Analysis of opiates in urine using microextraction by packed sorbent and gas Chromatography- Tandem mass spectrometry

Comprehensive overview of analytical and bioanalytical methodologies for the opioid analgesics - Tramadol and combinations

Synthetic opioids like Tramadol are used to treat mild to moderate pain. Its ability to relieve pain is about a tenth that of morphine. Furthermore, Tramadol shares similar effects on serotonin and norepinephrine to several antidepressants known as serotonin-norepinephrine reuptake inhibitors (SNRIs), such as venlafaxine and duloxetine. The present review paper discusses the recent developments in analytical methods for identifying drugs in pharmaceutical preparations and toxicological materials, such as blood, saliva, urine, and hair. In recent years, a wide variety of analytical instruments, including capillary electrophoresis, NMR, UV-visible spectroscopy, HPTLC, HPLC, LC-MS, GC, GC-MS, and electrochemical sensors, have been used for drug identification in pharmaceutical preparations and toxicological samples. The primary quantification techniques currently employed for its quantification in various matrices are highlighted in this research.

Nickel oxide nanoparticles modified with dimethylglyoxime grafted on a cellulose surface as an efficient adsorbent for thin film microextraction of tramadol in biological fluids followed by its determination using HPLC

In the current study, nickel oxide nanoparticles (NiO NPs) modified with dimethylglyoxime (DMG) were deposited onto the cellulose surface (Ni(DMG)2-NiO-Cell) and used as an efficient adsorbent for thin film microextraction (TFME) of tramadol (TRA). The extracted TRA was determined using a high-performance liquid chromatography-ultraviolet detector (HPLC-UV). NiO NPs were synthesized by co-precipitation method on the surface of the cellulose substrate; afterward, its surface was modified by DMG to increase the extraction capability of the thin film toward TRA. The synthesized NiO-Cell and Ni(DMG)2-NiO-Cell thin films were characterized using various techniques. The effect of modification of the NiO thin film with DMG reagent on the extraction efficiency was investigated. The crucial parameters influencing the extraction efficiency, including extraction time, desorption time, desorption solvent, pH and salt content, were investigated via a one-at-a-time approach. The figures of merit for the developed method were evaluated in urine, plasma, and deionized water under the optimized extraction and desorption condition. The limits of detection and limits of quantification were in the range of 0.1 to 1 ng mL-1 and 0.3 to 3 ng mL-1, respectively, for the studied samples. The linear dynamic ranges of the developed TFME-HPLC-UV method were 0.3-1000, 1-2500, and 3-5000 ng mL-1 for the deionized water, urine, and plasma samples, respectively. The reproducibility and repeatability of the developed method was assayed in terms of intra-day, inter-day, and inter-thin film precisions by conducting six-replicate experiments at the concentration level of 0.1 and 1 μg mL-1, which were in the range of 5.9% to 8.3%. The sufficiency and applicability of the developed TFME-HPLC-UV method was investigated by determining TRA in urine and plasma samples, and the resulting relative recoveries (RR%) were 85.9% and 91.7%, respectively.

Automated and semi-automated packed sorbent solid phase (micro) extraction methods for extraction of organic and inorganic pollutants

In this study, the packed sorbent solid phase (micro) extraction methods from manual to automated modes are reviewed. The automatic methods have several remarkable advantages such as high sample throughput, reproducibility, sensitivity, and extraction efficiency. These methods include solid-phase extraction, pipette tip micro-solid phase extraction, microextraction by packed sorbent, in-tip solid phase microextraction, in-tube solid phase microextraction, lab-on-a-chip, and lab-on-a-valve. The recent application of these methods for the extraction of organic and inorganic compounds are discussed. Also, the combination of novel technologies (3D printing and robotic platforms) with the (semi)automated methods are investigated as the future trend.

Mixed-mode cationic exchange sorptive tapes combined with direct infusion mass spectrometry for determining opioids in saliva samples

This article describes the synthesis of mixed-mode cationic exchange (MCX) tapes as sorptive phases in bioanalysis, and it faces the determination of methadone and tramadol in saliva as the model analytical problem. The tapes are synthesized using aluminum foil as substrate, which is subsequently covered with double-sided adhesive tape where the MCX particles (ca. 1.4 ± 0.2 mg) finally adhere. MCX particles allow the extraction of the analytes at the physiological pH, where both drugs are positively charged, minimizing the potential co-extraction of endogenous matrix compounds. The extraction conditions were studied considering the main variables (e.g. ionic strength, extraction time, sample dilution). Under the optimum conditions and using direct infusion mass spectrometry as the instrumental technique, detection limits as low as 3.3 μg·L^-1 were obtained. The precision calculated at three different levels, and expressed as relative standard deviation, was better than 3.8%. The accuracy, expressed as relative recoveries, ranged from 83 to 113%. The method was finally applied to determine tramadol in saliva samples from patients under medical treatment. This approach opens the door to easily preparing sorptive tapes based on commercial (or ad-hoc synthesized) sorbent particles.

Microextraction by Packed Sorbent as a Clean-up Approach for the Determination of Ketamine and Norketamine in Hair by Gas Chromatography--Tandem Mass Spectrometry

The use of new psychoactive substances has been increasing and constitutes a social and public health problem, and hence, toxicological analysis has become of utmost importance for the detection of such substances. In this article, we present the development and full validation of a simple, user and environmentally friendly, cheap and suitable method for the determination of ketamine and its main metabolite norketamine in hair samples. The procedure included using a miniaturized procedure-microextraction by packed sorbent with mixed-mode sorbent-for sample clean-up. Organic solvents use was minimal, and it was possible to obtain a linear method (0.05-10 ng/mg for both analytes). The extraction efficiency ranged from 32 to 61%, which did not impair sensitivity. The method proved to be selective, precise, accurate and suitable for routine analysis for the determination of said compounds in 50-mg hair samples.

The Determination of Cannabinoids in Urine Samples Using Microextraction by Packed Sorbent and Gas Chromatography-Mass Spectrometry

Cannabis is the most consumed illicit drug worldwide, and its legal status is a source of concern. This study proposes a rapid procedure for the simultaneous quantification of Δ9-tetrahydrocannabinol (THC), 11-hydroxy-Δ9-tetrahydrocannabinol (11-OH-THC), 11-nor-9-carboxy-Δ9-tetrahydrocannabinol (THC-COOH), cannabidiol (CBD), and cannabinol (CBN) in urine samples. Microextraction by packed sorbent (MEPS) was used to pre-concentrate the analytes, which were detected by gas chromatography–mass spectrometry. The procedure was previously optimized, and the final conditions were: conditioning with 50 µL methanol and 50 µL of water, sample load with two draw–eject cycles, and washing with 310 µL of 0.1% formic acid in water with 5% isopropanol; the elution was made with 35 µL of 0.1% ammonium hydroxide in methanol. This fast extraction procedure allowed quantification in the ranges of 1–400 ng/mL for THC and CBD, 5–400 ng/mL for CBN and 11-OH-THC, and 10–400 ng/mL for THC-COOH with coefficients of determination higher than 0.99. The limits of quantification and detection were between 1 and 10 ng/mL using 0.25 mL of sample. The extraction efficiencies varied between 26 and 85%. This analytical method is the first allowing the for determination of cannabinoids in urine samples using MEPS, a fast, simple, and low-cost alternative to conventional techniques.