1
|
Gan LP, Li J, Shi F, Zou Z, Li KJ, Shi ZZ, Wu XS, Li YP, Sun W, Lu ZS, Hu T, Dai L, Li CM. Co 4+ in porous ZIF-67-derives intercalating-bridging adsorption of 2-reaction sites for simultaneous 2-electron transfer toward sensitive detection of uric acid. Anal Chim Acta 2024; 1308:342614. [PMID: 38740455 DOI: 10.1016/j.aca.2024.342614] [Citation(s) in RCA: 0] [Impact Index Per Article: 0] [Reference Citation Analysis] [Abstract] [Key Words] [Track Full Text] [Journal Information] [Subscribe] [Scholar Register] [Received: 12/26/2023] [Revised: 03/11/2024] [Accepted: 04/13/2024] [Indexed: 05/16/2024]
Abstract
Metal-organic frameworks (MOFs) have been used to detect uric acid (UA), but still very challenging to achieve a low detection limit due to the low inferior conductivity of MOFs. Herein, three different N-doped ZIF-67-derived carbons were synthesized for the first time by one-step co-pyrolysis of 2-methylimidazole with cobalt nitrate (CN), cobalt acetate (CA) or cobalt chloride (CC) toward UA sensing. Afterwards, the cobalt nitrate-derived Co particle (Co/CN) supported by N-doped ZIF-67-derived carbon displays extremely low detection limit and high sensitivity for UA, outperformed all reported MOFs-based UA sensors. More interestingly, it was discovered that the high valence Co4+ within the Co/CN sample produced in high-acidic environment can intercalate in the frame for a bridge adsorption between two reaction sites, which boosted simultaneous 2-electron transfer, while Co3+ only allows an end-adsorption structure for one-electron transfer being the rate determining step. Furthermore, the bridge adsorption mode of UA on Co4+ -based catalyst was also verified by theoretical DFT calculations and XPS experiment. This work holds great promise for a selective and sensitive UA sensor for practical bioscience and clinic diagnostic applications while shedding lights in fundamental research for innovative designs and developments of high-sensitive electrochemical sensors.
Collapse
Affiliation(s)
- Li Peng Gan
- Key Laboratory of Luminescence Analysis and Molecular Sensing (Southwest University), Ministry of Education, China; Institute for Clean Energy and Advanced Materials, School of Materials & Energy, Southwest University, China; Chongqing Key Laboratory for Advanced Materials and Technologies of Clean Energies, Chongqing, 400715, China; Institute of Materials Science & Devices, School of Materials Science and Engineering, Suzhou University of Science and Technology, Suzhou, 215009, China
| | - Juan Li
- Key Laboratory of Luminescence Analysis and Molecular Sensing (Southwest University), Ministry of Education, China; Institute for Clean Energy and Advanced Materials, School of Materials & Energy, Southwest University, China; Chongqing Key Laboratory for Advanced Materials and Technologies of Clean Energies, Chongqing, 400715, China; Institute of Materials Science & Devices, School of Materials Science and Engineering, Suzhou University of Science and Technology, Suzhou, 215009, China
| | - Fan Shi
- Institute of Materials Science & Devices, School of Materials Science and Engineering, Suzhou University of Science and Technology, Suzhou, 215009, China
| | - Zhuo Zou
- Institute of Materials Science & Devices, School of Materials Science and Engineering, Suzhou University of Science and Technology, Suzhou, 215009, China; Australian Carbon Materials Centre (A-CMC), School of Chemical Engineering, University of New South Wales, Sydney, NSW, 2052, Australia
| | - Ke Jiang Li
- Key Laboratory of Luminescence Analysis and Molecular Sensing (Southwest University), Ministry of Education, China; Institute for Clean Energy and Advanced Materials, School of Materials & Energy, Southwest University, China; Chongqing Key Laboratory for Advanced Materials and Technologies of Clean Energies, Chongqing, 400715, China
| | - Zhuan Zhuan Shi
- Institute of Materials Science & Devices, School of Materials Science and Engineering, Suzhou University of Science and Technology, Suzhou, 215009, China
| | - Xiao Shuai Wu
- Institute of Materials Science & Devices, School of Materials Science and Engineering, Suzhou University of Science and Technology, Suzhou, 215009, China
| | - Yun Peng Li
- Institute of Materials Science & Devices, School of Materials Science and Engineering, Suzhou University of Science and Technology, Suzhou, 215009, China
| | - Wei Sun
- College of Chemistry and Chemical Engineering, Hainan Normal University, Haikou, 571158, China
| | - Zhi Song Lu
- Key Laboratory of Luminescence Analysis and Molecular Sensing (Southwest University), Ministry of Education, China; Institute for Clean Energy and Advanced Materials, School of Materials & Energy, Southwest University, China; Chongqing Key Laboratory for Advanced Materials and Technologies of Clean Energies, Chongqing, 400715, China.
| | - Tao Hu
- Institute of Materials Science & Devices, School of Materials Science and Engineering, Suzhou University of Science and Technology, Suzhou, 215009, China.
| | - Liming Dai
- Australian Carbon Materials Centre (A-CMC), School of Chemical Engineering, University of New South Wales, Sydney, NSW, 2052, Australia.
| | - Chang Ming Li
- Institute of Materials Science & Devices, School of Materials Science and Engineering, Suzhou University of Science and Technology, Suzhou, 215009, China.
| |
Collapse
|
2
|
Lepre E, Rat S, Cavedon C, Seeberger PH, Pieber B, Antonietti M, López-Salas N. Catalytic Properties of High Nitrogen Content Carbonaceous Materials. Angew Chem Int Ed Engl 2023; 62:e202211663. [PMID: 36303469 PMCID: PMC10107103 DOI: 10.1002/anie.202211663] [Citation(s) in RCA: 0] [Impact Index Per Article: 0] [Reference Citation Analysis] [Abstract] [Key Words] [Track Full Text] [Journal Information] [Subscribe] [Scholar Register] [Received: 08/08/2022] [Indexed: 11/07/2022]
Abstract
The influence of structural modifications on the catalytic activity of carbon materials is poorly understood. A collection of carbonaceous materials with different pore networks and high nitrogen content was characterized and used to catalyze four reactions to deduce structure-activity relationships. The CO2 cycloaddition and Knoevenagel reaction depend on Lewis basic sites (electron-rich nitrogen species). The absence of large conjugated carbon domains resulting from the introduction of large amounts of nitrogen in the carbon network is responsible for poor redox activity, as observed through the catalytic reduction of nitrobenzene with hydrazine and the catalytic oxidation of 3,3',5,5'-tetramethylbenzidine using hydroperoxide. The material with the highest activity towards Lewis acid catalysis (in the hydrolysis of (dimethoxymethyl)benzene to benzaldehyde) is the most effective for small molecule activation and presents the highest concentration of electron-poor nitrogen species.
Collapse
Affiliation(s)
- Enrico Lepre
- Department of Colloid Chemistry, Max Planck Institute of Colloids and Interfaces, Potsdam Science Park, Am Mühlenberg 1, 14476, Potsdam, Germany
| | - Sylvain Rat
- Department of Colloid Chemistry, Max Planck Institute of Colloids and Interfaces, Potsdam Science Park, Am Mühlenberg 1, 14476, Potsdam, Germany
| | - Cristian Cavedon
- Department of Biomolecular Systems, Max Planck Institute of Colloids and Interfaces, Potsdam Science Park, Am Mühlenberg 1, 14476, Potsdam, Germany
| | - Peter H Seeberger
- Department of Biomolecular Systems, Max Planck Institute of Colloids and Interfaces, Potsdam Science Park, Am Mühlenberg 1, 14476, Potsdam, Germany
| | - Bartholomäus Pieber
- Department of Biomolecular Systems, Max Planck Institute of Colloids and Interfaces, Potsdam Science Park, Am Mühlenberg 1, 14476, Potsdam, Germany
| | - Markus Antonietti
- Department of Colloid Chemistry, Max Planck Institute of Colloids and Interfaces, Potsdam Science Park, Am Mühlenberg 1, 14476, Potsdam, Germany
| | - Nieves López-Salas
- Department of Colloid Chemistry, Max Planck Institute of Colloids and Interfaces, Potsdam Science Park, Am Mühlenberg 1, 14476, Potsdam, Germany
| |
Collapse
|
3
|
Du S, Leistenschneider D, Xiao J, Dellith J, Troschke E, Oschatz M. Application of Thermal Response Measurements to Investigate Enhanced Water Adsorption Kinetics in Ball-Milled C 2 N-Type Materials. Chemistry 2022; 11:e202200193. [PMID: 36511511 PMCID: PMC9746058 DOI: 10.1002/open.202200193] [Citation(s) in RCA: 0] [Impact Index Per Article: 0] [Reference Citation Analysis] [Abstract] [Key Words] [Track Full Text] [Figures] [Journal Information] [Subscribe] [Scholar Register] [Received: 08/31/2022] [Revised: 11/14/2022] [Indexed: 12/15/2022]
Abstract
Sorption-based water capture is an attractive solution to provide potable water in arid regions. Heteroatom-decorated microporous carbons with hydrophilic character are promising candidates for water adsorption at low humidity, but the strong affinity between the polar carbon pore walls and water molecules can hinder the water transport within the narrow pore system. To reduce the limitations of mass transfer, C2 N-type carbon materials obtained from the thermal condensation of a molecular hexaazatriphenylene-hexacarbonitrile (HAT-CN) precursor were treated mechanochemically via ball milling. Scanning electron microscopy as well as static light scattering reveal that large pristine C2 N-type particles were split up to a smaller size after ball milling, thus increasing the pore accessibility which consequently leads to faster occupation of the water vapor adsorption sites. The major aim of this work is to demonstrate the applicability of thermal response measurements to track these enhanced kinetics of water adsorption. The adsorption rate constant of a C2 N material condensed at 700 °C remarkably increased from 0.026 s-1 to 0.036 s-1 upon ball milling, while maintaining remarkably high water vapor capacity. This work confirms the advantages of small particle sizes in ultramicroporous materials on their vapor adsorption kinetics. It is demonstrated that thermal response measurements are a valuable and time-saving method to investigate water adsorption kinetics, capacities, and cycling stability.
Collapse
Affiliation(s)
- Shengjun Du
- Institute for Technical Chemistry and Environmental ChemistryCenter for Energy and Environmental Chemistry Jena (CEEC Jena)Friedrich-Schiller-University JenaPhilosophenweg 7a07743JenaGermany,School of Chemistry and Chemical EngineeringSouth China University of TechnologyGuangzhou510641China
| | - Desirée Leistenschneider
- Institute for Technical Chemistry and Environmental ChemistryCenter for Energy and Environmental Chemistry Jena (CEEC Jena)Friedrich-Schiller-University JenaPhilosophenweg 7a07743JenaGermany
| | - Jing Xiao
- School of Chemistry and Chemical EngineeringSouth China University of TechnologyGuangzhou510641China
| | - Jan Dellith
- Department Competence Center for Micro- and NanotechnologiesLeibniz Institute of Photonic TechnologyAlbert-Einstein-Straße 907745JenaGermany
| | - Erik Troschke
- Institute for Technical Chemistry and Environmental ChemistryCenter for Energy and Environmental Chemistry Jena (CEEC Jena)Friedrich-Schiller-University JenaPhilosophenweg 7a07743JenaGermany
| | - Martin Oschatz
- Institute for Technical Chemistry and Environmental ChemistryCenter for Energy and Environmental Chemistry Jena (CEEC Jena)Friedrich-Schiller-University JenaPhilosophenweg 7a07743JenaGermany
| |
Collapse
|
4
|
López-Salas N, Antonietti M. Carbonaceous Materials: The Beauty of Simplicity. BULLETIN OF THE CHEMICAL SOCIETY OF JAPAN 2021. [DOI: 10.1246/bcsj.20210264] [Citation(s) in RCA: 10] [Impact Index Per Article: 3.3] [Reference Citation Analysis] [Track Full Text] [Subscribe] [Scholar Register] [Indexed: 11/13/2022]
Affiliation(s)
- Nieves López-Salas
- Colloids Chemistry Department, Max Planck Institute of Colloids and Interfaces, Am Mühlenberg 1, 14476, Potsdam, Germany
| | - Markus Antonietti
- Colloids Chemistry Department, Max Planck Institute of Colloids and Interfaces, Am Mühlenberg 1, 14476, Potsdam, Germany
| |
Collapse
|