Biodegradable gemini surfactants. Correlation of area per surfactant molecule with surfactant structure

Interfacial Adsorption of Oil-Soluble Kraft Lignin and Stabilization of Water-in-Oil Emulsions

In this paper, the potential of esterified Kraft lignin as a novel oil-soluble surfactant was examined. The lignin was chemically modified by esterification with lauric or stearic acid, making it soluble in solvents such as toluene or n-decane. Adsorption at the oil-water interface was then studied by the Du Noüy ring-method. The oil-soluble lignin behaved similar to water-soluble lignin surfactants, both the qualitative and quantitative progression of interfacial tension. Modeling revealed a surface excess of 7.5-9.0 × 10-7 mol/m2, area per molecule of 185-222 Å2, and a diffusion coefficient within the range 10-10 to 10-14 m2/s; all of which are in line with existing literature on water-soluble lignosulfonates. The data further suggested that the pendant alkyl chains were extended well into the paraffinic solvent. At last, bottle tests showed that the oil-soluble lignin was able to stabilize oil-in-water emulsions. The emulsion stability was affected by the concentration of lignin or NaCl as well as the oil phase composition. Aromatic oils exhibited lower emulsion stability in comparison to the aliphatic oil. In conclusion, a new type of surfactant was synthesized and studied, which may contribute to developing green surfactants and novel approaches to valorize technical lignin.

Aqueous solution behaviour and solubilisation properties of octadecyl cationic gemini surfactants and their comparison with their amide gemini analogues

Gemini surfactants 18-s-18(Et), comprised of two ethylammonium headgroups and two alkyl tails with m = 18 carbon atoms with spacers of s = 4, 6, 8 and 10 linking the headgroups (alkanediyl-α,ω-bis(diethyloctadecylammonium bromides)), were obtained. Their aqueous solution behaviour, including adsorption at the interface and aggregation in solution, was followed by tensiometric, conductometric and spectroscopic methods. The critical micelle concentration (CMC) of the surfactants decreased with increasing spacer length. The size of 18-s-18(Et) aggregates formed at concentrations of 10 and 40 CMC measured by DLS varied with the elongation of the spacer. Visualisation of aggregated surfactant structures at 40 CMC by cryo-TEM evidenced the formation of different morphologies depending on spacer length. Gemini with s = 4 formed elongated, cylindrical micelles, while geminis of s = 6, 8 and 10 self-assembled into vesicles. The ability of the studied geminis to solubilise hydrophobic dye Sudan I in water was determined as a function of surfactant concentration, demonstrating their high efficiency. Results for 18-s-18(Et) geminis were compared with those previously obtained for their analogues containing an amide group placed between headgroups and tails. The significant impact of amide groups on the surface activity and aggregation properties of gemini surfactants was evidenced and is related to hydrogen-bond formation by amide-containing compounds.

Synthesis, Physicochemical Characterization, and Interaction with DNA of Long-Alkyl-Chain Gemini Pyridinium Surfactants

Pyridinium gemini surfactants with hexadecyl chains linked to nitrogen atoms and a tuned aliphatic spacer that bridges the two pyridinium polar heads in 2,2'-positions have been synthesized and characterized. A multitechnique approach allowed us to study the aggregation behavior, using conductivity, surface tension, and fluorescence. Graphs of the specific conductivity (κ) versus the surfactant molar concentration (C), and graphs of the molar conductivity (Λ) versus C^0.5 suggest pre-aggregation phenomena of these amphiphiles at very low concentration. The trends of A_min as a function of the spacer length confirm the hypothesis of a conformational change of the molecule with four methylene groups as spacer owing to stacking interactions between the two pyridinium rings mediated by the counterion. Moreover, the trends of A_min and counterion binding (β) suggest that the spacer must be longer than eight carbon atoms to fold efficiently toward the micellar core. The opportunity to tune the surfactant structure and aggregation properties make those surfactants-particularly the long-chain ones for which the DNA complexing ability was shown by means of atomic force microscopy (AFM) imaging-desirable candidates for gene-delivery experiments.

Effect of functional group on the monolayer structures of biodegradable quaternary ammonium surfactants

The monolayer structures and conformational ordering of cationic surfactants including the biodegradable quaternary ammonium molecules have been systematically characterized by π-A isotherm, surface potential, atomic force microscopy (AFM), X-ray photoelectron spectroscopy (XPS), and sum frequency generation (SFG) vibrational spectroscopy. It was found that the monolayer of the typical dialkyl dimethylammonium on the water surface was less densely packed along with many conformational gauche defects. The packing density and ordering of these monolayers were improved as halide ions were added to the subphase. A similar condensation effect was also observed when amide or ester groups are present in the alkyl tails of the surfactant. These results are discussed on the basis of the repulsive electrostatic interactions between the terminal ammonium moieties, the hydrogen bonding between the functional groups in the alkyl chains, as well as the flexibility of the alkyl chains in these surfactants. The present study is crucial to understanding the relationship between the interfacial structures and the functionalities of the biodegradable quaternary ammonium surfactants.

Synthesis and transfection efficiency of cationic oligopeptide lipids: role of linker

In the design of new cationic lipids for gene transfection, the chemistry of linkers is widely investigated from the viewpoint of biodegradation and less from their contribution to the biophysical properties. We synthesized two dodecyl lipids with glutamide as the backbone and two lysines to provide the cationic headgroup. Lipid 1 differs from Lipid 2 by the presence of an amide linkage instead of an ester linkage that characterizes Lipid 2. The transfection efficiency of lipoplexes with cholesterol as colipid was found to be very high with Lipid 1 on Chinese Hamster Ovary (CHO) and HepG2 cell lines, whereas Lipid 2 has shown partial transfection efficiency on HepG2 cells. Lipid 1 was found to be stable in the presence of serum when tested in HepG2 and CHO cells albeit with lower activity. Fluorescence-based dye-binding and agarose gel-based assays indicated that Lipid 1 binds to DNA more efficiently than Lipid 2 at charge ratios of >1:1. The uptake of oligonucleotides with Lipid 1 was higher than Lipid 2 as revealed by confocal microscopy. Transmission electron microscopy (TEM) images reveal distinct formation of liposomes and lipoplexes with Lipid 1 but fragmented and unordered structures with Lipid 2. Fusion of Lipids 1 and 2 with anionic vesicles, with composition similar to plasma membrane, suggests that fusion of Lipid 2 was very rapid and unlike a fusion event, whereas the fusion kinetics of Lipid 1 vesicles was more defined. Differential scanning calorimetry (DSC) revealed a high T(m) for Lipid 1 (65.4 °C) while Lipid 2 had a T(m) of 23.5 °C. Surface area-pressure isotherms of Lipid 1 was less compressible compared to Lipid 2. However, microviscosity measured using 1,6-diphenyl-1,3,5-hexatriene (DPH) revealed identical values for vesicles made with either of the lipids. The presence of amide linker apparently resulted in stable vesicle formation, higher melting temperature, and low compressibility, while retaining the membrane fluid properties suggesting that the intermolecular hydrogen bonds of Lipid 1 yielded stable lipoplexes of high transfection efficiency.

Preparation of microspherical alpha-zirconium phosphate catalysts for conversion of fatty acid methyl esters to monoethanolamides

The performance of solid catalysts and catalyst supports is generally believed to be dependent on their morphology, surface area, and architecture. In order to fully exploit their attractive properties in actual practical applications, layered zirconium phosphate materials should be fabricated into macroscopic form. Here, we report the fabrication of microscopic spheres of alpha-zirconium phosphate (alpha-ZrP) by a spray-drying process. The layered alpha-ZrP nanoparticles were originally obtained using a synthesis route involving separate nucleation and aging steps (SNAS). The resulting products are composed of nanosize alpha-ZrP particles aggregated into solid microspheres with a diameter of 5-45 microm and a sphericity of 0.80. After calcination at 573 K, surface area of 43.8 m(2)/g could be obtained for alpha-ZrP microspheres, which is larger than that of the alpha-ZrP powder after similar thermal treatment (36.2 m(2)/g). Furthermore, the number of acidic sites of the alpha-ZrP microspheres is greater than for the alpha-ZrP powder due to its unique textual properties and higher surface area. The acylation reaction of fatty acid methyl esters (methyl stearate) with ethanolamine to form monoethanolamides was chosen as a probe reaction to evaluate the catalytic activity of the resulting microspherical alpha-ZrP materials, which showed high activity compared to the sample in the form of powders, with about 92.9% methyl stearate conversion at 393 K for 12 h. The enhanced performance in the reaction is determined by the large surface area and the increased number of acidic sites in the multiple-scales porosity of alpha-ZrP microspheres.

Surface-active properties of nitrogen heterocyclic and dialkylamino derivates of hexadecylphosphocholine and cetyltrimethylammonium bromide

The physico-chemical properties of dialkylamino and nitrogen heterocyclic analogues of hexadecylphosphocholine (HPC) and cetyltrimethylammonium bromide (CTAB) were investigated. The surface properties, such as the critical micelle concentration (cmc), the surface tension value at the cmc (gamma(cmc)), and the surface area at the surface saturation per head group (A(cmc)) were determined by means of surface tension measurements. Micelle size was determined using the dynamic light scattering method. The influence of dialkylamino groups and heterocyclic ring size on surface-active properties was investigated. Surface activity and micellar size of prepared analogues of HPC and CTAB were mutually compared.

Role of linker groups between hydrophilic and hydrophobic moieties of cationic surfactants on oligonucleotide-surfactant interactions

The interaction between DNA and amino-acid-based surfactants with different linker groups was investigated by gel electrophoresis, ethidium bromide exclusion assays, circular dichroism, and melting temperature determinations. The studies showed that the strength of the interaction between the oligonucleotides and the surfactants is highly dependent on the linker of the surfactant. For ester surfactants, no significant interaction was observed for surfactant-to-DNA charge ratios up to 12. On the other hand, amide surfactants were shown to interact strongly with the oligonucleotides; these surfactants could displace up to 75% of the ethidium bromide molecules bound to the DNA and induced significant changes in the circular dichroism spectra. When comparing the headgroups of the surfactants, it was observed that surfactants with more hydrophobic headgroups (proline vs alanine) interacted more strongly with the DNA, in good agreement with previous studies.