Long-term leaching through clayey till of N,N-dimethylsulfamide, a Persistent and Mobile Organic Compound (PMOC)

Leaching of unexpected cyazofamid degradation products into groundwater demonstrates gaps in current pesticide risk assessment

To investigate the formation and leaching potential of degradation products N,N-dimethylsulfamide (DMS) and dimethylsulfamic acid (DMSA) from cyazofamid under real-world agricultural conditions, the fungicide cyazofamid was applied in a potato crop as part of the Danish Pesticide Leaching Assessment Programme (PLAP). Leaching of DMS, DMSA, 4-chloro-5-(4-methylphenyl)-1H-imidazole-2-carbonitrile (CCIM), and 4-chloro-5-(4-methylphenyl)-1H-imidazole-2-carboxylicacid (CTCA) was monitored in water from the variably saturated zone (suction cups) and groundwater for more than two years following the applications. In total, 424 samples were analyzed for the content of the four degradation products. An additional laboratory study was executed in parallel with the field monitoring study. Here, cyazofamid was applied to soil columns and leaching of the four degradation products was studied under controlled conditions. In the EFSA conclusion on cyazofamid, CCIM and CTCA are mentioned as major relevant metabolites; DMS is not mentioned in the risk assessment and DMSA is only included in acute oral toxicity studies and an in vitro bacterial mutation assay. In contrast to the EFSA conclusion on cyazofamid, our studies showed no leaching of the two major metabolites, CTCA and CCIM, but instead, major leaching of DMS and DMSA in both the field and laboratory studies was observed. That is, both DMS and DMSA leached to the groundwater in concentrations >0.1 μg/L for more than half a year. Based on this, we suggest improvements to the current pesticide risk assessment.

Quantification of contaminant mass discharge from point sources in aquitard/aquifer systems based on vertical concentration profiles and 3D modeling

Point sources with contaminants, such as chlorinated solvents, per- and polyfluoroalkyl substances (PFAS), or pesticides, are often located in low-permeability aquitards, where they can act as long-term sources and threaten underlying groundwater resources. We demonstrate the use of a 3D numerical model integrating comprehensive hydrogeological and contamination data to determine the contaminant mass discharge (CMD) from an aquitard into the underlying aquifer. A mature point source with a dissolved chlorinated solvent in a clayey till is used as an example. The quantitative determination is facilitated by model calibration to high-resolution vertical concentration profiles obtained by direct-push sampling techniques in the aquifer downgradient of the contaminant source zone. The concentration profiles showed a plume sinking with distance from the source characteristic for such aquitard/aquifer settings. The sinking is caused by the interplay between infiltrating water and horizontal groundwater flow. The application of 3D solute transport modeling on high-resolution profiles allowed for determining the infiltration rate, the hydraulic conductivity in the aquitard, and, ultimately, the CMD. Different source zone conceptualizations demonstrate the potential effects of fractures and sorption in source zones in aquitards on CMD development. Fractures in the aquitard had a minor influence on the current CMD determined with the presented approach. Still, fractures with hydraulic apertures larger than 10 μm were crucial for the temporal development of the CMD and plume. A thorough characterization of the source zone conditions combined with high-resolution concentration profiles and detailed modeling is valuable for shedding light on the probable future development of groundwater contamination arising from sources in aquitard/aquifer settings and evaluating remedial actions.

Predicting the impact and duration of persistent and mobile organic compounds in groundwater systems using a contaminant mass discharge approach

This study investigated methods for predicting the duration and impact on groundwater quality from persistent and mobile organic compounds (PMOCs) at a drinking water well field affected by multiple contaminant sources. The fungicide metabolite N,N-dimethylsulfamide (DMS), which frequently occurs above the Danish groundwater quality criterion (0.1 μg/L), was used as an example. By combining contaminant mass discharge (CMD) estimations, modeling, and groundwater dating, a number of important discoveries were made. The current center of contaminant mass was located near the source area. The CMD at the well field was predicted to peak in 2040, and an effect from the investigated sources on groundwater quality could be expected until the end of the 21st century. A discrepancy in the current CMD at the well field and the estimated arrival time from the studied source area suggested an additional pesticide source, which has not yet been thoroughly investigated. The presence of the unknown source was supported by model simulations, producing an improved mass balance after inclusion of a contaminant source closer to the well field. The approach applied here was capable of predicting the duration and impact of DMS contamination at a well field at catchment scale. It furthermore shows potential for identification and quantification of the contribution from individual sources, and is also applicable for other PMOCs. Predicting the duration of the release and impact of contaminant sources on abstraction wells is highly valuable for water resources management and authorities responsible for contaminant risk assessment, remediation, and long-term planning at water utilities.