Air entrainment and granular bubbles generated by a jet of grains entering water

Mechanisms of Air Entraining of Proteins in Cementitious Materials

While few prior studies examined the air-entraining properties of proteins in cementitious materials, the underlying mechanisms of proteins' air entraining and the interactions between proteins and cement have not been studied in the past. The significance of this article is to address this knowledge gap by investigating the effect of proteins on relevant factors that affect air entraining in cement paste and establishing an understanding of the mechanism of air entrainment with proteins. These factors include the surface tension of pore solution, protein adsorption on cement particles, cement paste hydrophobization, and flow of fresh paste. Thirteen different proteins were used to investigate the effect of a wide range of protein characteristics on air entraining. Proteins decreased the pore solution surface tension to different degrees. At low concentrations, the adsorption of proteins on cement particles slightly affected the pore solution surface tension. Protein adsorption on cement particles showed a wide range of adsorption isotherms. Proteins generally increased the flow of paste due to electrostatic repulsion between cement particles because of the adsorption of negatively charged proteins on cement particles, as well as the ball-bearing effect of bubbles in fresh paste. The surface hydrophobicity was increased in pastes with proteins. A detailed microcomputed tomography (micro-CT) analysis showed very different air void microstructures in pastes with various proteins. While a relatively strong correlation was observed between air void porosity and surface hydrophobicity, the correlation between air void porosity and the surface tension of pore solution was weak. This indicates that the accumulation of hydrophobized cement particles on the air bubble in the fresh paste, refered to as the Pickering effect, is the main mechanism of air entraining of proteins in the paste. It was shown that a high air void porosity occurs in an intermediate range of flow.

Singular jets during droplet impact on superhydrophobic surfaces

HYPOTHESIS

The impact of droplets is prevalent in numerous applications, and jetting during droplet impact is a critical process controlling the dispersal and transport of liquid. New jetting dynamics are expected in different conditions of droplet impact on super-hydrophobic surfaces, such as new jetting phenomena, mechanisms, and regimes.

EXPERIMENTS

In this experimental study of droplet impact on super-hydrophobic surfaces, the Weber number and the Ohnesorge number are varied in a wide range, and the impact process is analyzed theoretically.

FINDINGS

We identify a new type of singular jets, i.e., singular jets induced by horizontal inertia (HI singular jets), besides the previously studied singular jets induced by capillary deformation (CD singular jets). For CD singular jets, the formation of the cavity is due to the propagation of capillary waves on the droplet surface; while for HI singular jets, the cavity formation is due to the large horizontal inertia of the toroidal edge during the retraction of the droplet after the maximum spreading. Key steps of the impact process are analyzed quantitatively, including the spreading of the droplet, the formation and the collapse of the spire, the formation and retraction of the cavity, and finally the formation of singular jets. A regime map for the formation of singular jets is obtained, and scaling relationships for the transition conditions between different regimes are analyzed.

Induced Circulation by Plunging and Submerged Jets in Circular Water Storage Tanks Using CFD

Water circulation in storage tanks significantly impacts water quality in distribution networks since old water tends to have low residual chlorine concentrations that are insufficient to neutralize microbial regeneration. Their large capacity and long residence times result in uneven mixing, which can accelerate the disinfectant decay and the formation of potentially carcinogenic disinfection by-products. The phenomenon is strongly related to the tank inflow conditions, since there are no active mixing devices. This paper presents a comprehensive analysis of the flow dynamics in circular storage tanks using a three-dimensional computational fluid dynamics model. The main motivation is that the inflow—which mixing processes rely on—strongly influences the circulations. The numerical analysis provided includes a thorough investigation of interest in understanding flow dynamics for two inflow configurations: (i) the plunging jet modelling and comparison with published experimental data and (ii) the submerged jet as an improvement measurement for these storage tanks.