extracts with good linearity (r² > 0.99) within a biologically relevant concentration range. The limit of quantification was 80 nM in Arabidopsis extracts, corresponding to 33 pmol/g plant fresh weight. The CE-MS method was applied to the determination of T6P in seedlings from wild type (WT) Arabidopsis and mutants lacking the trehalase AtTRE1, tre1-1, challenged with trehalose or sorbitol. T6P accumulation in tre1-1 plants grown on sorbitol was about twice the level of T6P found in WT. CE-MS is shown to be a fast and reliable technique to analyze phosphodisaccharides for seedling extracts. The low sample volume requirement of CE and its direct MS coupling makes it an attractive alternative for anion-exchange liquid chromatography–MS.

Capillary electrophoresis as a metabolomics tool for non-targeted fingerprinting of biological samples

Metabolomics, understood as a data driven strategy trying to find markers of a situation under study without a priori hypothesis, has rapidly caught the attention and evolved from the simple pattern recognition strategy, which was a great innovation at its origins, to the interest for the final identification of markers responsible for class separation, i.e., from data to knowledge. Due to differences in physico-chemical properties and concentrations of the metabolites, but also due to differences in matrix properties, cross-platform approaches are proving to increase the capability of information. Once more techniques do not compete. This is the scene where capillary electrophoresis (CE) has its niche to provide information mainly on polar or ionic compounds in biological fluids. General advantages and disadvantages of CE for sample fingerprinting will be discussed and methods will be classified depending on the detection system (UV or MS) as this strongly affects all the conditions. Recent developments will be presented in different biological fluids, although urine is without a doubt the preferred sample for CE analysis.

A capillary electrochromatography-electron spray ionization-mass spectrometry method for simultaneous analysis of charged and neutral constituents of a hepatocarcinoma cell metabolome

Although metabolome research is a rapidly expanding field in the postgenomic era, no single method exists for complete analysis of all the constituents of a metabolome. In this study, we developed a metabolome analysis method using a combination of capillary electrochromatography and electrospray ionization-mass spectrometry. The capillary electrochromatography column was prepared by surface modification of silica compounds (tetraethoxysilane and octyltriethoxysilane) in a fused-silica capillary column. The method was used to separate more than 100 charged and neutral compounds simultaneously. When 1 mM formic acid was used as the eluent, the cationic compounds were eluted rapidly, and then neutral and anionic compounds were eluted (in that order). The developed system was used to analyze the metabolome of a human hepatocellular carcinoma cell line (HepG2). Thirty-three peaks were detected, and eighteen compounds were identified, including marker compounds of hepatocellular cell activity, such as creatinine and homocysteine. Thus, the system was useful not only for metabolome analysis but also for diagnostic measurements of cell function.